Page 2 - Contents
2 Contents ˆ Contents Important Information .................................................................................................................................................. 4 Introduction .................................................................................................
Page 4 - Important Information; READ THIS BEFORE INSTALLATION
4 Important Information ˆ Important Information READ THIS BEFORE INSTALLATION Your phone is ETL listed to UL standards and meets all applicable FCC standards. We have designed your telephone to conform to federal regulations, and you can connect it to most telephone lines. However, each device that ...
Page 5 - Introduction; Cordless Handset
5 Introduction ˆ Introduction Your RadioShack ET-3507 900 MHz Dual Handset Phone offers the latest advances in cordless phone technology. The corded base and cordless handset operate through one phone jack. It saves up to 35 Caller ID records that you can review and call back using the corded base o...
Page 6 - Preparation; CHOOSING A LOCATION; On a Desk
6 Preparation ˆ Preparation CHOOSING A LOCATION The corded phone and cordless handset (with charging cradle) require only one phone jack for both phones. You can place the cordless handset and the charging cradle anywhere in your house, such as the kitchen, workshop or garage, without using a separa...
Page 7 - Connecting the Corded Handset
7 Preparation 7. Press and lift out the handset holder, turn it upside down so its tabbed edge faces up, then slide it back down into its slot. Note: To mount the phone directly on a wall, you need two screws (not supplied) with heads that fit into the keyhole slots on the bracket. Follow the steps ...
Page 8 - SETTING UP THE CORDED PHONE; Setting the Dialing Mode; Adjusting the Display Contrast
8 Preparation To charge the battery pack, place the handset in the charging cradle. The CHARGE indicator lights. Notes: • The CHARGE indicator lights even if the battery pack’s connector is not plugged into the compartment. Be sure the battery pack is properly connected before charging. • Recharge t...
Page 9 - STORING YOUR AREA CODE; Corded Phone; USING THE DATA PORT; Using a Headset
9 Preparation 2. Press ; ; ; ; to darken the display, or : : : : to lighten the display. Note: The phone sounds 3 beeps when you reach the lowest or highest contrast level. 3. Press FUNCTION to save the new setting and enter the area code setting mode. 7H;7 7H;7 7H;7 7H;7 9E:; 9E:; 9E:; 9E:; 3333 ##...
Page 10 - SETTING THE RINGERS
10 Preparation SETTING THE RINGERS To have the phone ring when a call comes in, set RINGER to ON . To turn the ringer off, set RINGER to OFF . With RINGER set to OFF , you can still make outgoing calls. If you hear an extension telephone ring, you can answer the incoming call on this phone. The NEW ...
Page 11 - Operation; A QUICK LOOK AT YOUR PHONE
11 Operation ˆ Operation A QUICK LOOK AT YOUR PHONE REDIAL — To quickly redial the last number dialed, pick up the corded handset or press SPEAKER , then press REDIAL . To redial a busy number, press REDIAL without hanging up the phone. <B7I> <B7I> <B7I> <B7I> appears and a d...
Page 12 - MAKING AND ANSWERING A CALL; ADJUSTING THE VOLUME
12 Operation MAKING AND ANSWERING A CALL Corded Phone To make a call using the corded phone, pick up the corded handset or press SPEAKER to use the speakerphone. You hear a dial tone and ;DJ;H ;DJ;H ;DJ;H ;DJ;H DKC8;H DKC8;H DKC8;H DKC8;H 5555 appears (if you are using speakerphone, the red SPEAKER ...
Page 13 - TRANSFERRING A CALL
13 Operation To send an intercom signal from the cordless handset to the corded phone, press INTCM on the cordless handset. ?DJ;H9EC ?DJ;H9EC ?DJ;H9EC ?DJ;H9EC appears on both the corded phone’s and the cordless handset’s displays. The corded phone beeps for about 15 seconds. Press PAGE/INTERCOM on ...
Page 14 - Memory Operation; STORING A NUMBER; Entering a Pause; DIALING A NUMBER
14 Memory Operation ˆ Memory Operation You can store up to 10 numbers (up to 24 digits) in each phone’s memory. Notes: • To keep your accounts secure, we recommend you do not store your personal access code for services such as bank-by-phone in a memory location. • When storing numbers for special s...
Page 15 - REVIEWING STORED NUMBERS; DELETING A STORED NUMBER
15 Memory Operation then CALL BACK . The speaker turns on and dials the desired number. Cordless Handset 1. Press TALK on the cordless handset and wait for a dial tone. 2. Press MEM . C;CE C;CE C;CE C;CE # ## ## ## ## appears. 3. Enter the memory location number ( 1 – 0 ). The memory location number...
Page 16 - Caller ID Operation; CALL WAITING
16 Caller ID Operation ˆ Caller ID Operation If you subscribe to Caller ID service from your phone company, the system automatically displays information about calls you receive and stores the information in Caller ID memory. Each phone can store up to 35 number records (the most recent is 35), repl...
Page 17 - DELETING RECORDS; Reviewing VIP Records
17 Caller ID Operation • Empty Caller ID memory locations do not appear. • When a repeat call is received, the old record will be removed from the Caller ID List and H;FJ H;FJ H;FJ H;FJ appears. • When the list is full, the oldest caller’s information is replaced by the newest one. DELETING RECORDS ...
Page 18 - Troubleshooting; CARE
18 Troubleshooting ˆ Troubleshooting We do not expect you have any problems with your telephone, but if you do, the following suggestions might help. If you still have problems, check the other phones on the same line to see if they work properly. If they do, and the problem does not seem to be with...
Page 19 - THE FCC WANTS YOU TO KNOW; LIGHTNING
19 Troubleshooting THE FCC WANTS YOU TO KNOW In the unlikely event that your phone causes problems on the phone line, the phone company can temporarily discontinue your service. If this happens, the phone company attempts to notify you in advance. If advance notice is not practical, the phone compan...
