RadioShack ET-007 - Manual

6 INSTALLATION SELECTING A LOCATION You can place the ET-007 on a desk ortable, mount it on a standard wall plate,or mount it directly on a wall. Choose alocation that is: • near an AC outlet • near a modular telephone line jack • out of the way of normal activities Note: Your ET-007 connects direct...

10 PREPARATION Follow the steps in “Connecting theHeadset Charger, Wireless Headset andInfrared Remote Dial Card” on Page 7 toinstall the battery in the headset. CHARGING THE BATTERY PACK After you install a battery pack, let thebattery charge for about 24 hours beforeyou use the headset the first t...

13 Listening Safely To protect your hearing, follow theseguidelines when you use the headset. • Set the volume to the lowest setting before you begin listening. After youbegin listening, adjust the volume toa comfortable level. • Do not listen at extremely high vol- ume levels. Extended high volumel...

14 OPERATION MAKING AND ANSWERING CALLS Using the Handset To make a call, pick up the handset anddial normally. The IN USE indicatorflashes when you receive a call andlights while the phone is in use. Pick up the handset to answer a call andplace the handset on the base to end acall. Note: The corde...

15 To switch from the headset to the hand-set, press HOLD on the infrared remote dial card. The IN USE/BATT. LOW indi-cator flashes. Pick up the handset to an-swer the call. The headset sounds atone if the handset is not picked up with-in about 30 seconds. Using the Intercom To use the intercom to s...

16 USING REDIAL You can quickly dial the last number di-aled. When you heard a dial tone, press REDIAL on the corded phone, or on the infrared remote dial card if you want touse the headset for dialing. Note: The base corded phone and theheadset record their own last number di-aled. You cannot redia...

17 USING HOLD To put a caller on hold, press HOLD . The HOLD indicator on the corded phoneflashes and you can hang up the hand-set without disconnecting the call. Or, ifyou are using the headset, press HOLD on the infrared remote dial card. To resume the call, lift the handset, pulldown on the micro...

18 3. Enter the number you want to store (up to 20 digits can be stored),including any pause or tone entries(see “Entering a Pause in a MemoryNumber” on Page 18 or “Using ToneService on a Pulse Line” onPage 17). 4. Press MEMORY on the base. The phone rings to indicate that thenumber is stored succes...

19 Chain-Dialing For quick recall of numbers for specialservices (such as bank-by-phone or al-ternate long-distance), you can storeeach group of numbers in its own mem-ory location. Then, when calling specialservices, dial the service's main numberfirst. At the appropriate place in the call,press th...

20 TROUBLESHOOTING We do not expect you to have any problems with your phone, but if you do, the follow-ing suggestions might help. If you still have problems, take the phone to your localRadioShack store for assistance. Problem Suggestion Interference is severe. Move the wireless headset closer to ...

22 CARE To enjoy your RadioShack ET-007 900MHz Handsfree Cordless Headset Sys-tem for a long time: • Keep the ET-007 dry. If it gets wet, wipe it dry immediately. • Use and store the ET-007 only in normal temperature environments. • Handle the ET-007 gently and care- fully. Do not drop it. • Keep th...

23 NOTES 43-007.fm Page 23 Wednesday, March 22, 2000 11:24 AM