RadioShack 49-1001 - Manual

sensor

magnet

screws (2)

wall anchors (2)

what’s included

1. Use a screwdriver to loosen the screw and

remove the front of the sensor.

2. Insert two AAA batteries (not supplied).
3. After you replace the batteries, place the

magnet next to the sensor then move it
away. If the system does not chime, you
must register the sensor again. To register
the sensor, follow steps 1 thru 6 on page 1.

If the sensor stops working properly, or

PROBLEM

appears on your console’s display, replace the
sensor’s batteries.

• Dispose of old batteries promptly and properly.

Do not burn or bury them.

• Use only fresh batteries of the required size and

recommended type.

• Do not mix old and new batteries, different

types of batteries, or batteries of different

capacities.

initializing your sensor

49-1001

Wireless Security

Door/Window Sensor

This wireless door/window sensor only works

with your Wireless Security Kit (49-1000). Your

Wireless Security Kit includes two sensors.

Purchase up to 28 additional (30 total) sensors

to expand and protect all 30 system zones.

You can add additional door/window sensors

and additional motion detectors, as long as the

additional units do not exceed 30 (number of

zones in your system). Refer to your 49-1000

user guide for more information on adding

motion detectors and door/window sensors to

your wireless system.

The sensor jack allows you to hardwire an

extra magnetic switch for additional door/

window protection.The sensor must be within

100 feet of the console to operate properly.

1. Press and hold down

TEST

on the sensor for

3-4 seconds, and then release it. The green
LED blinks twice.

Note: If you need to register the sensor a
second time, remove the batteries, and then
hold down

TEST

for 3-4 seconds to pick up a

random code.

2. Replace the cover.
3. Place the magnet next to the sensor, with

their arrows aligned.

4. Press

menu start

or on your system

console.

ENTER PIN

(Personal Identification

Number) appears on the display.

5. Use the console keypad to enter your four-

digit PIN. * appears on the display as you
press each digit. After you enter your PIN

,

1. INSTALL

appears.

6. Press

ok

and

1. INSTALL / ZONE

appears.

7. Move the magnet away from the sensor. The

console chimes and

ZONE 1 SET

appears on

the display to confirm registration.

8. Press

clear

to navigate backwards through

the console menu options. Press

1

to return

to the main display, press

2

to stay in install

mode and register additional sensors.

registering your sensor

TEST





DELAY MIN/MAX

wall anchors (2)

screws (2)

magnet

sensor









Please read this user’s guide before

installing, setting up and using your new product

www.radioshack.com