Q-See AND QSD2308/16 DVRS - Manual

Page 3 - To access the DVR through Internet Explorer.; Pic 1 Pic 2; Page 1

R R E E M M O O T T E E M M O O N N I I T T O O R R I I N N G G G G U U I I D D E E F F O O R R Q Q T T 5 5 , , Q Q S S D D T T , , A A N N D D Q Q S S D D 2 2 3 3 0 0 8 8 / / 1 1 6 6 D D V V R R S S Accessing the DVR from a computer attached to the same router: If you are only going to access the D...

Page 4 - Pic 3 Pic 4; Page 2

Pic 3 Pic 4 For the DVRs IP address you would enter the same first 3 sets of numbers as the gateway and select a fourth set of numbers that is different than any other device attached to the same router. If the IP address of your computer in the ipconfig (BLUE arrow in Pic 3) was a single or two dig...

Page 5 - Page 3

Pic 5 PORT FORWARDING To access the DVR from a remote computer you need to forward ports 80 and 2000 from the router the DVR is attached to, to the IP address of the DVR. 1. Connect your DVR to the Router and power on DVR 2. Configure your DVR and Set up port forwarding on your router a. Go to

Page 6 - Select the make and model of your router from the list

c. Select the make and model of your router from the list d. Click on the ‘Click here to skip this advertisement…’ link in the upper right corner of the screen. Notice: When you go to the

Page 7 - Page 5

f. Verify the ports are open and traffic is allowed a. Go to

Page 8 - Connection refused”.; If you get this error, call your; Page 6

ii. Go to the section below: To access the DVR through Internet Explorer iii. Otherwise, if the ports are not open, you will get the following message: “ Error: I could not see your service on 64.206.234.34 on port (80) - Reason: Connection refused”. If you get this error, call your Internet Service...

Page 9 - Pic 9; Page 7

To access the DVR through Internet Explorer: once you have setup the network settings on the DVR to match the settings of your router and forwarded the ports needed by the DVR (for remote access over the internet), you need to modify your browser controls. You need to allow Pop-ups. To do so go to t...

Page 10 - Pic 14 Pic 15; Page 8

Click on Custom Level Pic 12 On “Reset to” pull down menu, select “LOW” then click on “RESET” button. Click ‘Yes’ when asked: ‘Are you sure you want to change the setting for this zone?’ Click OK. Click Apply. Click OK. Close Internet Explorer. Pic 13 If you get a error message that says the program...

Page 11 - Notice; : If you still have problems connecting remotely:; Anti-virus programs could also

To connect to the DVR from the remote computer you would then open an Internet Explorer browser window and enter the internet IP of your router that you got by going to

Page 12 - Remote Viewing Window; Pic 14; Picture snapshot

Remote Viewing Window When you connect you will see the remote viewing window shown below: Pic 14 ① Full screen, 1/4/8 screen display mode. ② Camera indicators: ③ Picture snapshot ④ Remote viewing: adjust the color of cameras and control PTZ. ⑤ Remote playback and backup: remotely playback and backu...

Page 13 - Click on the New User? Link at the bottom of your pagec.

M M Y Y Q Q - - S S E E E E D D D D N N S S S S E E T T U U P P G G U U I I D D E E F F O O R R Q Q T T 5 5 , , Q Q S S D D T T , , A A N N D D Q Q S S D D 2 2 3 3 0 0 8 8 / / 1 1 6 6 D D V V R R S S Dynamic Domain Name Service (DDNS) provides the capability for a networked device using the Internet...

Page 16 - Accessing From iPhones; Enter into App Store function of iPhone

I I P P H H O O N N E E A A C C C C E E S S S S S S E E T T U U P P G G U U I I D D E E F F O O R R Q Q T T 5 5 , , Q Q S S D D T T , , A A N N D D Q Q S S D D 2 2 3 3 0 0 8 8 / / 1 1 6 6 D D V V R R S S Accessing From iPhones At present, the software only supports versions of iPhone OS 2.2 and abov...

Page 17 - to capture picture.

Step 4: Enter your iTunes Store password, click “OK” will display below interface Note: the first time you operate please enter your user ID; if you do not have a Store account, you need to setup one. Step 5: Download and install. After installed, SuperCam icon will display. Click this icon, a funct...

Page 19 - Pic 4 Pic 5; Next Picture; Delete

Image View Pic 4 Pic 5 Item Button Function Item Button Function 1 Previous picture 2 Next Picture 3 The first Picture 4 The last picture 5 Delete 6 Search Pictures, search page as Pic 5 Page 17

Page 22 - If you have questions:; Mailing Address: Customer Service:

If you have questions: Contact Us: Mailing Address: Customer Service: DPS Inc. Phone: 877-998-3440 x 538 8015 E. Crystal Dr Email: [email protected] Anaheim, CA 92807 Live Chat Link on our website Website: Tech Support:

Q-See AND QSD2308/16 DVRS - Manual

Table of Contents:

Summary

Other Q-See Models