Pyle PLCDCS300 - Manual

5 OPERATION 28 27 29 5 9 12 26 25 3 2 15 7 17 16 13 8 6 10 11 4 1 18 19 20 21 30 22 23 24 14

6 GENERAL OPERATION Note: In this product design, there has different sound accompanying with everybutton pressed and the sound isdesigned differently according to thecustomers. • ON/OFF Switch on the unit by pressing POWER button (9). When system is on, press POWER button (9) again to turn off the ...

7 Stations are searched automaticallyfrom next frequency and detected station is stored into the preset memory. In case of LOC state, the first Auto Store is done by LOC stateand if 6 CH is not fully memorized, the seconds Auto Store search continued by Distant state. At the end of Auto Store operat...

8 OPERATION CASSETTE OPERATION • TAPE OPEN/CLOSE Press TAPE OPEN/CLOSE button (26), the front panel will slide down to show the cassette compartment (28).Press TAPE OPEN/CLOSE button (26) again or POWER button (9) to slide up the front panel. • PROGRAM BUTTON These two buttons (27) perform the dual ...

9 • REPEAT THE SAME TRACK Press RPT button (21) to continuously repeat the same track. Press it again to stop repeat. • PREVIEW ALL TRACKS Press SCN button (20) to play first several seconds of each track on the current disc.Press it again to stop intro and listen to track. • PLAY ALL TRACKS Press R...

10 FUNCTION KEYS & CONTROL 1. PWR = Power Button 2. MUT = Mute Button 3. SEL = Select Button 4. VOL = Volume Up Button 5. VOL = Volume Down Button 6. BND = Band Select Button 7. MOD = Mode Button 8. TUNE/SEEK = Tune/Seek Down Button 9. TUNE/SEEK = Tune/Seek Up Button 10. EQ = Preset Equalization...

11 GENERAL P ower Supply Requirements : DC 12 Volts, Negative Ground Chassis Dimensions : 200 mm (W) x 138 mm (D) x 100 mm (H) Loading Impedance : 4 - 8 Ω per channel Maximum Output P ower : 4 x 50 Watts Current Drain : 10 Ampere (max.) CD PLA YER Signal to Noise Ratio : More than 55 dB Channel Sepa...

12 Before going through the check list, check wiring connection. If any of the problemspersist after check list has been made, consult your nearest service dealer. Symptom Cause Solution No power. The car ignition switch is If the power supply is properly not on. connected to the car accessorycircui...

MAINTENANCE For System The following suggestions help you carefor the product so that you can enjoy itfor years. 1. Keep the product dry. If it does get wet, wipe it dry immediately.Liquids might contain minerals that can corrode the electronic circuits. 2. Keep the product away from dust and dirt, ...

CAUTION 1. This unit is designed to operate on 12-volts DC, negative ground electrical system only. Do not attemptto install this unit in a vehicle having apositive ground system. 2. You should not touch the high-polished playback head with anymetallic or magnetic tools. 3. Your unit has built-in fi...