Pyle PLCD22MRP - Manual

5 OPERATION When pull open the disc cover: 12 7 10 18 23 21 22 11 9 1 13 3 25 19 24 14 20 6 15 16 8 2 4 17 5 26

6 OPERATION CONTROL & FUNCTIONS KEYS This unit is a marine rated wired remote control made using a modified controller orsimilar layout. It is capable of operation specified functions on the marine AM/FM/CDreceiver and the marine AM/FM/Cassette receiver. The body, buttons, controls anddisplay ne...

8 OPERATION 1. First insert the hooks on the base into the slots of the holder to install the base to the holder. 2. Select the proper object, then place the remote mounting bracket on the base and let the object go through the base and the mounting bracket. INSTALLATION HARDWARE HOLDER BASE REMOTE ...

9 OPERATION 3. Align the screw holes on the holder with the screw holes on the base and the screw holes on the bracket, then use the two screws (ø4X50) and nuts to fix the bracket,the base and holder to the proper location. 4. Last install the remote control to the holder. See below, align the four ...

• SWITCHING ON/OFF THE UNIT Switch on the unit by pressing anybutton (except EJECT (4)). When system is on, press POWER button (9) to turn off the unit. When system powerturns on, the system is returned toprevious mode. • DISPLAY THE DISC SLOT Press the hook (7) of the plastic disccover then poke it...

of the LCD display backlight. RESET FUNCTION When you pull out the plastic panel coveringthe CD opening, you will see the resetbutton (26) is placed above the disc slot(5). It must be activated with either aballpoint pen or thin metal object. Thereset button is to be activated for thefollowing reaso...

CD OPERATION • SWITCHING TO CD MODE If there is no CD inserted in the driver:Gently insert the CD with the printedside uppermost into the CDcompartment until you feel someresistance. The CD will be drawn intothe driver automatically. CD playbackbegins.If a CD is already inserted in the driver:Keep p...

for several seconds will exit PGMmode. - When the disc is playing in programmed order, pressing MEM button (20) for several seconds willcancel the all programmed contentand “CLR” appears on the display. - If you don’t press MEM button (20) to carry out program setting, thenpress PGM button (21) for ...

17 GENERAL P ower Supply Requirements : DC 12 Volts, Negative Ground Chassis Dimensions : 178 (W) x 178 (D) x 50 (H) mm Tone Controls- Bass (at 100 Hz) : ± 10 dB - Treble (at 10 KHz) : ± 10 dB Maximum Output P ower : 4 x 50 Watts Current Drain : 15 Ampere (max.) CD PLA YER Signal to Noise Ratio : Mo...

18 TROUBLE SHOOTING Before going through the check list, check wiring connection. If any of the problemspersist after check list has been made, consult your nearest service dealer. Symptom Cause Solution No power. The ignition switch is not If the power supply is on. connected to the accessory circu...