Presto 9401 - Manual

1

Refillable coffee holder

Coffee scoop

Coffee filter

Compacting cover

Air vent

Retractable

lifting pin

Fig. A

½ fill line

*

Home Cafe

is a trademark of the Proctor and Gamble Company.

Black & Decker

is a trademark of the Black and Decker Corporation.

Mr. Coffee

is a trademark of

Sunbeam Products, Inc. National Presto is not affiliated with these companies.

©

2005 by NPI, Inc.

Fig. B

Flat

side up

Fig. C

instructions

Before using the Presto

®

MyPod

™

refillable coffee holder with your Home Cafe* pod coffee maker, be sure the coffee maker is in

good working condition.

Before First Use

Before first use, wash the coffee scoop, refillable coffee

holder, and compacting cover in warm, soapy water.

Rinse thoroughly.

Brewing Coffee

1. Place a Presto

®

MyPod

™

coffee filter in the refillable

coffee holder.

2. Using the coffee scoop (Fig. A), pour 1 to 1½ scoops

of ground coffee on the filter in the refillable coffee

holder. Use 1 scoop for normal strength coffee and

1½ scoops for stronger coffee. Do not use more than

1½ scoops of coffee. Using a damp paper towel, brush

off any coffee grounds on the rim of the holder and

around the air vent before placing the holder in the

coffee maker.

Important:

The air vent must be clear before operating the coffee maker.

Always look

through the air vent on the refillable coffee holder before each use to make certain it is clear

(Fig. A). If the air vent on the coffee holder is clogged, clean it with a soft brush or a fine wire.

For best results, use coffee ground for drip coffee makers. This is the same grind used in the

commercial pods.

Do not use finely ground coffee with this holder.

3. Position the compacting cover over the coffee grounds so the flat side is facing up (Fig. B) and

push it down firmly and completely to compact the coffee grounds. Depress retractable lifting

pin before use.

4. Remove the pod holder that came with your Home Cafe* pod coffee maker. Replace it with the

Presto

®

MyPod

™

refillable coffee holder (Fig. C) and follow the manufacturer’s instructions for

brewing coffee.

It is normal for the brewed coffee to contain a small amount of sediment. To minimize the sedi

-

ment, clean off any coffee grounds on the rim of the holder before each use.

Removing and Cleaning Holder

1.

Your Home Cafe* coffee maker operates under high pressure. After coffee is done brewing,

before opening unit, wait approximately one minute to allow pressure to reduce and excess water to drain through unit. It is

normal for a small amount of dripping to occur once the brewing cycle is complete.

2.

Slowly open lid on your coffee maker and using the handle, carefully remove the coffee holder from the coffee maker.

Use caution

when removing coffee holder from coffee maker as there may still be some hot water/coffee in holder that may drip.

Let

mypod

™

refillable coffee holder

(model 09401)

Replaces the Black & Decker* model HCC100 and
Mr. Coffee* model SSP10 Home Cafe* pod holder.