Premier Mounts PP-FCMA-QL - Manual

Page 2 - Warning Statements

Page 2 Installation Instructions PP-FCMA-QL Table of Contents Warning Statements Warning Statements 2 Parts List 3 Installation Tools 3 Ceiling Tile Removal 4 Ceiling Anchoring 5 PP-FCMA-QL Installation 6 Attaching Pipe Clamps 7 Attaching EMT Conduit Pipe (Optional) 7 Quick Lock Installation 8 Elect...

Page 3 - Parts List

Installation Instructions Page 3 Parts List This ceiling adapter is shipped with all proper installation hardware and components. Make sure that none of these parts are missing and/or damaged before beginning installation. If there are parts missing and/or damaged, please stop the installation and c...

Page 4 - Ceiling Tile Removal; Read all cautions and warnings before continuing.

Page 4 Installation Instructions Ceiling Tile Removal Read all cautions and warnings before continuing. Step 1. Carefully remove the 24” x 24” or, depending on your ceiling configuration, the 24” x 48” suspended ceiling tiles. Observe the room and the ceiling; find the proper location for the PP-FCM...

Page 5 - Ceiling Anchoring; Truss

Installation Instructions Page 5 Ceiling Anchoring Truss Concrete Wood Truss ceilingStep 1. Loop the braided cable around the truss. Step 2. Run the open end through the loop. Step 3. Pull the open end down until the braided cable tightens around the truss. Wood Joist Step 1. Secure the four (4) ¼” ...

Page 6 - Attach the braided

Page 6 Installation Instructions The dual knock out plates for the electrical box must be removed prior to installation. PP-FCMA-QL Step 1. Attach the braided cable , using the directions on page 5, in the appropriate manner for your mounting configuration. Step 2. Let the four (4) strands of braide...

Page 7 - Lower the pipe clamp onto the step bolt.; Attaching the Pipe Clamps; through the pipe clamps.; Attaching the EMT Conduit Pipe (Optional)

Installation Instructions Page 7 Step 1. Locate the pre-installed step bolts that are on the PP-FCMA-QL. Step 2. Remove the four (4) black rubber caps from the step bolts. Step 3. Lower the pipe clamp onto the step bolt. Step 4. Secure the pipe clamp to the PP-FCMA-QL using a 1/4” KEP nut (see above...

Page 8 - Quick Lock Installation; Cable

Page 8 Installation Instructions Quick Lock Installation Re-check all hardware and installation for proper tightness and security and replace the tile. Cable OutputCable Input Directional Input Arrows Release Pin Directional Input Arrows Feed braided cable into the cable lock (see directional input ...

Page 10 - Installation Instructions; Cut the tile where the electrical base box is going to be secured.; Electrical Box Installation

Page 10 Installation Instructions PP-FCMA-QL Ceiling Tile PP-FCMA-QL M8 Flat Washer M8 x 20mm Phillips Head Screw PP-FCMA-QL Adjustments Step 1. Loosen the M8 x 20mm screws and M8 flat washers. This will allow you to slide the base box laterally. Please refer to the purchased base box for further op...

Page 11 - Technical Specifi cations

PP-FCMA-QL Installation Instructions Page 11 Technical Specifi cations All measurements are in inches (mm). Securing Pipe to the PP-FCMA-QL Step 1. Secure the 1½” (NPT) pipe to the ceiling plate and tighten by using one (1) M5 x 16 Phillips head screw (supplied) to the plate. The M5 x 16 Phillip hea...

Premier Mounts PP-FCMA-QL - Manual

Table of Contents:

Summary

Other Premier Mounts Models