Page 2 - FCC STATEMENT; Notice
EN-1 FCC STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to thefollowing two conditions:(1) This device may not cause harmful interference, and(2) This device must accept any interference received, including interference that may cause undesired operation. Note: Th...
Page 3 - READ THIS FIRST; Trademark Information
EN-2 READ THIS FIRST Trademark Information Microsoft ® and Windows ® are U.S. registered trademarks of Microsoft Corporation. Pentium ® is a registered trademark of Intel Corporation. Macintosh is a trademark of Apple Inc. SD™ is a trademark. Other names and products may be trademarks or r...
Page 4 - SAFETY INSTRUCTIONS; Warnings; Do not disassemble, change or repair the camera.; Keep the battery out of the reach of children.
EN-3 SAFETY INSTRUCTIONS Please read all Warnings and Cautions before using this product. Warnings If foreign objects or water enter the camera, turn the power off andremove the battery. Continued use may cause personal injury. Please consult our friendlycustomer service. If the camera has been drop...
Page 5 - Cautions; Do not fire the flash close to anyone’s eyes.; Do not subject the LCD display to impact.; Do not wrap the camera or place it in cloth or blankets.; Before you move the camera, disconnect all cords and cables.
EN-4 Cautions Insert the battery properly paying careful attention to the polarity (+ or–) of the terminals. Inserting the battery with its polarities inverted may cause damage to theproduct, injury, or damage to the surrounding areas due to the batteryleaking. Do not fire the flash close to anyone’...
Page 6 - Notes on Battery Usage
EN-5 Notes on Battery Usage When you use the battery, carefully read and strictly observe the Safety Instructions and the notes described below: Use only the specified battery (3.7V). Avoid extremely cold environments as low temperatures can shorten the battery lifeand reduce camera performance....
Page 7 - Important Information on Underwater Instructions
EN-6 Important Information on Underwater Instructions Before using the camera underwater, please make sure to read the following the instructions carefully. Before Using in Water: 1. Make sure there is no foreign material such as dirt or sand on the waterproof seal of the battery/SD card door. Water...
Page 9 - CONTENTS
CONTENTS EN-8 9 INTRODUCTION 9 Overview 9 Package Contents 10 GETTING TO KNOW YOUR CAMERA 10 Front View10 Rear View11 Button Operation12 User Interface 14 GETTING STARTED 14 Preparation15 Charging the Battery16 Initial Settings 18 CAPTURE MODE 18 Capturing Still Images19 Taking Images When the Smile...
Page 10 - INTRODUCTION; Overview
EN-9 INTRODUCTION Overview Congratulations on your purchase of your new Polaroid digital camera.Capturing high-quality digital images is fast and easy with this state-of-the-art smartcamera. Equipped with a 8.0-megapixel CCD, this camera is capable of capturingimages with a resolution of up to 3264 ...
Page 11 - GETTING TO KNOW YOUR CAMERA; Front View
EN-10 GETTING TO KNOW YOUR CAMERA Front View Rear View 1 6 2 3 5 4 12 15 14 13 7 8 9 1011 1. Shutter button2. Power button3. Flash4. Self-timer LED5. Lens6. Microphone 7. LCD display8. Status LED 9. Hand strap holder10. Tripod socket 11. Battery/SD card door12. Waterproof seal13. Battery compartment...
Page 12 - Button Operation
EN-11 Button Operation Item Function 8 Capture Mode 6 Video Mode 7 Playback Mode 1. > : Zooms out = : Zooms in > : Zooms out = : Zooms in > : Thumbnail = : Zooms in 2. Switches to: video mode > scene mode selection screen Switches to: scene mode selection screen > capture mode Still i...
Page 13 - User Interface
EN-12 User Interface Capture mode P m 2008 / 01 / 01 00 : 00 2008 / 01 / 01 00 : 00 00001 00001 + 0.3 x4.0 x4.0 1 2 3 10 11 12 13 4 5678 9 14 15 16 17 18 q q 1. Zoom status2. Flash mode [Blank]Auto Flash[ a ] Always ON [ d ] Flash Off [ c ] Red-eye Reduction [ ` ] Slow Sync [ _ ] Pre-flash 3. Batter...
Page 15 - GETTING STARTED; Preparation
EN-14 GETTING STARTED Preparation 1. Attach the camera’s hand strap as shown in the illustration. 2. Open the camera’s battery/SD card door.3. Insert the supplied battery in the correct orientation as shown. 4. Insert a SD/SDHC memory card (Optional). The camera has 32MB internal memory (28MBavail...
Page 16 - Charging the Battery
EN-15 Charging the Battery You must fully charge your battery before the initial use of your camera. 1. Insert the battery into the battery charger.2. Connect the power cord to the charger and insert the plug into a wall outlet. The status LED on the charger is redwhen charging and is green whench...
Page 17 - Initial Settings; Setting the Date and Time
EN-16 Initial Settings Setting the Date and Time The date/time needs to be set when: The camera is turned on for the first time. The camera is turned on after leaving the camera without the battery for anextended period of time. When the date and time information is not displayed on the LCD disp...
Page 19 - CAPTURE MODE; Capturing Still Images; MODE
EN-18 CAPTURE MODE Capturing Still Images Your camera is equipped with a 2.5" full color TFT LCD display to help you composeimages, playback recorded images/video clips or adjust menu settings. 1. Press the power button to turn the power on. The status LED turns green when the camera is on. 2....
Page 21 - Capturing Images using the Face Detection Feature
EN-20 Capturing Images using the Face Detection Feature The Face Detection feature identifies and focuses on the faces in the image. Thisadvanced feature simultaneously detects up to 5 faces regardless of their position in thescene. 1. Toggle the MODE button to [ 8 ]. 2. Toggle the OZ button until [...
Page 22 - Setting the Scene Mode
EN-21 Setting the Scene Mode By simply selecting one of the following 24 scene modes, you can capture your imagewith the most appropriate settings. 1. Toggle the MODE button until the scene mode selection screen appears. 2. Select the desired scene mode with the e / f buttons, and press the SET butt...
Page 24 - Taking Underwater Images
EN-23 Taking Underwater Images Choose one of the underwater scene modes available in this camera by following the steps in“Setting the Scene Mode ” . Before using the camera underwater, make sure to read and understand the information in “Important Information on Underwater Instructions”. Taking und...
Page 25 - VIDEO MODE; Recording Video Clips; Playing Back Video Clips
EN-24 VIDEO MODE Recording Video Clips This mode allows you to record video clips at a resolution of VGA 640 x 480 / QVGA 320 x240 pixels.1. Toggle the MODE button to [ B ]. 2. Compose the image.3. Press the shutter button. The recording will start. Pressing the shutter button again will stop th...
Page 26 - PLAYBACK MODE; Playing Back of Still Images
EN-25 PLAYBACK MODE Playing Back of Still Images You can play back your still images on the LCD display. 1. Press the [ 7 ] button. The last image appears on the screen. 2. The images can be displayed in forward or reverse sequence with the e / f buttons. To view the previous image, press the e ...
Page 27 - Thumbnail Display
EN-26 Thumbnail Display This function allows you to view thumbnail images on the LCD display so you maysearch for a particular image/video clip. 1. Press the [ 7 ] button. The last image appears on the screen. 2. Press the > button. 3 thumbnail images are displayedsimultaneously. Press the ...
Page 28 - Attaching Voice Memos; Playing back voice memo
EN-27 Attaching Voice Memos A maximum of 30 seconds of audio can be recorded as a memo for captured stillimages. The voice memo can be recorded only once. 1. Press the [ 7 ] button. The last image appears on the screen. 2. Select the image to which you want to attach the voice memo with the e / f ...
Page 29 - Protecting Images; Canceling the Protection
EN-28 Protecting Images To prevent images from accidentally being erased, follow the steps below:1. Press the [ 7 ] button. 2. Select the image that you want to protect with the e / f buttons. 3. Press the MENU button. 4. Select [Protect] with the c / d buttons, and press the SET button. 5. Select [...
Page 30 - Erasing Images
EN-29 Erasing Images 1. Press the [ 7 ] button. 2. Select the image you want to delete with the e / f buttons. 3. Press the F button. 4. Select [Single] or [All] with the c / d buttons, and press the SET button. [Single]: Erases the selected image or the lastimage. [All]: Erases all of the image...
Page 31 - MENU OPTIONS; Capture Menu
EN-30 MENU OPTIONS Capture Menu This menu is the basic settings to be used when capturing still images. 1. Toggle the MODE button to [ 8 ]. 2. Press the MENU button, and select the [Capture] / [Function] menu with the e / f buttons. 3. Select the desired option item with the c / d buttons, and press...
Page 32 - ISO; Metering; Color
EN-31 W. Balance This sets the white balance for a variety of lighting conditions and adjusts the images overall color according to the surrounding light conditions. Use this function if image color appears unnatural. * [Blank] Auto (for most photographic scenes)* [ $ ] Incand. * [ & ] Fluoresc....
Page 33 - Quick Shot
EN-32 Capture Md. This sets the recording method at the time of capturing images. In [Continuous], [AEB], [Cont.flash], [Burst], and [Pre-Shot] capture mode, the [Voice Memo] is automatically fixed at [Off]. Quick Shot If this function is set to “On”, the camera takes a quick shot without focusing...
Page 34 - Video Menu
EN-33 Video Menu This menu is for the basic settings to be used when recording video clips. 1. Toggle the MODE button to [ B ]. 2. Press the MENU button, and select the [Capture] / [Function] menu with the e / f buttons. 3. Select the desired option item with the c / d buttons, and press the SET but...
Page 35 - Playback Menu; MENU
EN-34 Playback Menu In the [ 7 ] mode, choose which settings are to be used for playback. 1. Press the [ 7 ] button. 2. Press the MENU button. 3. Select the desired option item with the c / d buttons, and press the SET button to enter its respective menu. 4. Select the desired setting with the c / d...
Page 36 - Setup Menu
EN-35 Setup Menu Set your camera’s operating environment. 1. Toggle the MODE button to [ 8 ] or [ B ]; or press the [ 7 ] button. 2. Press the MENU button, and select the [Setup] menu with the f button. 3. Select the desired option item with the c / d buttons, and press the SET button to enter its r...
Page 37 - Format
EN-36 Light Freq. This camera supports different lighting frequencies: 50 Hz and 60 Hz. When photographing under fluorescent lighting, select the correct frequency setting depending in your local area's voltage. This function is only effective if you set the White Balance to Fluorescent setting. * 5...
Page 38 - System Requirement; Downloading Your Files
EN-37 TRANSFERRING FILES TO YOUR COMPUTER System Requirement Downloading Your Files 1. Connect one end of the USB cable to an available USB port on your computer. 2. Connect the other end of the USB cable to the USB terminal on the camera. 3. Turn on your camera.4. Select [PC] using the c / d button...
Page 39 - USING THE CAMERA AS A PC CAMERA
EN-38 USING THE CAMERA AS A PC CAMERA Your camera can act as a PC camera, which allows you to videoconference with busi-ness associates, or have a real-time conversation with friends or family. To use the cam-era for videoconferencing, your computer system must include the items as below: Micropho...
Page 40 - EDITING SOFTWARE INSTALLATION; ArcSoft MediaImpressionTM; Print Creations
EN-39 EDITING SOFTWARE INSTALLATION There are 3 types of software that are included on the CD-ROM: ArcSoft MediaImpression™ - manages your media for you, and gives you tons of fun and exciting ways to create and share projects featuring your photo, video, and musicfiles. Create your own movies or ph...
Page 41 - SPECIFICATIONS
EN-40 SPECIFICATIONS * Design and specifications are subject to change without notice. Item Description Image sensor 1/2.5” CCD sensor (8.0 megapixels) Image resolution Still image 8M: 3264 x 2448, 6M: 2816 x 2112, 4M: 2272 x 1704, 2M: 1600 x 1200, 0.3M: 640 x 480 Video clip VGA: 640 x 480 (25 fps),...
Page 42 - APPENDIX; Possible Number of Shots
EN-41 APPENDIX Possible Number of Shots Possible number of shots (still image) The table shows the approximate shots that you can capture at each setting based on the capacity of the internal memory and the SD/SDHC memory card. Possible recording time / sec (video clip) * We recommend a memory card ...
Page 43 - Troubleshooting
EN-42 Troubleshooting Refer to the symptoms and solutions listed below before sending the camera for repairs. If the problem persists, contact your local reseller or service center . Symptom Cause Solutions / Corrective Actions The power does not come on. The battery is not inserted. Insert the batt...
Page 44 - Connecting to a PictBridge Compliant Printer; Connecting the camera to the printer
EN-43 Connecting to a PictBridge Compliant Printer If a printer that supports PictBridge is available, images can be printed by connectingthe digital still camera directly to the PictBridge-compatible printer without using acomputer. Connecting the camera to the printer 1. Connect one end of the USB...
