Planar PXL2230MW - Manual - manualsarea.com

Page 2 - Content

Content Operation Instructions ...........................................................................................................1 Unpacking Instructions ..........................................................................................................2 Safety Precautions .............

Page 3 - Operation Instructions; Reorient or relocate the receiving antenna.

1 Operation Instructions Thank you for purchasing the PXL2230MW multi-touch LED LCD monitor. Please read this guide thoroughly before installation. FCC RADIO FREQUENCY INTERFERENCE STATEMENT WARNING: (FOR FCC CERTIFIED MODELS) This TFT LED LCD monitor has been tested and found compliant with the lim...

Page 5 - Front View of the Product; Volume Adjust/ Scroll Down/ Adjust Decrease

3 Front View of the Product ① OSD Turn On/ Off ② Volume Adjust/ Scroll Down/ Adjust Decrease ③ Preset Mode/ Scroll UP/ Adjust Increase ④ Input select/ Confirm Selection ⑤ Power On/ Off ⑥ LED Indicator ① ② ③ ④ ⑤ ⑥

Page 6 - Rear View of the Product; Power Input

4 Rear View of the Product ⑦ ⑧ ⑨ ⑩ ⑪ ⑫ ⑬ ⑦ Power Input ⑧ USB – Type A to B ⑨ Headphone Jack ⑩ Audio Input ⑪ HDMI Input(HDMI 19 pin) ⑫ DVI Input (DVI 24 pin) ⑬ VGA Input (D-Sub 15 pin)

Page 7 - Quick Installation; Connect the USB cable from the computer to the monitor.

5 Quick Installation 1. Connect either VGA, DVI or HDMI Video Source from the monitor to the computer. Make sure both monitor and computer are powered OFF. 2. Connect the audio cable from audio output of computer to the audio input of the monitor. 3. Connect the USB cable from the computer to the mo...

Page 8 - Basic Operation and Calibration/Reset Instructions; POWER; Using the OSD Menu

6 Basic Operation and Calibration/Reset Instructions Before using the TFT Touchscreen LED LCD monitor:  Connect external equipment properly.  Insert the power plug, and the power LED indicator will light orange. Power On/Off To turn the TFT Touchscreen LED LCD monitor on/off: Press POWER button on...

Page 9 - Reset

7 Option 2: OSD & Power button lock – all 5 buttons including the “POWER” button are locked. Press and hold the 1 button and the ▼ button for 10 seconds to lock all 5 buttons. The TFT Touchscreen LED LCD monitor will show a “Lock Out” message for 3 seconds and the message will disappear automati...

Page 10 - Advanced Operation—OSD Menu

8 Advanced Operation—OSD Menu You can use the OSD menu to adjust various settings for your TFT Touchscreen LED LCD monitor. Press the 1 button to display the OSD Menu, and use ▲▼ to select the desired OSD menu. Short Cuts Function from the button(s) Auto Image Adjust: To auto adjust Horizontal Posit...

Page 13 - Supporting Timing Modes; Doing so may result in permanent damage to your monitor.

11 Supporting Timing Modes STANDARD RESOLUTION VGA 720 x 400 @ 70Hz VGA 640 x 480 @ 60Hz MAC 640 x 480 @ 67Hz VESA 640 x 480 @ 72Hz VESA 640 x 480 @ 75Hz VESA 800 x 600 @ 56Hz VESA 800 x 600 @ 60Hz VESA 800 x 600 @ 72Hz VESA 800 x 600 @ 75Hz MAC 832 x 624 @ 75Hz VESA 1024 x 768 @ 60Hz VESA 1024 x 76...

Page 14 - Technical Information; Optical Touch

12 Technical Information LCD Panel 21.5” TFT (with LED backlight) Power Management On: 25 Watts (typical),30 Watts (maximum) Standby Mode : < 0.5 Watt Off: < 0.5 Watt Displayable Resolution Full HD 1920 x 1080 max. Vertical Frequency 60Hz max. Pixel Dimension 0.24825 x 0.24825 mm LCD Display C...

Page 15 - Wall-Mount Installation Instructions; Wall Mount Arm not included; Lay the TFT Touchscreen LED LCD monitor face down on a

13 Wall-Mount Installation Instructions Wall Mount Arm not included Turn the power OFF then disconnect the cables from the TFT Touchscreen LED LCD monitor before performing the procedure below. 1. Lay the TFT Touchscreen LED LCD monitor face down on a soft surface. 2. Remove the 4 screws holding the...

Page 16 - Troubleshooting; No power; Power on but no screen image; Connect the TFT Touchscreen LED LCD monitor to another computer.

14 Troubleshooting No power  Make sure A/C power cord is securely connected to the power adapter and the power supply is firmly connected to the TFT Touchscreen LED LCD monitor.  Plug another electrical device into the power outlet to verify that the outlet is supplying proper voltage.  Make sure...

Page 17 - Technical Support; Planar Support

15 Planar Support Cables, Replacement Lamps, Accessories To find cables, replacement lamps and accessories for your LED LCD monitor, touch screen or other Planar products visit our online store at www.PlanarOnline.com or find other stores who carry Planar products at http://www.planar.com/howtobuy T...

Planar PXL2230MW - Manual

Table of Contents:

Summary

Other Planar Models