Philips BTM2056/05 - User Manual

5 EN Overview of the main unit a • Turn the system on. • Switch to standby mode. a b c d e f g h i j k l mn b SOURCE • Select a source: CD, Bluetooth, FM tuner, USB, or MP3 LINK.

6 EN c / • Skip to the previous or next track. • Search within a track or disc. • Tune to FM radio stations. • Adjust time. d • Confirm a selection. • Select mono or stereo broadcast. • Star t or pause play. e • Stop play or erase a program. f VOLUME + / - • Adjust volume. g • Open or close the disk...

8 EN 3 Get started Caution • Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. Always follow the instructions in this chapter in sequence. Placement You can place the system on a flat surface or mount i...

9 EN Turn on Press . » The system switches to the last selected source. Tip • To select another source, press SOURCE repeatedly or the source selection buttons on the remote control. Switch to standby mode Press to switch the system to standby mode. » The clock (if set) appears on the display panel....

10 EN 2 Press and hold for 3 seconds to star t full scan. » The system automatically stores FM radio stations with sufficient signal strength. » The first preset station is broadcast automatically. Tip • To exit storing mode, press or . 4 Play Play disc 1 Press to open the disc tray. 2 Inser t a dis...

11 EN 1 Inser t the USB storage device into the socket. 2 Press USB on the remote control to select the USB source. » Play star ts automatically. If not, press . Play from Bluetooth-enabled devices Note • The effective operating range between the system and the paired device is approximately 10 mete...

12 EN REPEAT / SHUFFLE [ ] : Play the current track repeatedly. [ ] (for MP3/ WMA only): play all tracks in this album repeatedly. [ ]: play all tracks repeatedly. [ ]: play all tracks randomly. To return to normal play, press REPEAT / SHUFFLE repeatedly until the repeat or shuffle icons disappear. ...

14 EN Select stereo/mono broadcast Note • Stereo broadcast is the default setting for tuner mode. • For stations with weak signals: to improve the reception, change to monaural sound. In FM tuner mode, press to switch between mono and stereo broadcast. 6 Other features Set the alarm timer This syste...

15 EN Tip • If CD or USB is selected as alarm source, yet there is no disc inser ted or no USB connected, the system switches to the tuner source automatically. Set the sleep timer Note • Make sure that you have set the clock correctly. When the system is turned on, press SLEEP repeatedly to select ...

16 EN 7 Product information Note • Product information is subject to change without prior notice. Specifications Amplifier Maximum Output Power 15 W Frequency Response 63 -14000 Hz, -3 dB Signal to Noise Ratio > 57 dBA Total Harmonic Distor tion <1% MP3 Link Input 650 mV RMS Disc Disc Diameter...

17 EN Unsupported formats: • Empty albums: an empty album is an album that does not contain MP3/WMA files, and is not be shown in the display. • Unsuppor ted file formats are skipped. For example, Word documents (.doc) or MP3 files with extension .dlf are ignored and not played. • AAC, WAV, PCM audi...

18 EN 8 Troubleshooting Warning • Never remove the casing of this device. To keep the warranty valid, never tr y to repair the system yourself. If you encounter problems when using this device, check the following points before requesting ser vice. If the problem remains unsolved, go to the Philips ...

20 EN 9 Notice Any changes or modifications made to this device that are not expressly approved by Philips Consumer Lifestyle may void the user’s authority to operate the equipment. This product complies with the radio interference requirements of the European Community. Your product is designed and...