Peavey 410 - Manual
Peavey 410 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 4 – REAR PANEL; service center for repair.
- Page 5 – SPECIFICATIONS; PREAMP SECTION; The following specs are measured; Nominal level is with Input; Lead Channel; TONE SETTING; External Footswitch Function:; ROCK
- Page 6 – STANDBY SWITCH (Interruptor de
- Page 7 – REMOTE SWITCH JACK (Enchufe
- Page 9 – GROUND SWITCH
- Page 10 – Siehe diagramm der frontplatte im englischen teil des handbuchs.
- Page 13 – IMPORTANT SAFETY INSTRUCTIONS; WARNING; SAVE THESE INSTRUCTIONS
- Page 14 – Peavey Electronics Corporation
Single Unit Guitar Amp
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
REAR PANEL 16 The fuse is located within the cap of the fuseholder. If the fuse should fail, IT MUST BE REPLACED WITHTHE SAME TYPE AND VALUE IN ORDER TO AVOID DAMAGE TO THE EQUIPMENT AND TO PRE-VENT VOIDING THE WARRANTY. If the amp repeatedly blows fuses, it should be taken to a qualified service ce...
SPECIFICATIONS POWER AMPLIFIER SEC-TION 4 with driver Rated Power Load: 50 W RMS into 16 or 8 ohms Power Clipping: (Typically) (5% THD, 1 120 V AC line) 50 W RMS into 16 or 8 ohms(Bias must be reduced to measure) Frequency Response: -2 50 Hz to 15 40 W RMS into 16 ohms Hum Noise: Greater than 80 bel...
Consulte diagramas panel delantero en la de de este manual. POWER SWITCH (Interruptor de corriente) (1) Coloque a la “on” STANDBY SWITCH (Interruptor de de espera) (2) Este interruptor le a su aparato estar en o la de En la “standby” tubos permanecen calientes, pero el amplificador no en CHANNEL SEL...
