Paradyne UIM-10/100 - Manual
Paradyne UIM-10/100 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Install the MUM in an IP DSLAM chassis.; b. Slide the MUM firmly into the chassis. DO NOT USE EXCESS FORCE.; UIM Installation in a Mini DSLAM
- Page 3 – CAUTION; straight-through Ethernet cable
- Page 4 – Additional Information; LED Indicators; FCC Regulatory Compliance Information for Class A Equipment; LED State
- Page 5 – This Class A product complies with European Norm EN55022.; Worldwide Headquarters
220-0000016 rev01
UIM-10/100
Uplink Interface Module
INSTALLATION
1. Unpack and inspect the equipment.
The following components should be included:
If there is visible damage, do not attempt to connect the device; contact Customer Support at 1-877-
638-2638 (001-603-427-0600 for international customers) or [email protected].
2. Install the UIM-10/100.
Required tool for installation: Phillips screwdriver.
UIM Installation in an IP DSLAM
Affix the UIM to a Multiplexer Uplink Module (MUM).
a. Place the MUM on a flat surface with the circuit board facing up.
b. Select a port on the MUM for UIM installation; either port (1 or 2) may be used.
Although not required for operational purposes, if redundancy is desired, two UIMs
may be installed on the MUM, one in each port.
Installation Instructions
CAUTION
Net to Net Technologies strongly recommends the use of proper electrostatic discharge (ESD) precautions when
handling this equipment.
!
1 UIM-10/100
!
4 #6 Phillips Panhead Internal Locking Screws
!
2 #6 Phillips Beige Flathead Screws
NOTE
The UIM may be attached to a MUM that has already been in service, although you must remove the
MUM from the IP DSLAM in order to do so.
Removal of a MUM from an IP DSLAM chassis that is
powered up will not affect the operational status of other modules within the chassis; it
will, however, disengage the IP DSLAM's upstream network connection.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
220-0000016 rev01 c. Remove the blanking plate* from the selected port. d. Carefully slide the faceplate of the UIM under the lip of the MUM faceplate at the selected port opening such that the UIM circuit board is facedown and the UIM label shows through the port opening with the model name along t...
220-0000016 rev01 c. Remove the blanking plate* from the selected port. d. Carefully slide the faceplate of the UIM under the inside lip of the Mini DSLAM at the selected port opening such that the UIM circuit board is facedown and the UIM label shows through the port opening with the model name alo...
220-0000016 rev01 Additional Information LED Indicators Regulatory Compliance The following regulatory compliance information applies to the UIM-10/100 as installed in a Mini DSLAM chassis or as affixed to a MUM installed in an IP DSLAM chassis. FCC Regulatory Compliance Information for Class A Equi...
