Paradyne 496-15149 - Manual
Paradyne 496-15149 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Technical Specifications; Specification; Installing a Replacement Power Supply
- Page 3 – Power-Up Verification
- Page 4 – Verification Checklist; Troubleshooting; Symptom; Power Failure Recovery
496-15149
TM
1
2-Slot Power Supply
Installation Instructions
Document Number 9000-A2-GN1A-10
April 1998
Before You Begin
The 2-slot housing can hold one power supply, which is already installed in the housing.
Should you need to replace this power supply, be sure to review the following
information.
CAUTION:
Refer installation of power supplies to qualified service personnel.
!
HANDLING PRECAUTIONS FOR STATIC-SENSITIVE DEVICES
This product is designed to protect sensitive components from
damage due to electrostatic discharge (ESD) during normal
operation. When performing installation procedures,
however, take proper static control precautions to
prevent damage to equipment. If you are not sure
of the proper static control precautions, contact
your nearest sales or service representative.
Package Checklist
Verify that your package contains the following:
An ac power supply (See following specifications.)
An ac power cord
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 Technical Specifications Specification Criteria Rated Voltage (nominal) 100–250 Vac, 50/60 Hz Rated Current 1.0 Amps Operating Voltage Range (limits) 90–265 Vac 47–63 Hz Power Consumption (typical) 120 Vac 29.7 watts 452 mA 230 Vac 29.9 watts 270 mA Result: 102 Btu per hour Installing a Replacemen...
3 3. Unscrew the two screws on the current power supply using a flatblade screwdriver. 4. Remove the current power supply by pulling on the handle. 496-15126 5. Remove the new power supply from its shipping box. Handle only by the top and bottom edges of the sheet metal bracket to avoid damaging it....
4 Verification Checklist - Did the NAM’s OK LED light? If not, see Troubleshooting . Troubleshooting Symptom Possible Cause Solutions No power. The power cord is notsecurely plugged into thewall receptacle, or is notconnected to the powerinlet at the rear of thehousing. Check that the power cordis s...
