Paradyne 3510 - Manual - manualsarea.com

Page 2 - Warranty; Document Feedback

Copyright 1999 Paradyne Corporation. All rights reserved.Printed in U.S.A. Notice This publication is protected by federal copyright law. No part of this publication may becopied or distributed, transmitted, transcribed, stored in a retrieval system, or translatedinto any human or computer language ...

Page 3 - Product Documentation on the World Wide Web; HANDLING PRECAUTIONS FOR STATIC-SENSITIVE DEVICES

496-15149 TM 1 COMSPHERE 3500 Series Data Service UnitsModels 3510 & 3511Quick Reference Document Number 3510-A2-GL10-10 March 1999 Product Documentation on the World Wide Web We provide complete product documentation online. This lets you search thedocumentation for specific topics and print on...

Page 4 - Installation Procedures; Model 3510 DSU Installation; Hardware

2 Installation Procedures This section provides instructions for installing standalone Model 3510 DSUs andcarrier-mounted Model 3511 DSUs. Refer to the appropriate section. Model 3510 DSU Installation Physical installation of the Model 3510 consists of unpacking the DSU and placing it inits planned ...

Page 5 - Perform the Device Test as described in the

3 5. Perform the Device Test as described in the Operation section of the User’s Guide. If the DSU fails this test, replace the DSU. 6. Connect the network interface. The Model 3510 DSU’s rear panel contains a miniature universal service orderingcode (USOC) type RJ48S jack for connecting your DSU to...

Page 6 - Model 3511 DSU Installation; Rear View of the COMSPHERE 3000 Series Carrier

4 Model 3511 DSU Installation This section includes the installation procedures for the Model 3511 DSU, which isdesigned for installation in a COMSPHERE 3000 Series Carrier. Before installing theDSU, verify that the carrier has been installed properly and is operational. CAUTION: Discharge any stati...

Page 7 - Installing the Rear Connector Plate; To install a DSU and its rear connector plate for the first time:; Procedure; Model 3511 DSU Installation and Circuit Pack Lock

5 Installing the Rear Connector Plate To install a DSU and its rear connector plate for the first time: Procedure 1. Configure the DSU to meet the requirements of the application (refer to Hardware Strapping on page 8). Do not disable the front panel switches at this time. 2. At the rear of the carr...

Page 8 - Connecting to a V.35 Interface; Tighten the screws on both sides of the connector.

6 5. At the front of the carrier, hold the DSU vertically with the latch on its faceplate in the open position. Then, insert the circuit card into the top and bottom circuit cardguides for the slot that contains the rear connector plate. 6. Aligning the circuit card with the rear connector plate, sl...

Page 9 - Thumbscrews; Connecting to the Digital Network; appropriate slot number.

7 25-Pin Connector V.35 Adapter V.35 Cable Thumbscrews 99-16298 Model 3511 DSU V.35 Adapter Installation (Feature Number 3000-F1-510) Connecting to the Digital Network The installed DSU is connected to the digital network through the 50-pin connectors onthe rear of the carrier. These interfaces are ...

Page 10 - Hardware Strapping; Model 3510 DSU Strap Access

8 Hardware Strapping Both Model 3510 and 3511 DSUs can be configured for installation at the local orremote end of a network by setting onboard straps. The straps also allow you toconfigure either type of DSU (Model 3510 or 3511) as a LADS for connection to 4-wiremetallic circuits. 98-12303a S1 S3 S...

Page 11 - To remove the faceplate to change the hardware straps:; bezel from the tabs securing it in place.; Swing the front bezel up and set the bezel aside.; the bezel back into place.; Model 3511 DSU Strap and Fuse Locations

9 For the Model 3510 DSU, the straps are concealed behind the faceplate. To remove the faceplate to change the hardware straps: Procedure 1. With your thumbs under the edge of the front bezel, firmly press upward to lift the bezel from the tabs securing it in place. 2. Swing the front bezel up and s...

Page 12 - See Table 3, Data Rate Selection

10 Table 1. Straps S1 through S5 (1 of 2) Switch Selection Position Function S1–1S1– 2 S1– 3 S1– 4 S1– 5 S1– 6 —— R F R F R F R F See Table 2, Timing Signal Source SelectionSee Table 2, Timing Signal Source Selection Disables circuit assurance function (Default)Enables circuit assurance function Hol...

Page 17 - DSU Strap Setting Descriptions

15 Table 4. Network Address Selection for Model 3510 (4 of 4) Network Address Switch S4 Selection Network Address 6 5 4 3 2 1 56 F F F R R R 57 F F F R R F 58 F F F R F R 59 F F F R F F 60 F F F F R R 61 F F F F R F 62 F F F F F R 63 F F F F F R 64 (Default) R R R R R R F = Front R = Rear DSU Strap ...

Page 18 - When disabled, DSR is turned Off during a Local Loopback.

16 S1-4: DSR Normal during Local Loopback – DSR ON during Local Loopback. Whenenabled, this strap forces the DSR lead ON during a Local Loopback. This allows DTEsthat rely on DSR being on to send test messages to the DSU. When disabled, DSR is turned Off during a Local Loopback. S1-5: Elastic Store ...

Page 20 - Important Safety Instructions; included in the manual.

18 ! Important Safety Instructions 1. Read and follow all warning notices and instructions marked on the product or included in the manual. 2. This product is intended to be used with a 3-wire grounding type plug – a plug which has a grounding pin. This is a safety feature. Equipment grounding is vi...

Page 21 - United States – Notice to Users of the Telephone Network

19 Notices ! WARNING: ! WARNING: ! Government Requirements Certain governments require that instructions pertaining to connection to the telephonenetwork be included in the installation and operation manual. Specific instructions arelisted in the following sections. United States – Notice to Users o...

Page 22 - Canada – Notice to Users of the Canadian Telephone Network

20 No repairs may be performed by the user. Should you experience difficulty with thisequipment, refer to Warranty, Sales, Service, and Training Information inside the cover of this document. For Digital Data Service (DDS) installations, inform the local telephone company of theappropriate facility ...

Paradyne 3510 - Manual

Table of Contents:

Summary

Other Paradyne Models