Page 2 - Congratulations on your purchase of this; Palsonic; colour television receiver.; CONTENTS; Contents
Contents Congratulations on your purchase of this Palsonic colour television receiver. We recommend that you thoroughly read this manual before use to fully enjoy themany functions and excellent effects of this receiver.Retain this manual in an easily accessible location for future reference. Note: ...
Page 4 - Features
Clock/Game/Calendar English/French/Spanish/Indonesian on-screen display Hyperband 255 preset channels Automatic channel preset Full function remote control AV input & S-VIDEO input terminals Digital AFT technology Four picture modes ON timer/OFF timer Green Power Hotel lock 1 Features Features T...
Page 5 - Important Safety Cautions; Safety Cautions
Important Safety Cautions When any unusual situation occurs, turn off thepower supply at once and remove the plug from thewall outlet. Contact a qualified service department inyour local area. Do not expose the TV set to rain or excessivemoisture. Avoid using the set in very warm ordamp places and n...
Page 7 - Identification of Controls; Introduction; Front
1. :Earphone Jack 2. MENU button: To enter into menu operation.3. AV/TV button: Video input select.4. VOL- button: volume down adjust; menu item adjust.5. VOL+ button: volume up adjust; menu item adjust.6. CH- button: channel down select; menu item select.7. CH+ button: channel up select; menu item ...
Page 8 - Back
Back 1. Antenna input2. AV input (VIDEO, AUDIO L/MONO, R)3. S-VIDEO input 5
Page 9 - Remote Controller
6 Notes: In most cases, the function CH+/- buttons are equal to the buttons, and the function of VOL+/- buttonsare equal to the buttons. Identification of Controls (continued) Introduction Remote Controller ! /
Page 10 - Effective range of the Remote
! Install two "AAA" batteriesmatching the +/- polaritiesof the battery to the +/- marks inside the batterycompartment. Replace the battery cover. Notes: The battery life should be about one year under normaluse. Do not try to recharge batteries not intended to berecharged.Use only the size a...
Page 11 - Antenna installation; Installation; Antenna Installation/Connect to video and audio equipment
INSTALL the unit in a room where direct light will not fall upon the screen. Total darkness or a reflection onthe picture screen may cause eyestrain. Soft and indirect lighting is recommended for comfortable viewing. Antenna installation Optimum reception of colour requires a good signal and will ge...
Page 12 - Connect to video and audio equipment
Connect to video and audio equipment This TV set provides 2 groups of AV input terminals for your convenient connection to VTR, DVD orvideo camera to enjoy the high quality picture.Please refer to the owner's manual of the equipment to be connected as well. Important notes on the AV input terminalsP...
Page 14 - Operations; Select Input Signal; Select input signal; Press digit buttons to switch back to TV mode.
Operations Select Input Signal Select input signal ! 4 3 2 1 Press AV/TV button on the TV set or AV buttonon the remote control. When the set is in TV mode, press this button and the set goesto AV mode. Now you could watch video program from AVinput terminals.If you want to switch to TV press AV but...
Page 15 - Auto Search; Manual Search; Tuning in
3 2 1 2 4 3 2 1 5 1. Press CH+ or CH- buttons to select item. Press VOL+ or VOL- buttons to adjust item. Press MENU button four times to call Programmenu page. Auto Search Press MENU button repeatedly to enter intoProgram menu page. Press CH+ or CH- button repeatedly to selectAuto Search item. Press...
Page 16 - Fine tuning; Channel Skip/Fine tuning; Skip an unnecessary channel
4 3 2 1 5 Press MENU button repeatedly to enter intoProgram menu page. Press CH+ or CH- button repeatedly to selectChannel Number item. Press VOL+ or VOL- button to set a channelnumber (for example, channel 99). Press CH+ or CH- buttonrepeatedly to selectChannel Skip. Press VOL+ or VOL-button to set...
Page 17 - Colour System/Sound System Selection
3 2 1 Setting Colour System If the picture colour is abnormal, maybe the colour system setting iswrong. Then you can select a proper colour system as follows. Press MENU button repeatedly to enter intoProgram menu page. Press VOL+or VOL-button to select a propercolour system. Setting Sound System If...
Page 18 - Channel Selection
! 168 3 2 8 Press 0-9 directchannel selector. 1 Operations Channel Selection Use Direct Channel Selector (0-9 and -/-- buttons) To select one-digit channel: Press -/-- buttonrepeatedly todisplay "-". To select two-digit channel: Press -/-- buttonrepeatedly todisplay "--". To select t...
Page 19 - Adjusting Picture
100 Item Standard Soft Brightness Brightness 4 Contrast weaker Color paler deeper Sharpness darker lighter softer sharper Picture mode Vivid Adjusting Picture Contrast Color 80 50 50 50 50 Press MENU button, the Picture menu pagedisplays. Sharpness Tint Press CH+ or CH- button to select item. 50 50 ...
Page 20 - Sound Control; Adjusting Volume/Muting the Sound
Use MUTE button. ! Use VOL+ or VOL- button. Press VOL+ button, the volume increases;Press VOL- button, the volume decreases.The minimum volume is 0 and the maximum volume is 100. If you want to mute the sound,press button on the remote. To resume the sound, press thisbutton again. Notes: You can als...
Page 21 - Press CH- button twice to select Time Off item.; Clock Setting; Setting Time
2 1 Clock SleepTimerTime OffTime On 00:1000:30 - - 2 3 1 ! 2 3 Press MENU button repeatedly to enter intoClock menu page. Press VOL+ or VOL- button to set sleep time. The sleep time switches among Off, 10, 20, 30, 40, 50 and 60minutes. When the time is up the set auto goes to STANDBY. You can also u...
Page 22 - Time On/ Alarm Channel
3 2 1 1 2 3 Setting Time On Press MENU button repeatedly to enter intoClock menu page. Press CH- button repeatedly to select Time Onitem. Press VOL+ or VOL- button to set On time. After you finish setting Time On item, press the STANDBYbutton on the remote control. Then the TV set auto turns onwhen ...
Page 23 - System Setting
B. Before the icon disappear, continue to press 4, 3, 2, 1 on the remote control. C. Press VOL+ or VOL- button to switch between Off and On. 2 1 Press CAL (calendar) button onthe remote controller to displaycalendar.You can adjust month by VOL+/-buttons and year by CH+/- buttons. 20 Selecting OSD la...
Page 24 - How to play the name?
Child Lock 1 2 4 3 Firstly, please refer to the Hotel mode on the previous page to enter into the Control menupage. Press CH - button to select Child Lock item and then press VOL+ or VOL- button toswitch between On or Off. When the Child Lock is set to On, all programs will be shielded andthe screen...
Page 25 - Troubleshooting Guide; Others; Trouble Shooting
Remote controller doesnot work Unevenness in colour insome parts of the screen The screen is black Before calling service personnel, please check the following chart for a possible cause to the troubleyou are experiencing. Even if the picture or the sound is normal, changesin room temperature someti...
Page 26 - Specifications
! TV system & channel range Power Supply: Power Consumption: Dimensions (mm): Weight (kg): CRT: AC 240V, 50Hz 70W 590 (W) x 448 (H) x 483 (D) 23 51cm System PAL-B/G VHF 2-12 UHF 21-69 CATV X~Z+2, S1~S41 Colour System: Sound output: Accessories: PAL-B/G NTSC playback 1.5W x 2 Remote controller X ...
Page 27 - PALSONIC CUSTOMER SERVICE
604-J21193-03 PALSONIC CORPORATION PTY LTD 1 JOYNTON AVENUE WATERLOO NSW 2017 AUSTRALIA TEL:(02)9313 7111 FAX:(02)9313 7555 www.palsonic.com.au PALSONIC CUSTOMER SERVICE TELEPHONE AUSTRALIA: 1300 657 888
