Oregon Scientific EMR963HG - Manual
Oregon Scientific EMR963HG – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – Supports the remote unit in wall-mounting; BEFORE YOU BEGIN; Assign different channels to different remote units.; BATTERY AND CHANNEL
- Page 4 – Remove the screws on the battery compartment.; Select the channel number on the CHANNEL slide switch.; Select the temperature display unit on the °C/°F slide switch.; BATTERY INSTALLATION: MAIN UNIT; Follow these steps to install / replace batteries:; Slide open the battery compartment door.
- Page 5 – GETTING STARTED; To force a signal search:; HOW TO CHECK REMOTE AND; To display temperature / humidity readings from the main unit:; displayed in the box under the kinetic-wave.; HOW TO READ
- Page 6 – To activate the remote-sensor scanning mode:
- Page 7 – To deactivate the remote-sensor scanning mode:; MAXIMUM AND MINIMUM; To display the maximum and minimum display memory:; TEMPERATURE/HUMIDITY ALARM; Sequence; To set a high or low temperature or humidity alarm:; Press to set the temperature or humidity limit. Each press will
- Page 8 – To disable a sounding alarm:; DISCONNECTED SIGNALS
- Page 9 – Main unit; Remote unit
- Page 11 – NOTE ON COMPLIANCE
1
MULTI-CHANNEL IN-OUT
CABLE FREE
THERMO-HYGROMETER
MODEL : EMR963HG
USER’S MANUAL
INTRODUCTION
Congratulations on your purchase of Oregen Scientific's Cable-Free
Thermo-Hygro sensor.
Enclosed with this package is one (1) main display unit and one (1)
cable-free remote thermo-hygro sensor unit.
The main unit has an extra-large multifunction 2-line LCD that
shows recordings for indoor and outdoor temperatures, humidity,
maximum and minimum recordings and trend indicators. The unit
supports up to three 433MHz remote thermo-sensors or thermo-
hygro sensors. A variety of additional sensors can be purchased
separately.
In addition to monitoring maximum and minimum temperature and
humidity readings, the unit also has an alarm that can be set to
activate once readings exceed a given variance.
No wire installation is required between the main and remote units.
As the EMR963HG operates at 433MHz, it can be used in the U.S.
and most places in Continental Europe.
FEATURES: MAIN UNIT
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
3 H Wall-mount holder Supports the remote unit in wall-mounting I Removable table standFor standing the remote unit on a flat surface BEFORE YOU BEGIN To ensure proper functioning of the EMR963HG follow this setupprocedure. For best operation: 1. Assign different channels to different remote units. ...
4 Follow these steps to install / replace batteries: 1. Remove the screws on the battery compartment. 2. Select the channel number on the CHANNEL slide switch. 3. Select the temperature display unit on the °C/°F slide switch. 4. Insert the batteries strictly according to the polarities shown therein...
5 GETTING STARTED Once batteries are placed in a given remote sensor unit, it will starttransmitting information at 40-second intervals. Also, for approximately a 3-minute duration, the main unit willautomatically search for signals once batteries are installed. Uponsuccessful reception, the individ...
