Oreck WS-7013U - Manual
Oreck WS-7013U – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – INVENTORY OF CONTENTS; One strip of double sided adhesive tape; ADDITIONAL EQUIPMENT; Figure 1
- Page 6 – DETAILED SETUP GUIDE; I. BATTERY INSTALLATION; Remove the mounting
- Page 7 – B. INDOOR TEMPERATURE STATION; After the batteries are installed,; DO NOT; Remove the battery cover on the backside.; Battery
- Page 9 – III. UNITS OF TEMPERATURE MEASURE; SET
- Page 10 – To reset both the minimum and maximum
- Page 11 – For problems not solved, please
- Page 13 – MAINTENANCE AND CARE INSTRUCTIONS; Do not submerge in water.
- Page 15 – WARRANTY INFORMATION
WS-7013U
Wireless 433 MHz
Temperature Station
Instruction Manual
Register your product
on the web at:
WWW.ORECK.COM
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
INVENTORY OF CONTENTS 1. The indoor temperature station (Figure 1) 2. The remote temperature sensor (TX6U) and mounting bracket (Figure 2) 3. (3) 1/2" Philips screws 4. One strip of double sided adhesive tape 5. Instruction Manual and Warranty Card 6. (2) AAA 1.5V batteries 7. (2) AAA 1.5V batte...
3. The hour will now be flashing. a. Press and release the " MIN/MAX " button until the correct hour is shown. Note: When in the 12h mode "PM" is displayed under the word "TIME" during PMhours. During the AM hours this area will beblank. b. When the correct hour is shown, pre...
B. INDOOR TEMPERATURE STATION Note: After the batteries are installed, DO NOT press any buttons. This may interfere with thesignals, causing temperatures to registerincorrectly. 1. Remove the battery cover on the backside. To do this, push the cover upward and pull it out. 2. Observing the correct p...
