Oreck WS-7013U - Manuals - manualsarea.com

Page 3 - INVENTORY OF CONTENTS; One strip of double sided adhesive tape; ADDITIONAL EQUIPMENT; Figure 1

INVENTORY OF CONTENTS 1. The indoor temperature station (Figure 1) 2. The remote temperature sensor (TX6U) and mounting bracket (Figure 2) 3. (3) 1/2" Philips screws 4. One strip of double sided adhesive tape 5. Instruction Manual and Warranty Card 6. (2) AAA 1.5V batteries 7. (2) AAA 1.5V batte...

Page 6 - DETAILED SETUP GUIDE; I. BATTERY INSTALLATION; Remove the mounting

3. The hour will now be flashing. a. Press and release the " MIN/MAX " button until the correct hour is shown. Note: When in the 12h mode "PM" is displayed under the word "TIME" during PMhours. During the AM hours this area will beblank. b. When the correct hour is shown, pre...

Page 7 - B. INDOOR TEMPERATURE STATION; After the batteries are installed,; DO NOT; Remove the battery cover on the backside.; Battery

B. INDOOR TEMPERATURE STATION Note: After the batteries are installed, DO NOT press any buttons. This may interfere with thesignals, causing temperatures to registerincorrectly. 1. Remove the battery cover on the backside. To do this, push the cover upward and pull it out. 2. Observing the correct p...

Page 9 - III. UNITS OF TEMPERATURE MEASURE; SET

4. Press and release the " MIN/MAX " button to set the hour. 5. Press and release the " SET " button to move to the minute setting. 6. Press and release the " MIN/MAX " button to set the minutes. 7. Press and release the " SET " button to activate the clock. Note: Whe...

Page 10 - To reset both the minimum and maximum

IV. FEATURES A. MINIMUM AND MAXIMUM TEMPERATURES 1. Press and release the " MIN/MAX " button. "MIN" appears in the temperature LCDs andthe recorded minimum temperatures aredisplayed. 2. Press and release the " MIN/MAX " button to toggle to the maximum temperatures. Thetime of...

Page 11 - For problems not solved, please

before permanently mounting. A. REMOTE TEMPERATURE SENSOR 1. Remove the mounting bracket from the remote temperature sensor. 2. Mount using either screws or adhesive tape. 3. Reattach the remote temperature sensor to the mounting bracket. B. THE TEMPERATURE STATION 1. The indoor temperature station ...

Page 13 - MAINTENANCE AND CARE INSTRUCTIONS; Do not submerge in water.

responsive to ambient air currents because ofthe shielding effect of the display case. Inaddition, the case can act as a heat sink toabsorb and store heat from external sources(i.e. handling of the case or radiant heat). Inaddition, the much greater range of theoutdoor temperature sensor requires ad...

Page 15 - WARRANTY INFORMATION

Remote Temperature 1.57" x 0.9" x 5.04" Sensor (40 x 23 x 128 mm) Battery life Approximately 1 year WARRANTY INFORMATION Oreck Corporation warrants the Indoor/OutdoorClock and Weather Station (WS-7013U) freefrom defects in material and workmanship undernormal, non-commercial use and serv...