Oki 58374501 - Manual
Oki 58374501 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Step 2: Prepare the Inverter
- Page 4 – Step 3: Assemble the Inverter
- Page 5 – Step 4: Assemble the Finisher
- Page 8 – Step 5: Make Connections
Finisher Unit Installation Guide
Components
1
Finisher Unit
7
Inverter Stand
2
Finisher stand
8
Clear Band
3
Finisher Stacker
9
Band Stopper, Small
4
Finisher Cover
10
Band Stopper, Large
5
Power Cord
11
Metal Brackets
6
Inverter Unit
12
Cable (inverter to printer)
Not illustrated: Screws
Step 1: Prepare the Printer
1. Turn the printer off (
!
) and disconnect the
power cord (
"
) and interface cable (
#
).
2. Using a screwdriver, remove the breakout
panels on the side of the printer.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 3. Install the metal brackets where the breakout panels were. 4. Open the face-up stacker ( ! ), then open the flap and press it onto the stacker surface ( " ). 5. Close the stacker. Step 2: Prepare the Inverter Before assembling the finisher, you must adjust the height of the inverter unit to...
4 5. Pull forward on the extension plate to disengage the pins from the top channel stops, then slide it down into the inverter and push back to engage the pins on the bottom channel stops. 6. Reattach the extension plate using the screws you removed earlier. 7. Turn the inverter around and reinstal...
5 2. Attach the front of the inverter to the stand using two screws on either side. 3. Attach the back of the inverter to the stand using one screw on either side. 4. Attach the guard rail on the inverter stand to the printer using 2 screws. Step 4: Assemble the Finisher 1. Hook the finisher stand o...
