Page 2 - ENGLISH; DURATION PER DAY (HOURS) 8 6 4 3 2 1; IMPORTANT SAFETY INSTRUCTIONS; CAUTION
ENGLISH DangerExposure to extremely high noise levels may cause a permanent hearing loss. Individuals vary considerably to noise induced hearing loss but nearly everyone will lose some hearing if exposed to sufficiently intense noise for a sufficient time. The U.S. Government's Occupational Safety a...
Page 3 - FRENCH; DURE EN HEURES PAR JOUR 8 6 4 3 2 1; ATTENTION; IMPORTANTES INSTRUCTIONS DE SECURITE
FRENCH DURE EN HEURES PAR JOUR 8 6 4 3 2 1 INIVEAU SONORE CONTINU EN dB 90 93 95 97 100 103 DangerL‘exposition a des niveaux eleves de bruit peut provoquer une perte permanente de l’audition, Chaque organisme humain reagit differemment quant a la perte de l’audition, mais quasiment tout le monde sub...
Page 5 - Introduction
Congratulations on your purchase of the NuVo T2 dual Tuner. With the T2 Dual Tuner, broadcast music enters the twenty-first century. Finally you can enjoy state-of-the-art, advanced radio and satellite receiver technology, with astonishingly clear reception throughout the entire home. Combined with ...
Page 6 - NV-T2DF Wiring Diagram; Diagram is shown with the NuVo Concerto System and NuVoNet.; NV-T2DFX Package Contents
NV-T2DF Wiring Diagram Diagram is shown with the NuVo Concerto System and NuVoNet. NV-T2DF Package Contents: 1 NV-T2DF Dual AM, FM, WX Tuner 1 NV-T2FAA Active AM/FM Antenna1 NV-T2RC3 Remote Control2 NV-RCA1 Stereo RCA Audio Cables1 NV-AC1 2 Meter Coaxial Antenna Cable1 NV-PC2 North American Power Ca...
Page 7 - Front Panel; Frequency and Band Display:; station being received.; Category Up and Down:; This button toggles between RDS information on and off.
Front Panel 1. Stand-by LED: This LED (Light Emitting Diode) indicates that the T2 is plugged into an AC power source. 2. Remote Sensor: This IR (Infrared) receiver allows wireless remote control of the T2 functions. This IR input is active, even when it is used in conjunction with the direct IR inp...
Page 8 - Back Panel; Simplese, Essentia, and Concerto audio distribution systems.
Back Panel 1. Antenna Input: Coax “F” connector brings in the signal input from the NuVo NV-T2FAA AM/FM or the NV-T2XAA XM active antenna (pg. 11). 2. Aux. Input: This stereo RCA connector is enabled through the advanced menu options (pg. 14), and allows an additional audio source to be connected an...
Page 9 - NV-T2RC3 Remote Control; The power button turns the selected tuner on and off.; momentarily when a button is pushed.
NV-T2RC3 Remote Control 1. Power: The power button turns the selected tuner on and off. 2. Scroll Buttons: These buttons are the equivalent of turning the front panel Select knob. The top button is the equivalent of turning the knob clockwise, and the bottom button is the equivalent of counterclockw...
Page 11 - Menu Controls, AUX Input; Configurator software (see; Using the T2 Configurator
IR Pass-Thru The mini jack labeled “IR pass-thru" mini connection is used for connecting forwarded IR signals to an audio component connected to the auxiliary audio input. Using the Aux. Input The T2 is equipped with an auxiliary audio input labeled “AUX IN.” This will accept an audio signal fro...
Page 12 - The NuVo amplified; XM Antenna Input
AM/FM Antenna Input The T2 ships with a proprietary active AM/FM antenna. This antenna is designed to work only with the NuVo T2 series AM/FM tuners. It can be located up to 200 feet from the tuner location, and we recommend 75-ohm RG 6 coaxial cable with a standard F style connector on each end. Si...
Page 13 - Proper Location of the XM Antenna; if you are in the extreme southern portion; Subscribing to XM Satellite Radio; are trademarks of XM Satellite Radio Inc.
Page 12 Proper Location of the XM Antenna Location of the XM antenna is critical to proper performance. There cannot be any obstructions between the antenna and the southern sky. This means that any possible interference from buildings, trees or other structures must be avoided. The most common loca...
Page 14 - Fig. 11 Menu Option Tree
II. Front Panel Menu Controls AM/FM The T2 has many settings available in the menus. This allows for specialized set up options for tuner operation. The menu is accessed from the front panel by pressing and holding the “MENU” button. Once in menu mode, you can scroll through the menu options by turn...
Page 15 - Advanced AM/FM Settings
The following menu selections are not necessary for standard tuner operation, but do provide a deeper level of control for those who need it. When you scroll to “Advanced Settings” in the menu, pressing the Select knob then accesses the following menu options: Operating Mode The T2 defaults to Stand...
Page 16 - Audio Settings; Bass output can be adjusted +12 dB or down
Audio Settings These selections are intended for AM, FM and XM stand-alone applications. They should be left at default settings for NuVo audio systems. These systems allow identical audio control on a per-zone basis. Bass EQ: Bass output can be adjusted +12 dB or down to 12 dB. The default setting ...
Page 17 - AUX Input; The T2 has an auxiliary audio input; Noise Blanking; The T2; Enabled; in order to listen to very distant, weak
AUX Input Disable/Enable: The T2 has an auxiliary audio input that allows access through either of the tuners to an additional audio source. To use this you must first enable the input in the menu options. AUX Gain: The audio input from an auxiliary source can be adjusted to match the output of the ...
Page 18 - III. Front Panel Menu Controls XM; OK
Page 17 III. Front Panel Menu Controls XM Most menu functions are identical to the AM/FM tuner with some exceptions. The menu functions specific to XM reception are outlined here. Signal Status: This function is important to XM signal reception. When the antenna is installed and plugged into the T2 ...
Page 19 - IV. Stand-alone Front Panel Use of the T2; Tuning a Desired channel:; Radio Data Service (RDS) Information and Display Modes
IV. Stand-alone Front Panel Use of the T2 Tuning a Desired channel: Pressing the Select knob cycles through the tuning modes. Step Tune Mode: Each of the T2's tuners default to step tune mode. When the Select knob is turned clockwise (CW), the tuner will tune within the preset tuning standard ( see ...
Page 20 - WXYZ; Source Switching; or
Actual use of these data fields is not regulated, and they may vary significantly in content between stations. If you choose not to have RDS information displayed, pressing the “Display” button will then indicate “RDS receive OFF”. In this state, Stereo indication and a signal strength indicator wil...
Page 21 - IV. Using the T2 with the Concerto NuVoNet; Setting Up the Tuner for NuVoNet
IV. Using the T2 with the Concerto NuVoNet Setting Up the Tuner for NuVoNet The T2 must be set for one of the Concerto source inputs 1-6. This can be done at the front panel when the tuner is first turned on, in the T2 Configurator software, or through the front panel advanced menu. The best way to ...
Page 22 - Direct Numeric Entry Tuning:
Making the Connection Prior to connecting to NuVoNet, the Concerto must have the correct Configuration version downloaded with the T2 representing two of the audio sources. Making the NuVoNet connection is done simply by connecting the “NuVoNet” output on the T2 to one of the “Peripheral Device” inp...
Page 23 - T2 AM/FM Configuration Software; After you have opened a configuration, name; NuVoNet Operating Mode:; This drop down menu allows you; NuVoNet Operating Mode
T2 AM/FM Configuration Software The T2 package includes a PC Windows based T2 Configurator setup software designed to quickly move you through the Tuners' setup options in a methodical fashion, and allow access to the more advanced setup features. Configurations are saved as files in the software's ...
Page 24 - Preset Information
2.2 Regional Setup 2.3 Brightness 2.4 Auto-On Page 23 2.2 Regional Setup: Depending on your geographic location, the tuner needs to be set for the proper tuning standard. The choices are USA and Canada, Western Europe, Australia, and New Zealand. Countries outside these geographic locations need the...
Page 26 - Some countries operate at a tuning; Tuning Parameters; When selected, Fine Tuning changes the; Advanced Settings
4.1 Custom Regional Setup Page 25 4.1 Custom Regional Setup: Some countries operate at a tuning standard outside the four preset regions. The Custom setting allows specific parameters. One determining factor for tuning is the “Pre-emphasis”. The two choices for this are 50µS (microseconds) and 75µS....
Page 27 - The T2 has an additional input that allows an; Advanced Presets; High-Cut is rarely used, but it can be a useful; Audio Output Level
4.5 AUX Input Page 26 4.5 AUX Input: The T2 has an additional input that allows an external device to be controlled through the T2's IR pass through. When this input is enabled, the level of the signal input can be adjusted up or down to match the tuners' signal output level. 5.0 Advanced Presets Th...
Page 29 - When the download is complete a; Successful Download; Troubleshooting; Symptom; Download Configuration:; The final step in the setup is to; Download Configuration
Page 28 7.2 Successful Download: When the download is complete a final window will appear indicating that all the information has downloaded successfully. Actual download time will vary based on your computer's processing capabilities. 7.2 Successful Download Troubleshooting Symptom I can't control ...
