Page 2 - ENGLISH; DURATION PER DAY (HOURS) 8 6 4 3 2 1; IMPORTANT SAFETY INSTRUCTIONS; CAUTION
ENGLISH DangerExposure to extremely high noise levels may cause a permanent hearing loss. Individuals vary considerably to noise induced hearing loss but nearly everyone will lose some hearing if exposed to sufficiently intense noise for a sufficient time. The U.S. Government's Occupational Safety a...
Page 4 - NV-T2DF Wiring Diagram; Diagram is shown with the NuVo Concerto System and NuVoNet.
L L O U T A U X I N R R T R I G G E RO N = + 1 2 V A U D I OO U T P U T T U N E R B T U N E R A O U T A U D I OO U T P U T R S 2 3 2 A N T E N N A I N P U T I N U S E O N LY N u Vo N V- T 2 PA SP O W E R E D A N T E N N A S Y S T E M T R I G G E RO N = + 1 2 V A U X I N M o d e l N V- T 2 D FD u a l...
Page 5 - Front Panel; be set up according to specific listening genres.
Front Panel 1. Stand-by LED: This LED (Light Emitting Diode) indicates that the T2 is plugged into an AC power source. 2. Remote Sensor: This IR (Infrared) receiver allows wireless remote control of the T2 functions. This IR input is active, even when it is used in conjunction with the direct IR inp...
Page 6 - Back Panel; Simplese, Essentia, and Concerto audio distribution systems.
Back Panel 1. Antenna Input: Coax “F” connector brings in the signal input from the NuVo NV-T2PAS antenna (pg. 10). 2. Aux. Input: This stereo RCA connector is enabled through the advanced menu options (pg. 14), and allows an additional audio source to be connected and accessed through the tuner sou...
Page 7 - NV-T2RC3 Remote Control; Power: The power button turns the selected tuner on and off.
NV-T2RC3 Remote Control 1. Power: The power button turns the selected tuner on and off. 2. Scroll Buttons: These buttons are the equivalent of turning the front panel Select knob. The top button is the equivalent of turning the knob clockwise, and the bottom button is the equivalent of counterclockw...
Page 9 - Menu Controls, AUX Input; Configurator software (see; Using the T2 Configurator
IR Pass-Thru The mini jack labeled “IR pass-thru" mini connection is used for connecting forwarded IR signals to an audio component connected to the auxiliary audio input. Using the Aux. Input The T2 is equipped with an auxiliary audio input labeled “AUX IN.” This will accept an audio signal fro...
Page 10 - Antenna Input; USB and RS232 Communication
Antenna Input The T2 ships with a proprietary amplified AM/FM antenna. This antenna is designed to work only with the NuVo T2 series tuners. It can be located up to 200 feet from the tuner location, and we recommend 75-ohm RG 6 coaxial cable with a standard F style connector on each end. Simply atta...
Page 11 - II. Front Panel Menu Controls
II. Front Panel Menu Controls The T2 has many settings available in the menus. This allows for many specialized set up options for basic tuner operation. The menu is accessed from the front panel by pressing and holding the “MENU” button. Once in menu mode, you can scroll through the menu options by...
Page 12 - Advanced Settings; Seek Threshold
The following menu selections are not necessary for standard tuner operation, but do provide a deeper level of control for those who need it. When you scroll to “Advanced Settings” in the menu, pressing the Select knob then accesses the following menu options: Operating Mode Concerto Source 1-6: Thi...
Page 13 - Audio Settings; Bass output can be adjusted +12 dB or down
Audio Settings These selections are intended for some stand-alone applications. They should be left at default settings for NuVo audio systems. These systems allow identical audio control on a per-zone basis. Bass EQ: Bass output can be adjusted +12 dB or down to 12 dB. The default setting is flat. ...
Page 14 - AUX Input; The T2 has an auxiliary audio input; Noise Blanking; The T2 default setting is to have noise; Enabled; . For areas of T2 operation having a; Disabled; in order to
AUX Input Disable/Enable: The T2 has an auxiliary audio input that allows access through either of the tuners to an additional audio source. To use this you must first enable the input in the menu options. AUX Gain: The audio input from an auxiliary source can be adjusted to match the output of the ...
Page 15 - III. Stand-alone Front Panel Use of the T2; Tuning a Desired Station:; keys.” This will scroll to the; Direct Numeric Tuning:; Radio Data Service (RDS) Information and Display Modes
III. Stand-alone Front Panel Use of the T2 Tuning a Desired Station: Pressing the Select knob cycles through the tuning modes. Step Tune Mode: Each of the T2's tuners default to step tune mode. When the Select knob is turned clockwise (CW), the tuner will tune within the preset tuning standard ( see...
Page 16 - WXYZ; Source Switching; or
Actual use of these data fields is not regulated, and they may vary significantly in content between stations. If you choose not to have RDS information displayed, pressing the “Display” button will then indicate “RDS receive OFF”. In this state, Stereo indication and a signal strength indicator wil...
Page 17 - IV. Using the T2 with the Concerto NuVoNet; Setting Up the Tuner for NuVoNet
IV. Using the T2 with the Concerto NuVoNet Setting Up the Tuner for NuVoNet The T2 must be set for one of the Concerto source inputs 1-6. This can be done at the front panel when the tuner is first turned on, in the T2 Configurator software, or through the front panel advanced menu. The best way to ...
Page 18 - Direct Numeric Entry Tuning:
Operating the T2 with the Concerto Display Pad By following the previous steps you should now be able to operate the T2 from any of the Concerto Display Pads. The Concerto Display Pads have secondary tuner functions silk-screened on the bezel below the associated keys. They appear under the appropri...
Page 19 - T2 Configuration Software; After you have opened a configuration, the next step is the; NuVoNet Operating Mode:; This drop down menu allows you; NuVoNet Operating Mode
T2 Configuration Software Basic setup and operation of the T2 is easily done from the front panel, the included T2RC3 remote, or the Concerto Display Pad. The T2 package includes the T2 Configurator setup software designed to quickly move you through the Tuners' setup options in a methodical fashion...
Page 20 - Preset Information
2.2 Regional Setup 2.3 Brightness 2.4 Auto-On Page 20 2.2 Regional Setup: Depending on your geographic location, the tuner needs to be set for the proper tuning standard. The choices are USA and Canada, Western Europe, Australia, and New Zealand. Countries outside these geographic locations need the...
Page 22 - Some countries operate at a tuning; Tuning Parameters; When checked, Fine Tuning changes the; Audio Output Level
4.1 Custom Regional Setup Page 22 4.1 Custom Regional Setup: Some countries operate at a tuning standard outside the four preset regions. The Custom setting allows specific parameters. One determining factor for tuning is the “Pre-emphasis”. The two choices for this a are 50µS (microseconds) and 75µ...
Page 23 - Advanced Presets
4.5 AUX Input Page 23 4.5 AUX Input: The T2 has an additional input that allows an external device to be controlled through the T2's IR pass through. When this input is enabled, the level of the signal input can be adjusted up or down to match the tuners' signal output level. 5.0 Advanced Presets Th...
Page 24 - Download Configuration:; The final step in the setup is to; Download Configuration
Page 24 6.1 Categories Tab 6.2 FM Freqs: This tab lists all the available frequencies within the FM band. When highlighted, the Frequency Information on the right side of the tab allows you to name and categorize each desired frequency in up to four different categories. The Category drop down menus...
Page 25 - When the download is complete a; Successful Download; NV-T2DF Specifications; FM Section; Audio Section
Page 25 7.2 Successful Download: When the download is complete a final window will appear indicating that all the information has downloaded successfully. Actual download time will vary based on your computer's processing capabilities. 7.2 Successful Download NV-T2DF Specifications FM Section AM Sec...
