Nutone WS130AA - Manual

Nutone WS130AA

Nutone WS130AA – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
Page: / 12

Table of Contents:

  • Page 2 – PREPARE HOOD LOCATION
  • Page 3 – PREPARE THE HOOD
  • Page 4 – CONNECT WIRING
  • Page 5 – OPERATION
  • Page 6 – WARRANTY; SERVICE PARTS
  • Page 7 – ADVERTENCIA; LEA Y CONSERVE ESTAS INSTRUCCIONES; A la persona que realiza la instalación: Deje; PRECAUCION; CAMPANA EXTRACTORA; Página 7; CAMPANA; PARA COCINAR DOMÉSTICO SOLAMENTE.
  • Page 8 – Página 8; PREPARACIÓN DEL LUGAR DONDE
  • Page 9 – Página 9
  • Page 10 – CONEXIÓN ELÉCTRICA; PREPARACIÓN DE LA CAMPANA
  • Page 11 – OPERACIÓN
  • Page 12 – PIEZAS DE SERVICIO; GARANTIA
Loading the manual

Page 1

ALLURE™ WS1 SERIES

RANGE HOOD

!

WARNING

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO

PERSONS, OBSERVE THE FOLLOWING:

1. Use this unit only in the manner intended by the manufacturer. If you have

questions, contact the manufacturer at the address or telephone number

listed in the warranty.

2. Before servicing or cleaning unit, switch power off at service panel and

lock the service disconnecting means to prevent power from being

switched on accidentally. When the service disconnecting means cannot

be locked, securely fasten a prominent warning device, such as a tag, to

the service panel.

3. Installation work and electrical wiring must be done by a qualified

person(s) in accordance with all applicable codes and standards, includ-

ing fire-rated construction codes and standards.

4. Sufficient air is needed for proper combustion and exhausting of gases

through the flue (chimney) of fuel burning equipment to prevent backdraft-

ing. Follow the heating equipment manufacturer’s guideline and safety

standards such as those published by the National Fire Protection As-

sociation (NFPA), and the American Society of Heating, Refrigeration and

Air Conditioning Engineers (ASHRAE), and the local code authorities.

5. When cutting or drilling into wall or ceiling, do not damage electrical wiring

and other hidden utilities.

6. To reduce the risk of fire or electric shock, do not use this range hood

with an additional speed control device.

7. Ducted fans must always be vented to the outdoors.
8. To reduce the risk of fire, use only metal ductwork.
9. Use with approved cord-connection kit only.
10.This unit must be grounded.

TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:

1. Never leave surface units unattended at high settings. Boilovers cause

smoking and greasy spillovers that may ignite. Heat oils slowly on low

or medium settings.

2. Always turn hood ON when cooking at high heat or when cooking flaming

foods.

3. Clean ventilating fans frequently. Grease should not be allowed to

accumulate on fan or filter.

4. Use proper pan size. Always use cookware appropriate for the size of

the surface element.

TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF A

RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING:*

1. SMOTHER FLAMES with a close-fitting lid, cookie sheet, or metal tray,

then turn off the burner. BE CAREFUL TO PREVENT BURNS. If the

flames do not go out immediately, EVACUATE AND CALL THE FIRE

DEPARTMENT.

2. NEVER PICK UP A FLAMING PAN — You may be burned.
3. DO NOT USE WATER, including wet dishcloths or towels - violent steam

explosion will result.

4. Use an extinguisher ONLY if:

A. You know you have a Class ABC extinguisher and you already know

how to operate it.

B. The fire is small and contained in the area where it started.
C. The fire department is being called.
D. You can fight the fire with your back to an exit.
* Based on “Kitchen Fire Safety Tips” published by NFPA.

ALLURE

WS1 SERIES

RANGE HOODS

READ AND SAVE THESE INSTRUCTIONS

Installer: Leave this manual with

the homeowner.
Homeowner: Operating and

Cleaning information on page 5.

Page 1

CAUTION

1. For general ventilating use only. Do not use to exhaust hazardous or

explosive materials and vapors.

2. To avoid motor bearing damage and noisy and/or unbalanced impellers,

keep drywall spray, construction dust, etc. off power unit.

3. For best capture of cooking impurities, your range hood should be

mounted so that the top of the hood is 24-30” above the cooking surface.

4. Please read specification label on product for further information and

requirements.

TABLE OF CONTENTS

This manual is divided into sections as follows:

“PREPARE HOOD LOCATION”

Run ductwork from roof or wall cap, and electrical wiring from service

panel - to installation location

“PREPARE THE HOOD”

Get your hood ready for installation

“CONNECT WIRING”

Make electrical wiring connections to hood

“INSTALL HOOD”

Secure hood to cabinet and ductwork - install bulbs and filters

“OPERATION”

How to use the hood controls

“CLEANING”

Keep your hood in top working condition

“SERVICE PARTS”

Part numbers and exploded view of hood components

“WARRANTY”

One-year limited warranty and how to contact us

NOTE

If hood is to be installed Non-Ducted:

Purchase a set of (2) non-ducted filters from your

local distributor or retailer and attach them to the

aluminum mesh filters.

Patent No.:
US D450, 829 S

!

FOR DOMESTIC COOKING ONLY

!

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - PREPARE HOOD LOCATION

Page 2 ALLURE™ WS1 SERIES RANGE HOOD CABINET BOTTOM CABINET FRONT HORIZONTAL DUCT ACCESS HOLE 5¼" 5¼" 7½" 1/8 " ¾" 13 15/16 " (30" hood) 16 15/16 " (36" hood) 13 15/16 " (30" hood) HOOD MOUNTING SCREWS (4) ELECTRICAL ACCESS HOLE (in wall) 3¾" 16 15/16 ...

Page 3 - PREPARE THE HOOD

Page 3 ALLURE™ WS1 SERIES RANGE HOOD PREPARE THE HOOD PREPARE THE HOOD 3 Remove Damper/Duct Connector from inside the hood. Set connec- tor aside - with mounting screws and parts bag. 4 Remove Wir- ing Cover from inside the hood. Set cover and mounting screw aside. 5 Remove either top or back wir- i...

Page 4 - CONNECT WIRING

Page 4 ALLURE™ WS1 SERIES RANGE HOOD CONNECT WIRING WARNING: To reduce the risk of electric shock, make sure power is switched off at the service panel. Lock or tag service panel to prevent power from being switched on accidentally. HOUSE WIRING (120 VAC) CARDBOARD (Use to protect cooktop) 1 Connect...

Other Nutone Models