Nutone VS-89 - Manual
Nutone VS-89 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
READ AND SAVE THESE
INSTALLATION INSTRUCTIONS!
Accessory
Switch
MODEL:VS-89
INSTALLATION
Used with Vent–Light–Night Light
Combination.
1. Install a double–gang box.
2.
Refer to Figure 1.
Run power wiring
from fuse box or circuit breaker and
wiring from heat–vent–light wires to
outlet box.
3. Secure all wires to outlet box with an
approved box connector.
4. Dress all leads, leaving
approximately 1/2" of bare wire for
making connections.
5.
Refer to Figure 1.
Make wire
connections. Observe cover plate
markings (Vent–Light–Night Light) when making connections. Make sure
that the switch and the unit it controls are properly grounded.
6.
Refer to Figure 2.
Using two supplied screws, secure switch bracket
assembly to outlet box adapter plate.
7. Position wall plate over switch assembly and secure with supplied screws.
FIGURE 1
FIGURE 2
HOT (Light)
HOT (Vent)
HOT (Night Light)
COMMON
TO UNIT
VENT
NIGHT
LIGHT
LIGHT
WHITE
BLACK
TO 120vAC, 60Hz
HOUSE POWER
TO UNIT
ADAPTER
PLATE
2 GANG
BOX
TO 120vAC,
60Hz HOUSE POWER
USE A SINGLE-GANG BOX
ADAPTER PLATE TO COVER
DOUBLE GANG BOX.
ADAPTER PLATE NOT
SUPPLIED WITH SWITCH.
READ AND SAVE THESE
INSTALLATION INSTRUCTIONS!
Accessory
Switch
MODEL:VS-89
INSTALLATION
Used with Vent–Light–Night Light
Combination.
1. Install a double–gang box.
2.
Refer to Figure 1.
Run power wiring
from fuse box or circuit breaker and
wiring from heat–vent–light wires to
outlet box.
3. Secure all wires to outlet box with an
approved box connector.
4. Dress all leads, leaving
approximately 1/2" of bare wire for
making connections.
5.
Refer to Figure 1.
Make wire
connections. Observe cover plate
markings (Vent–Light–Night Light) when making connections. Make sure
that the switch and the unit it controls are properly grounded.
6.
Refer to Figure 2.
Using two supplied screws, secure switch bracket
assembly to outlet box adapter plate.
7. Position wall plate over switch assembly and secure with supplied screws.
FIGURE 1
FIGURE 2
HOT (LIGHT)
HOT (VENT)
HOT (Night
Light)
COMMON
TO UNIT
VENT
NIGHT
LIGHT
LIGHT
WHITE
BLACK
TO 120vAC, 60Hz
HOUSE POWER
TO UNIT
ADAPTER
PLATE
2 GANG
BOX
TO 120vAC,
60Hz HOUSE POWER
USE A SINGLE-GANG BOX
ADAPTER PLATE TO COVER
DOUBLE GANG BOX.
ADAPTER PLATE NOT
SUPPLIED WITH SWITCH.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
