Nutone LA310CY - Manual
Nutone LA310CY – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – REPLACING EXISTING 2-NOTE CHIME; One Year Limited Warranty
- Page 3 – INSTALACIÓN; Pase los cables eléctricos a través del orificio u orificios de; TIMBRE DE PUERTA; NO ENGRASE LOS PULSADORES DE LOS TIMBRES.; dejará una superficie seca.; CABLEADO RECOMENDADO PARA CONSTRUCCIONES NUEVAS; no se usan
- Page 4 – REEMPLAZO DEL TIMBRE EXISTENTE DE 2 NOTAS; transformador modelo C907.
INSTALLATION
ALL ELECTRICAL WORK MUST BE DONE IN ACCOR-
DANCE WITH LOCAL AND/OR NATIONAL ELECTRICAL
CODE AS APPLICABLE.
TURN OFF POWER AT SERVICE ENTRANCE BEFORE
INSTALLING, WIRING, OR SERVICING THIS PRODUCT.
1. Hold chime mechanism against wall and mark four (4)
mounting holes.
2. Drill 3/16” holes where marked and tap in wall anchors
from parts bag.
3. Bring wiring through access hole(s) in chime mechanism
backplate.
4. Loosely attach chime mechanism to wall with screws
from parts bag.
5. Tighten screws securely.
6. Connect wires to appropriate terminals.
7. Install two (2) alkaline 9-volt batteries, if appropriate for
your application. Turn on power at service entrance.
Make sure pushbuttons operate chime properly. (Ad-
just switch on circuit board for 4 or 8 chime tones at
front door. Side and rear doors will have 1 chime tone
each.)
8. Hook cover over chime mechanism.
THREE-NOTE
DOOR CHIME
READ AND SAVE THESE INSTRUCTIONS
battery
holders
wiring
access
hole
mounting
holes
DO NOT OIL CHIME PLUNGERS.
Oil will cause them to stick during operation. If plungers fail to operate freely due to accumulation of dust,
cooking grease, etc., clean with a non-flammable cleaning solvent which will evaporate, leaving a dry
surface.
RECOMMENDED NEW CONSTRUCTION WIRING
F
S
R
1
2
3
Lighted or
Unlighted Buttons
Front
Side
Rear
Ground
120 VAC
16 VAC
Transformer
NOT USED
Volume Control
9-volt
batteries
not used
OPTIONAL: 2 or 3 chimes can be connected to a single transformer. 2 chimes
require transformer Model C909 or C907. 3 chimes require transformer Model C907.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
REPLACING EXISTING 2-NOTE CHIME F S R 1 2 3 Lighted or Unlighted Buttons 9V 9V Front Side Rear Ground 120 VAC 16 VAC Transformer Requires Two 9-volt Batteries NOT USED Volume Control OPTIONAL: 2 or 3 chimes can be connected to a single transformer. 2 chimes require transformer Model C909 or C907. 3 ...
INSTALACIÓN TODO TRABAJO ELÉCTRICO DEBE REALIZARSE DE CONFOR- MIDAD CON EL CÓDIGO ELÉCTRICO LOCAL Y/O NACIONAL SEGÚN SEA APLICABLE.APAGUE EL SUMINISTRO ELÉCTRICO EN LA ENTRADA DEL SERVICIO ANTES DE INSTALAR, CABLEAR O DAR SERVICIO A ESTE PRODUCTO.1. Ponga el mecanismo del timbre en la pared y marque...
AISLANTE SUPERIOR DE BARRA DEL TIMBRE ABERTURA EN U PORTABARRA DEL TIMBRE AISLANTE INFERIOR DE BARRA DEL TIMBRE SOPORTE TAPÓN SUPERIOR DEL TUBO DEBE PODER HABER UN LIGERO MOVIMIENTO ASCENDENTE Y DESCENDENTE 1. El aislante superior de barra del timbre debe asentarse completa mente en la abertura en U...
