Nutone LA-207TWH - Manual
Nutone LA-207TWH – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
INSTALLATION & OPERATING INSTRUCTIONS
READ & SAVE THESE INSTRUCTIONS!
®
Wireless Pushbutton
Model: LA-207TWH
FIGURE 2
COVER
FIGURE 3
MOUNTING THE PUSHBUTTON
Refer to Figures 1 and 2.
1. Locate the pushbutton next to or near the door.
Do not mount the pushbutton
on a metal surface. Caution: Some stucco houses have metal mesh in the
wall structure which will affect the wireless chime performance.
Experiment with various positions of receiver with respect to the
pushbutton to determine the location that gives best performance before
mounting permanently. If not satisfied, use a wired chime.
2. Remove the pushbutton cover by inserting the tip of a screwdriver in the slot at
the bottom of the pushbutton and then gently rock the pushbutton cover apart
from the pushbutton base.
3. Choose a level place to locate the pushbutton base.
4. Position the pushbutton base, and mark the mounting surface with a pencil
through the two holes in the pushbutton.
5. Drill two
3
⁄
16
" diameter holes at the previously marked area.
6. Insert the plastic anchors into the
3
⁄
16
" diameter holes.
7. Place pushbutton base over anchors, and fasten with two screws provided.
Do not replace cover at this time.
8. Apply a small amount of caulking to the mounting screw holes on the base for
waterproofing.
PUSHBUTTON SECURITY CODING
Refer to Figure 3.
It is not necessary to change the security code of the pushbutton unless you
experience interference from other wireless devices.
1. To change the security code, remove any combination of the six plastic jumper
straps.
2.
NOTE: Both the pushbutton and receiver codes must match.
BATTERY INSTALLATION
Refer to Figure 3.
1. Position the A23 12 volt battery as illustrated.
Be sure to observe polarity
(+/–).
For replacement battery, use EverReady
®
A23BP or Duracell
®
MN21B
(or equivalent).
INSTALLING PUSHBUTTON COVER
1. Position the pushbutton cover over the pushbutton base so that the “lip” on
the base engages into the “slot” on the cover. Make sure the rubber gasket is
properly seated. Firmly press cover until it snap fits over the base.
SLOT
DO NOT MOUNT ON
METAL SURFACE
LIP
MOUNTING
SCREWS
WATERPROOF
GASKET
BASE
WOODEN WALL OR
DOOR FRAME
PLASTIC
WALL
ANCHORS
TOP
P.C. BOARD
BATTERY
LOCATION
SECURITY CODE
SETTING
FIGURE 1
TO OPEN
COVER “PUSH”
SLOT
Congratulations on your purchase of a NuTone wireless chime. The chime
operates by radio frequency signal transmitted by the pushbutton and
received by the chime. The pushbutton/transmitter is mounted at the door.
The receiver may be located anywhere in your home within 100 feet
( 3 0 m e t e r s ) o f t h e p u s h b u t t o n . T h e p u s h b u t t o n / t r a n s m i t t e r c a n b e
programmed to sound one of three chime sounds. This feature allows up
to three pushbuttons to generate three different chime sounds.
WESTMINSTER
TWO
NOTE
ONE
NOTE
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
