Nutone CI-365 - Manual
Nutone CI-365 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Refer to Figure 2; IF ACCESS CANNOT BE MADE FROM BELOW; Provide slack in low voltage lines for future connection.; FIGURE 2
- Page 3 – Refer to Figure 3; VacPanTM should be located tight to one side in stud space.; Refer to Figure 4; FIGURE 3
- Page 4 – FIGURE 5
READ INSTRUCTIONS BEFORE INSTALLATION
IMPORTANT NOTES:
1. For maximum clearance under cabinets use 2
1
/
2
" X 3
1
/
2
" short 90° elbow.
2. Check for an air tight seal at VacPan™ and elbow prior to installation.
3. If required, use Teflon tape to make air tight seal but do not use glue.
4. Make certain clearance is available in kick space prior to installation under cabinets.
5. Use central vacuum cover plate or double electrical blank plate for access cover when required.
6. Allow
1
/
2
" play in vacuum pipe at location of VacPan™ so that fitting connection can be lifted to install or remove
VacPan™.
INSTALLATION INSTRUCTIONS
READ & SAVE THESE INSTRUCTIONS!
VacPan
™
Automatic Dustpan Inlet
MODEL: CI-365
FIGURE 1
BRASS TERMINAL
CONTACT
SPRING TERMINAL
CONTACT
DO NOT GLUE
MADE IN CANADA
U.S. P
ATENT PENDING
CANADIAN P
ATENT PENDING
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
INSTALLATIONOPTION #1 - UNDER CABINET ACCESS TO PIPING FROM BELOW Refer to Figure 2 1. Select a location under cabinet for VacPan™ (6) so that new fittings can be connected to existing pipe. Drill small reference hole under location of VacPan™ to determine position in basement or crawl space. 2. Usi...
INSTALLATIONOPTION #2 - IN WALLS ALONG BASE BOARDS Refer to Figure 3 (ACCESS TO PIPING FROM BELOW) 1. Locate studs (1) in the wall at the location VacPan™ will be installed. 2. VacPan™ should be located tight to one side in stud space. 3. Drill a small reference hole (2) through the floor under area...
INSTALLATION NEW HOME CONSTRUCTION Refer to Figure 5 1. Cut out wall plate (9) between two studs at the location of VacPan™. Cut a 6 3/4" piece of wall plate and refasten to floor temporary rough-in block. (10) This will act as temporary rough-in block that will force all trades to finish around...
