Nutone 665RF - Manual
Nutone 665RF – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – WIRING; DUCTING; MOUNTING REFLECTOR AND GRILLE
- Page 3 – One Year Limited Warranty
- Page 4 – PARTS LIST
INSTALLATION INSTRUCTIONS
READ & SAVE THESE INSTRUCTIONS!
Heat-A-Ventlite
®
Combination
MODEL: 665RF
TYPE IC
suitable for use under thermal insulation
LOCATION
1. Mount heater to ceiling joists, or if necessary, to a header
installed between joists.
2.
Caution: Do not mount heater closer than 12" to a
vertical surface. Do not mount over tub or in shower
enclosure.
3. Installation in existing construction requires an accessible
area above the desired location. Make sure that wiring can
be run to the location.
MOUNTING HEATER HOUSING
NEW CONSTRUCTION
FIGURE 1
Using Hanger Bars
Refer to Figure 1.
1. Insert hanger bars in slots provided in housing.
2. Locate heater housing between joists so that bottom of heater housing is even with the planned finished ceiling.
3. Use screws or nails (not provided) to secure hanger bars to ceiling joists.
Using Side Mounting Tabs
1. Locate heater housing next to ceiling joist.
2. Use wood screws (not provided) through keyhole slots in mounting tabs to loosely attach housing to ceiling joist.
3. Adjust housing so that it will be flush with the finished ceiling. When housing is properly adjusted, tighten screw in slots to
secure housing.
EXISTING CONSTRUCTION
1. Determine desired location for heater.
2. Drill a small hole through the ceiling at the desired location and stick a coat hanger or stiff wire through hole into attic to help
find the location from above.
3. Check the area above to make sure that wiring can be installed and that the installation will not interfere with existing
electrical wiring.
4. From above, place the housing between ceiling joists at the desired location. Using the housing as a template, mark the area
to be cut out along the bottom flange of the housing.
5. After making the cutout, install the housing in the opening using the hanger bars or mounting tabs as described above. Make
sure that the bottom of the housing is flush with the bottom of the finished ceiling.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
HEATER JUNCTION BOX LIGHTRECEPTACLE W H I T E WHITE RED GREEN WA L L S W I T C H B O X W H I T E BLACK 120VAC LINE SUPPLYGROUND LIGHT H E AT VENT W H I T E B LACK B LUE V E N T R E C E P TA C L E HEATRECEPTACLE (WHITE) FIGURE 2 WIRING All wiring must comply with local and national codesand unit must...
Product specifications subject to change without notice. 4820 Red Bank Road, Cincinnati, Ohio 45227 Printed in U.S.A., Rev. 3/2001, Part No. 88576 One Year Limited Warranty WARRANTY OWNER: NuTone warrants to the original consumer purchaser of its products that such products will be free from defects...
1 2 4 3 6 7 8 9 10 HEATER ASSEMBLY 16 17 18 19 5 11 VENT ASSEMBLY 14 13 12 15 20 21 665RF HEATER APRIL 1998 EFFECTIVE DATE PRODUCT GROUP MODEL NUMBER PARTS LIST NOTE: Always order by current part number NuToneAttn: Parts Department4820 red Bank RoadCincinnati, OH 45227-1599Phone: (513) 527-5426Fax: ...
