Numark MPCD33 - Manual

MPCD33 SETUP and CONNECTIONS Typical connection with a mixer is illustrated below. 1. Mount the units in your console or rack with 19” EIA rails. 2. The transport should be mounted not to exceed an angle of 15 degrees. 3. Your CD player can be affected by excess vibration so mount the units in a sec...

MPCD33 FRONT PANEL FEATURES 1. Open/Close: Press to load or eject the disc. The tray will not open if a disc is in play. The tray door will automatically close in 30 seconds if left open. This is to protect the tray from accidental damage while open. 2. Single: Toggles the unit to play back just one...

MPCD33 Pitch Bend Function: allows the user to temporarily change the speed of the music to align beats. When the beats of the music of the CD you wish to match is fast compared to the tempo of the other music, rotate the jog wheel counter clockwise (to the left). When the CD is behind, rotate the j...

MPCD33 REAR PANEL FEATURES 22. Control Cable Connector- Plug in the 8-pin cable included in here to connect the remote control and main CD unit together 23. IEC Power Plug Connector - Plug your supplied power cord in here. 24. Voltage Selector - Set this switch to the voltage for your location. 25. ...

MPCD33 MP3 AUDIO PLAYBACK REQUIREMENTS While playing MP3 music, please note the following points. It is assumed that the user of this unit understands how to properly burn a CDR and add MP3 files to it. Many different variations MP3 audio are available from various sources and computer programs. Ple...

MPCD33 DESCRIPTION OF THE PLAY/PAUSE AND CUE OPERATIONS PLAY and CUE Pressing the “PLAY/PAUSE” button starts the disc. Pressing the “CUE” button will reset the disc to the last place where the disc was started. This is called the cue point. By alternately pressing the “PLAY/PAUSE” button and the “CU...

MPCD33 MATCHING THE BEATS PER MINUTE (BPM) Match the tempo by monitoring the music of both PLAYER 1 and PLAYER 2 by ear and adjusting the pitch. When the tempo of the music of the selected CD player is slow compared to the tempo of the other player, move the slider to the “+” side and match the temp...

MPCD33 EXAMPLE OF MIXING USING TWO CD PLAYERS While playing a disc on PLAYER 1 load a disc into PLAYER 2 and select your next track, match its pitch to the track playing on PLAYER1 and when you are ready use the crossfader on your mixer to fade from PLAYER 1 to PLAYER 2. Load a disc in PLAYER 1 and ...

MPCD33 FADER START Fader Start is achievable by attaching your CD player to a similarly equipped DJ mixer and setting the rear panel selection switch to “mixer” mode. 1. Connect cables between the CD player and your DJ mixer. 2. Press the button or switch on your mixer into fader start mode to activ...

MPCD33 TROUBLESHOOTING: Symptom Possible Cause Corrective Action The power fails to switch on when the POWER switch is set to on Poor power plug connection at the AC outlet or IEC Power cord loose from rear of unit Insert the power plug firmly into the AC outlet and make sure connection is good in u...

® Professional Disc Jockey Products LIMITED PRODUCT WARRANTY 1. What is covered and for how long? NUMARK INDUSTRIES LCC ("NUMARK") warrants to the original purchaser that NUMARK'S DJ Mixers, Amplifiers, CD players, turntables, preamplifiers, beatkeepers, equalizers, microphones, headphones, ...