Page 2 - User Manual; Introduction to Nokia MW1122; Figure 1
E Copyright Nokia Networks Oy C33902002SE_00 1 MW1122 ADSL/WLAN Router User Manual 05.07.2000 C33902.21 A0 1 Introduction to Nokia MW1122 Nokia MW1122 is an integrated ADSL (Asymmetric DigitalSubscriber Line) bridge and router which enables high-speed Internetaccess from your wireless (WLAN) and Eth...
Page 3 - Interfaces; Figure 2; Indicator lights
MW1122 User Manual E Copyright Nokia Networks Oy C33902002SE_00 2 2 Installing MW1122 Before you install MW1122 you may want to familiarise yourself withthe interfaces and indicator lights of MW1122. From section 2.3 youwill find a step-by-step installation procedure, which shows thephysical install...
Page 4 - Figure 3
E Copyright Nokia Networks Oy C33902002SE_00 3 Figure 3 MW1122 front panel indicators DSL GREEN Off ADSL link is down. Blinks ADSL connection is being established. On ADSL link is up. ETH GREEN Off Ethernet is down. On 10Base-T Ethernet is functional Blinks Receives traffic from Ethernet. COL GREEN ...
Page 6 - Connect the 6-pin ADSL line cable between the ADSL connector; Figure 4; MW1122 and splitter connected
E Copyright Nokia Networks Oy C33902002SE_00 5 7. Connect the 6-pin ADSL line cable between the ADSL connector on the MW1122 back panel and your ADSL line wall socket. Ifyou want to use telephone and data services simultaneouslyconnect a splitter according to Figure 4. After a while, the DSLindicato...
Page 7 - Browser management; Note; Opening a connection; To open a connection to the Nokia MW1122:
MW1122 User Manual E Copyright Nokia Networks Oy C33902002SE_00 6 connected to the ETH port of MW1122. In this case the ETH indicatorshould be lit. 3.1 Browser management You can use your PC’s web browser software to access the webconfiguration pages in MW1122. To access the web pages you mustknow t...
Page 8 - Figure 5; Main Page
E Copyright Nokia Networks Oy C33902002SE_00 7 3.1.2 Main Page Main Page is shown first when you use a web browser to connect toMW1122.The list on the left shows the current page highlighted.Clicking an item on the list (Wireless LAN, WLAN Clients, ServiceProviders, Local Network, Statistics, Restar...
Page 9 - Wireless LAN page
MW1122 User Manual E Copyright Nokia Networks Oy C33902002SE_00 8 The Main Page shows you the statuses of the DSL line, Ethernetinterface, and wireless LAN interface. It also shows the number ofwireless LAN clients on your network, wireless LAN network nameand the channel in use. Software and hardwa...
Page 10 - Europe
E Copyright Nokia Networks Oy C33902002SE_00 9 Set Regulatory domain according to your location of use. TheRegulatory domain setting affects the available Radio channels. Theradio channels corresponding to the regulatory domains are: Europe 1...13 Canada 1...11 USA 1...11 Japan 14 Change Transmit po...
Page 11 - WLAN Clients page; Enabling access control
MW1122 User Manual E Copyright Nokia Networks Oy C33902002SE_00 10 3.1.4 WLAN Clients page On the WLAN Clients page you can enable access control based on theMAC addresses of your wireless LAN clients. When access control isenabled, only the wireless stations on the Client table are allowedaccess to...
Page 12 - Encrypting wireless connection; If you want to activate WEP, you have two options:
E Copyright Nokia Networks Oy C33902002SE_00 11 lower case characters only when typing the MAC address. You mustidentify the wireless station by filling the Name field. Activate theClient table by selecting Client table MAC address from the Admissionmethod pull-down list and clicking the Apply butto...
Page 14 - Figure 8; WLAN Clients page and default key encryption
E Copyright Nokia Networks Oy C33902002SE_00 13 Note When you click the Apply button, the WLAN settings become active.If you have enabled the access list or changed the encryption mode andyou are accessing MW1122 through the wireless link, the connectionwill be lost. You must reconfigure the wireles...
Page 15 - Figure 9
MW1122 User Manual E Copyright Nokia Networks Oy C33902002SE_00 14 Figure 9 WLAN Clients page and station-specific keyencryption
Page 16 - Service Providers pages; Service Provider page with PPP configuration
E Copyright Nokia Networks Oy C33902002SE_00 15 3.1.5 Service Providers pages The Service Providers page can be used to set authentication for ATMVCCs with PPP encapsulation (Figure 10). You can set theAuthentication method and the corresponding Username andPassword. You can also view Network connec...
Page 17 - Service Providers page with PPTP configuration
MW1122 User Manual E Copyright Nokia Networks Oy C33902002SE_00 16 Figure 11 Service Providers page with PPTP configuration
Page 18 - Local Network pages
E Copyright Nokia Networks Oy C33902002SE_00 17 3.1.6 Local Network pages The Local Network page as four sub pages: Local ports, DHCP, NAPT,and Routing. Local ports On the Local Network Local Ports sub page you can assign IPaddresses to Ethernet and wireless LAN ports. If you set Physical LANinterfa...
Page 19 - DHCP; Start address is the interface IP address
MW1122 User Manual E Copyright Nokia Networks Oy C33902002SE_00 18 DHCP On the Local Network DHCP subpage you can enable/disableDynamic Host Control Protocol and set the Address ranges fromwhich the addresses are distributed to the DHCP clients on yournetwork. You can also set the Domain Name Server...
Page 20 - Local Network DHCP page
E Copyright Nokia Networks Oy C33902002SE_00 19 Figure 13 Local Network DHCP page
Page 21 - NAPT; Local Network NAPT page
MW1122 User Manual E Copyright Nokia Networks Oy C33902002SE_00 20 NAPT If Network Address Port Translation (NAPT) has been activated,servers on your local network are not visible outside your network. OnNAPT page, you can configure pinholes through which you canprovide outside access to your web se...
Page 22 - Routing page; Local Network Routing page
E Copyright Nokia Networks Oy C33902002SE_00 21 Routing page On the Local Network Routing sub page you can set static routes andenable/disable dynamic routing protocols (Routing InformationProtocol version 1 and 2). To enable dynamic routing to a particular interface select the Routingprotocol versi...
Page 23 - Statistics page
MW1122 User Manual E Copyright Nokia Networks Oy C33902002SE_00 22 3.1.7 Statistics page The Statistics page lets you view a selection of MW1122 statistics. toview statistics of a particular function, click the corresponding buttonand the statistics view is opened on a separate window. Figure 16 Sta...
Page 24 - Restart page; On the Restart page, you can reset subsystems and restart MW1122.
E Copyright Nokia Networks Oy C33902002SE_00 23 3.1.8 Restart page On the Restart page, you can reset subsystems and restart MW1122. Figure 17 Restart page
Page 25 - Save Config page; Features; MW1122 has the following interfaces:
MW1122 User Manual E Copyright Nokia Networks Oy C33902002SE_00 24 3.1.9 Save Config page When you change the configuration, all configuration changes areactivated immediately without restart/reload. However, theconfiguration will not be saved into the nonvolatile memory. IfMW1122 is restarted or po...
Page 26 - MW1122 can operate in four different main modes:; LAN and WLAN interfaces
E Copyright Nokia Networks Oy C33902002SE_00 25 D Gateway/bridge management interface. This interface is used as abridge host interface or gateway interface depending on theoperation mode. In this manual it is called VBRIDGE. On theMW1122 web pages, the interface is called gateway or bridge IPinterf...
Page 27 - Data VCC operation; Routing
MW1122 User Manual E Copyright Nokia Networks Oy C33902002SE_00 26 connections are used for routing IP traffic, the VBRIDGE interfacemust be used instead of LAN/WLAN IP addresses. Alternatively, thisinterface is used in bridge only application when the IP address isrequired for remote management pur...
Page 28 - Network Address Port Translation; Principle of Network Address Port Translation
E Copyright Nokia Networks Oy C33902002SE_00 27 interface and each ATM VCC interface. Optionally, the bridgingbetween the VCCs can be disabled. 4.4 Network Address Port Translation MW1122 supports Network Address Port Translation (NAPT) forTCP/IP, UDP/IP and ICMP/IP protocols. When NAPT is used, a s...
Page 29 - Dynamic Host Configuration Protocol
MW1122 User Manual E Copyright Nokia Networks Oy C33902002SE_00 28 Application Layer Gateway functionality (ALG). MW1122 has ALGfor the following protocols/applications: D ICMP D FTP D H.323 including NetMeeting D CUSeeMe D PPTP D IRC D IPSEC ESP tunnel mode and IKE Note, that most IPSEC implementat...
Page 30 - Automatic, chooses the first free VCC
E Copyright Nokia Networks Oy C33902002SE_00 29 MW1122 supports both G.992.1 and G.992.2 ADSLrecommendations defined by ITU-T. Rate adaptation is done in steps of 32 kbit/s. The ADSL interface ofMW1122 functions completely automatically and all configurationrelated to the ADSL connection is done at ...
Page 31 - Choosing the VCC2 for tunneling example; Payload encapsulations
MW1122 User Manual E Copyright Nokia Networks Oy C33902002SE_00 30 Figure 20 Choosing the VCC2 for tunneling example 4.8 Point-to-Point Protocol over Ethernet (PPPoE) Standard PPPoE mode is used when MW1122 is operating as a bridge.PPPoE protocol defines how PPP sessions are mapped into Ethernetpack...
Page 32 - Wireless LAN and radio interface
E Copyright Nokia Networks Oy C33902002SE_00 31 the access list. This can be done manually through the local commandline interface (CLI) or with a Web browser management. 4.11 Wireless LAN and radio interface MW1122 supports wireless LAN to be used as one of the interfaces.The wireless LAN utilises ...
Page 33 - Technical specifications
MW1122 User Manual E Copyright Nokia Networks Oy C33902002SE_00 32 payload encapsulation formats. WFQ works properly only withIP-based protocols. If the flow is IP-based but is encrypted using IPSecor PPP encryption, then WFQ cannot identify the flows correctly. Inthis case, the default flow is used...
Page 34 - Bridging
E Copyright Nokia Networks Oy C33902002SE_00 33 Bridging Bridging Self-learning bridge, bridges between all inter-faces. Possibility to disable bridging betweenWAN interfaces. MAC table 1024 entries Class of Service Weighted fair queueing Command line interface (CLI) for local management Physical la...
Page 35 - Connectors and pin numbering; ETH connector; Table 1; Ethernet interface pin-out numbering; Table 2; ADSL interface pin-out numbering
MW1122 User Manual E Copyright Nokia Networks Oy C33902002SE_00 34 5.1 Connectors and pin numbering The pin numberings are given here if you want to obtain longer cablesfor your MW1122. 1 8 Figure 21 ETH connector PIN Signal Direction MW1122- Ethernet MDI signal 1 Tx+ –> Transmit data + 2 Tx– –&g...
Page 36 - Ambient conditions, EMC and safety; Ambient conditions
E Copyright Nokia Networks Oy C33902002SE_00 35 5.2 Ambient conditions, EMC and safety Ambient conditions Operating temperature range 5 to 45 ° C Humidity 10% to 90%, non-condensing EMC MW1122 complies with the following specifications provided that thedevice is connected to an earthed socket outlet...
