Page 2 - ADSL Router; User Manual; Introduction to Nokia M1122; Figure 1
E Copyright Nokia Networks Oy C33906002SE_00 1 M1122 ADSL Router User Manual C33906.21 A0 25.08.2000 1 Introduction to Nokia M1122 Nokia M1122 is an integrated ADSL (Asymmetric Digital SubscriberLine) bridge and router which enables high-speed Internet access fromyour Ethernet local area network (LA...
Page 3 - Interfaces; Figure 2; Indicator lights
M1122 User Manual E Copyright Nokia Networks Oy C33906002SE_00 2 2 Installing M1122 Before you install M1122 you may want to familiarise yourself withthe interfaces and indicator lights of M1122. From section 2.3 you willfind a step-by-step installation procedure, which shows the physicalinstallatio...
Page 4 - Figure 3
E Copyright Nokia Networks Oy C33906002SE_00 3 Figure 3 M1122 front panel indicators DSL GREEN Off ADSL link is down. Blinks ADSL connection is being established. On ADSL link is up. ETH- GREEN Off Ethernet is down. On 10Base-T Ethernet is functional Blinks Receives traffic from Ethernet. COL GREEN ...
Page 5 - Figure 4; Connect the Ethernet cable between your PC’s 10Base-T
M1122 User Manual E Copyright Nokia Networks Oy C33906002SE_00 4 2.3 Step-by-step installation procedure splitter Figure 4 M1122 with cables and splitter (T66270) connected(Telephone and ADSL services) 1. Plug the mains power cord to a mains outlet.2. Switch on M1122. The PWR indicator lights up. Af...
Page 6 - Browser management; Note; Opening a connection; To open a connection to the Nokia M1122:
E Copyright Nokia Networks Oy C33906002SE_00 5 Now, your M1122 has been connected and you can check theconnections according to your service provider’s instructions. 3 Configuring M1122 Your service provider has configured your M1122 for the service. Donot change settings unless specifically asked b...
Page 7 - Figure 5; Main Page
M1122 User Manual E Copyright Nokia Networks Oy C33906002SE_00 6 3. Type in the username/password as requested. If no username/password is required, just click OK to proceed. TheNokia M1122 Main Page appears. 3.1.2 Main Page Main Page is shown first when you use a web browser to connect toM1122. The...
Page 8 - Service Providers pages; Service Providers page with PPP configuration
E Copyright Nokia Networks Oy C33906002SE_00 7 The Main Page shows you the statuses of the DSL line and the Ethernetinterfaces. Software and hardware versions and the serial number ofM1122 are shown in the bottom of the page. 3.1.3 Service Providers pages The Service Providers page can be used to se...
Page 9 - Figure 7; Service Providers page with PPTP configuration
M1122 User Manual E Copyright Nokia Networks Oy C33906002SE_00 8 Figure 7 Service Providers page with PPTP configuration
Page 10 - Local Network pages; Figure 8; Local Network Local Ports page; DHCP
E Copyright Nokia Networks Oy C33906002SE_00 9 3.1.4 Local Network pages The Local Network page as four sub pages: Local ports, DHCP, NAPT,and Routing. Local ports On the Local Network Local Ports sub page you can assign an IPaddress to the Ethernet ports. Note When you click Apply, the IP addresses...
Page 11 - Start address is the interface IP address
M1122 User Manual E Copyright Nokia Networks Oy C33906002SE_00 10 Start address is the first address in the address range. The Range sizedefines how many addresses the range contains. Subnet mask is thesubnet mask of the addresses in the range. Primary and SecondaryDNSs set the domain name servers f...
Page 12 - Figure 9; Local Network DHCP page
E Copyright Nokia Networks Oy C33906002SE_00 11 Figure 9 Local Network DHCP page
Page 13 - NAPT; Local Network NAPT page
M1122 User Manual E Copyright Nokia Networks Oy C33906002SE_00 12 NAPT If Network Address Port Translation (NAPT) has been activated,servers on your local network are not visible outside your network. OnNAPT page, you can configure pinholes through which you canprovide outside access to your web ser...
Page 14 - Routing page; Local Network Routing page
E Copyright Nokia Networks Oy C33906002SE_00 13 Routing page On the Local Network Routing sub page you can set static routes andenable/disable dynamic routing protocols (Routing InformationProtocol version 1 and 2). To enable dynamic routing to a particular interface select the Routingprotocol versi...
Page 15 - Statistics page
M1122 User Manual E Copyright Nokia Networks Oy C33906002SE_00 14 3.1.5 Statistics page The Statistics page lets you view a selection of M1122 statistics. toview statistics of a particular function, click the corresponding buttonand the statistics view is opened on a separate window. Figure 12 Stati...
Page 16 - Restart page; On the Restart page, you can reset subsystems and restart M1122.
E Copyright Nokia Networks Oy C33906002SE_00 15 3.1.6 Restart page On the Restart page, you can reset subsystems and restart M1122. Figure 13 Restart page
Page 17 - Save Config page; Features; M1122 has the following interfaces:
M1122 User Manual E Copyright Nokia Networks Oy C33906002SE_00 16 3.1.7 Save Config page When you change the configuration, all configuration changes areactivated immediately without restart/reload. However, theconfiguration will not be saved into the nonvolatile memory. If M1122is restarted or powe...
Page 18 - M1122 can operate in four different main modes:; LAN interface
E Copyright Nokia Networks Oy C33906002SE_00 17 D Gateway/bridge management interface. This interface is used as abridge host interface or gateway interface depending on theoperation mode. In this manual it is called VBRIDGE. On theM1122 web pages, the interface is called gateway or bridge IPinterfa...
Page 19 - Routing
M1122 User Manual E Copyright Nokia Networks Oy C33906002SE_00 18 D RFC2364 Virtual circuit multiplexed PPP over AAL5 (PPP-VC) D RFC2364 Virtual circuit multiplexed PPP over AAL5 used totunnel LAN/VBRIDGE PPTP packets(TUNNELED-PPP-VC) If an IP address is given to a virtual channel interface and brid...
Page 21 - Dynamic Host Configuration Protocol
M1122 User Manual E Copyright Nokia Networks Oy C33906002SE_00 20 4.5 Dynamic Host Configuration Protocol M1122 can act as a Dynamic Host Configuration Protocol (DHCP)server for the PCs on the end-user home network. In this mode, M1122can assign up to 253+253 consecutive addresses from two separatea...
Page 22 - Automatic, chooses the first free VCC
E Copyright Nokia Networks Oy C33906002SE_00 21 terminates the tunnel and all data from that terminated local PPTPtunnel will be forwarded to an assigned ATM VCC by using PPP overAAL5 encapsulation. Thus, each local PPTP tunnel requires anequivalent ATM VCC assigned to it restricting the total numbe...
Page 23 - Payload encapsulations
M1122 User Manual E Copyright Nokia Networks Oy C33906002SE_00 22 4.8 Point-to-Point Protocol over Ethernet (PPPoE) Standard PPPoE mode is used when M1122 is operating as a bridge.PPPoE protocol defines how PPP sessions are mapped into Ethernetpackets. When M1122 operates as a bridge, this protocol ...
Page 24 - Technical specifications
E Copyright Nokia Networks Oy C33906002SE_00 23 5 Technical specifications Features ADSL Physical layer ANSI T1.413 Issue 2 (ANSI ADSL), ITU-TG.992.1 (ITU-T ADSL), and ITU-T G.994.1(Handshake) compatible. ADSL line connector RJ-11 ATM over ADSL ATM connections PVC, up to 8 virtual circuits Service c...
Page 26 - Connectors and pin numbering; ETH connector; Table 1; Ethernet interface pin-out numbering; Table 2; ADSL interface pin-out numbering
E Copyright Nokia Networks Oy C33906002SE_00 25 5.1 Connectors and pin numbering The pin numberings are given here if you want to obtain longer cablesfor your M1122. 1 8 Figure 17 ETH connector PIN Signal Direction M1122- Ethernet MDI signal 1 Rx+ <– Receive data + 2 Rx– <– Receive data – 3 Tx...
Page 27 - Ambient conditions, EMC and safety; Ambient conditions
M1122 User Manual E Copyright Nokia Networks Oy C33906002SE_00 26 5.2 Ambient conditions, EMC and safety Ambient conditions Operating temperature range 5 to 45 ° C Humidity 10% to 90%, non-condensing EMC M1122 complies with the following specifications provided that thedevice is connected to an eart...
