Niles SS-6 - Manual
Niles SS-6 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – TABLE OF CONTENTS; Introduction; Balancing Speaker Volume; SPECIFICATIONS; Weight
- Page 3 – Installation Considerations; Amplifier Impedance Load; When playing the following speakers:; or 2 pair of 8-ohm speakers; The Protection button should be:
- Page 4 – Avoiding Interference; “TECH TIP”; Playing One Pair of Speakers At a Time; Make sure the amplifier or receiver power is OFF and set the; Figure 3; Connecting the; SPEAKER 4
- Page 5 – Figure 1; Using a
- Page 6 – Operation; Figure 2; Installation
- Page 7 – Type of Speaker Wire; TOOLS
- Page 8 – Features and Benefits; TECH
Niles Audio
Corporation
www.nilesaudio.com
12331 S.W. 130 Street
Miami, Florida 33186
Tel: (305) 238-4373
Fax: (305) 238-0185
®
©2004 Niles Audio Corporation. All rights reserved. Niles, the Niles logo and Blending High Fidelity and
Architecture are registered trademarks of Niles Audio Corporation. Because we strive to improve our
products, Niles reserves the right to change product specifications without notice. The technical and
other information contained herein is not intended to set forth all technical and other specifications of
Niles products. Additional information can be obtained on-line at www.nilesaudio.com or by calling
Niles at 1-800-289-4434. Printed in China 1/04 DS00359ACN
SS-4/SS-6
B
L E N D I N G
H
I G H
F
I D E L I T Y
A N D
A
R C H I T E C T U R E
®
I N S T A L L A T I O N & O P E R A T I O N G U I D E
SPEAKER SELECTION SYSTEM
SS-4/SS-6
DS00359ACN/SS-4/SS-6 Printer 11/19/03 5:09 PM Page 15
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Introduction The SS-4/SS-6 allows you to connect multiple pairs of speakersto your stereo receiver or amplifier and play any pair, anycombination of pairs, or all pairs simultaneously. You don’thave to worry about overloading your amplifier. The SS-4/SS-6has a protection circuit that keeps your ampl...
Installation Considerations SS-4/SS-6 Power Handling The SS-4/SS-6 is designed for use with a receiver or amplifierhaving a maximum power output of 100 watts per channel at 8 ohms. Damage caused by the use of a higher-power receiv-er or amplifier will void the warranty. Niles speaker selectorswith h...
Avoiding Interference Speaker wires can act as an “antenna” for electrical noise.Locating speaker wires too close to a light dimmer or switchmay cause a “buzzing” or “popping” sound to be heardthrough the speakers. If you must locate the SS-4/SS-6 wiringnear electrical devices, route the speaker wir...