Nextar ncd90 - Manual - manualsarea.com

Page 2 - Contents

Contents Precautions..............................................................................2Notes on Installation.................................................................3Before You Install.....................................................................4Installation (DIN Front Mo...

Page 4 - Tools for Installation; Notes on Installation

3 • Disconnect negative battery terminal before starting installation. Consult the vehicle’s owner’s manual for proper instruction. • The unit is designed for a 12Volt DC negative ground operation system only. Before installing the unit, make sure your vehicle is a 12Volt DC negative ground system. ...

Page 5 - Before You Install

4 Before You Install 2. Mark Polarity of the Speaker Wires Automotive audio equipment installations can be troublesome at times, even to the most experienced of installation technicians. If you are not confident working with electrical wiring, removing and reinstalling interior panels, carpeting, da...

Page 6 - Installation

5 WARNING! Disconnect negative battery terminal from battery before starting installation. Consult the vehicle’s owner’s manual for proper instructions. NOTE: Mark the polarity of the existing speaker wires before disconnecting battery. NOTE: Remove the two transport screws from the top of the unit ...

Page 8 - Wiring Connections

7 Wiring Connections Make sure that you have a good chassis ground. Good ground connections will eliminate most electrical noise problems. A good chassis ground requires a tight connec- tion to the vehicle's metal chassis. The area around the ground connection should be clean, bare metal without rus...

Page 9 - Front Panel Controls

Page 10 - Basic Operation

9 Basic Operation Tuning the unit On / Off Press any Button to turn the unit on, the display will show a message WELCOME to indicate it is ready for use. Press the POWER button for 2 seconds to turn the unit off. Mode Selection Press the BAND Button to select Ra- dio Mode. Press the MODE Button to c...

Page 12 - CD Operation

11 CD Operation (Cont) Insert/Eject CD Insert a disc into CD slot with label side up. The disc will be automati- cally loaded into the unit, even when it is off or at radio mode. The word “LOAD” will blink on the display and the CD will play automatically. Press the EJECT Button to eject the disc fr...

Page 14 - Subwoofer out; ID3 Tag

13 Auxilliary in, RCA out & Subwoofer out Auxiliary Input The Auxiliary Input Jack is on the pan- el of the unit. Insert the AUX IN cable's stereo plug into the AUX IN jack on the panel of the unit. Route the other end of the stereo plug to the headphone jack of any external audio device such as...

Page 15 - Infra Red Remote Control

14 Infra Red Remote Control This unit comes with a full remote control system. The CR-2025 Lithium battery is an included item with the remote control. In case you have to replace the batteries (1) remove the cover from the back of the remote control. (2) insert a CR-2025 Lithium battery. (3) Fix th...

Page 16 - Simple Troubleshooting Guide; Specifications

15 Simple Troubleshooting Guide CD’s cannot be loaded PROBLEM No Power Some errors occur in the LCD or nothing functions when buttons are pressed.Unable to receive stations Poor radio reception CAUSE/SOLUTION Check wiring connections. Check and make sure the fuse is not blown. Replace with the prope...

Nextar ncd90 - Manual

Table of Contents:

Summary

Other Nextar Models