Netgear FSM7352S - Manual
Netgear FSM7352S – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – CONTENTS; Page of 24
- Page 5 – CHAPTER 1: INTRODUCTION; Overview; Switches to each other with high-speed links
- Page 6 – Features
- Page 7 – Package Contents
- Page 8 – Verify that your package contains the following:
- Page 9 – CHAPTER 2: PHYSICAL DESCRIPTION; Front and back panels; Front and Back Panels; Senses whether the cable is a straight-through or crossover cable.
- Page 10 – SFP module bay
- Page 11 – LED Descriptions; Label; Green on –; Console Port; Console; and; required for initial management configuration; of
- Page 12 – The console port is configured to use the following settings:
- Page 13 – CHAPTER 3: INSTALLATION; Step 1: Preparing the Site; Characteristics; Mounting; Operating conditions:
- Page 14 – Step 2: Installing the Switch; Installing the Switch on a Flat Surface; Step 3: Checking the Installation
- Page 15 – When you apply power, the; LED on the switch’s front panel will be Yellow, as it conducts a Power; Power; LED will change to Green and the; Power; LED will blink in yellow.; Power; Step 5: Connecting Devices to the Switch; Step 6: Installing a SFP Module
- Page 17 – show sysinfo; ”, and it will display the; Changing protocol mode will reset ip configuration.; After system prompt return, enter the following command
- Page 18 – Step 8: Connecting the stacking modules
- Page 19 – APPENDIX A: TECHNICAL SPECIFICATIONS; Network Protocol and Standards Compatibility
- Page 20 – Power Consumption: 80 W maximum
- Page 21 – Safety
- Page 22 – APPENDIX B: TROUBLESHOOTING; Troubleshooting Chart; Symptom; No power is received; Link; LED is off or intermittent.; Additional Troubleshooting Suggestions
- Page 24 – APPENDIX C: Default Settings
© 2005 by NETGEAR, Inc. All rights reserved.
Trademarks
© 2005 NETGEAR, Inc. NETGEAR ® , the Netgear Logo, the Gear Guy, and Everybody’s connecting are trademarks or registered trademark of
Netgear, Inc. in the United States and/or other countries. Microsoft, Windows, and the Windows logo are trademarks, or registered trademarks of
Microsoft Corporation in the United States and/or other countries. Other brand and Product names are trademarks or registered trademarks of their
respective holders. Information is subject to change without notice. All rights reserved.
Statement of Conditions
In the interest of improving internal design, operational function, and/or reliability, NETGEAR reserves the right to make changes to the products
described in this document without notice. NETGEAR does not assume any liability that may occur due to the use or application of the product(s) or
circuit layout(s) described herein.
Certificate of the Manufacturer/Importer
It is hereby certified that the NETGEAR Model FSM7352S Managed Fast Ethernet Switch has been suppressed in accordance with the conditions
set out in the BMPT-AmtsblVfg 243/1991 and Vfg 46/1992.The operation of some equipment (for example, test transmitters) in accordance with the
regulations may, however, be subject to certain restrictions. Please refer to the notes in the operating instructions.
Federal Office for Telecommunications Approvals has been notified of the placing of this equipment on the market and has been granted the right
to test the series for compliance with the regulations.
Voluntary Control Council for Interference (VCCI) Statement
This equipment is in the first category (information equipment to be used in commercial and/or industrial areas) and conforms to the standards set
by the Voluntary Control Council for Interference by Data Processing Equipment and Electronic Office Machines that are aimed at preventing radio
interference in commercial and/or industrial areas.
Consequently, when this equipment is used in a residential area or in an adjacent area thereto, radio interference may be caused to equipment
such as radios and TV receivers.
Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
This device may not cause harmful interference.
This device must accept any interference received, including interference that may cause undesired operation.
Note:
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
EN 55 022 Declaration of Conformance
This is to certify that the NETGEAR Model FSM7352S Managed Fast Ethernet Switch is shielded against the generation of radio interference in
accordance with the application of Council Directive 89/336/EEC, Article 4a. Conformity is declared by the application of EN 55024 Class A (CISPR
22).
EN 55 022 and EN 55 024 Statements
This is to certify that the NETGEAR Model FSM7352S Managed Fast Ethernet Switch is shielded against the generation of radio interference in
accordance with the application of Council Directive 89/336/EEC, Article 4a. Conformity is declared by the application of EN 55 022 Class A
(CISPR 22) and EN 55 024.
Page 1 of 24
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
CONTENTS CHAPTER 1: INTRODUCTION ...............................................................................................................................5 Overview ....................................................................................................................................
CHAPTER 1: INTRODUCTION Congratulations on your purchase of a NETGEAR Model FSM7352S Layer 3 Managed Stackable Fast Ethernet Switch! Your NETGEAR Switch is a state-of-the-art, high-performance, IEEE-compliant network solution designed for users who want ease of use along with powerful management fea...
Features The following list identifies the key features of the NETGEAR Model FSM7352S Layer 3 Managed Stackable Fast Ethernet Switch. • Forty-eight 10/100Mbps and four 10/100/100 Mbps auto sensing Fast Ethernet TP ports • Four SFP modules combo (shared with TP) with GTP for a variety of fiber connec...
