Page 2 - PROPOSITION 65 WARNING
PAGE 2 — QP- 2TE TRASH PUMP — OPERATION AND PARTS MANUAL — REV. #1 (08/10/10) PROPOSITION 65 WARNING
Page 3 - NOTES
QP- 2TE TRASH PUMP — OPERATION AND PARTS MANUAL — REV. #1 (08/10/10) — PAGE 3 NOTES
Page 4 - NOTE; QP- 2TE — TABLE OF CONTENTS; Terms and Condition Of Sale
PAGE 4 — QP- 2TE TRASH PUMP — OPERATION AND PARTS MANUAL — REV. #1 (08/10/10) Specification and part number are subject to change without notice . NOTE QP-2TE Trash Pump Proposition 65 Warning ............................................. 2Table of Contents .............................................
Page 5 - PARTS ORDERING PROCEDURES; Ordering parts has never been easier!; Choose from three easy options:; Order via Internet; Order; Order via Fax
QP- 2TE TRASH PUMP — OPERATION AND PARTS MANUAL — REV. #1 (08/10/10) — PAGE 5 PARTS ORDERING PROCEDURES www .multiquip .com Ordering parts has never been easier! Choose from three easy options: WE ACCEPT ALL MAJOR CREDIT CARDS! When ordering parts, please supply: R Dealer Account Number R Dealer Nam...
Page 6 - SAFETY INFORMATION; SAFETY MESSAGES; DANGER
PAGE 6 — QP- 2TE TRASH PUMP — OPERATION AND PARTS MANUAL — REV. #1 (08/10/10) SAFETY INFORMATION Do not operate or service the equipment before reading the entire manual. Safety precautions should be followed at all times when operating this equipment. Failure to read and understand the safety messa...
Page 7 - GENERAL SAFETY; PUMP SAFETY
QP- 2TE TRASH PUMP — OPERATION AND PARTS MANUAL — REV. #1 (08/10/10) — PAGE 7 SAFETY INFORMATION GENERAL SAFETY CAUTION NEVER operate this equipment without proper protective clothing, shatterproof glasses, respiratory protection, hearing protection, steel-toed boots and other protective devices r...
Page 8 - ENGINE SAFETY
PAGE 8 — QP- 2TE TRASH PUMP — OPERATION AND PARTS MANUAL — REV. #1 (08/10/10) SAFETY INFORMATION CAUTION NEVER lubricate components or attempt service on a running machine. NEVER block or restrict flow from discharge hose. Remove kinks from discharge line before starting pump. Operation with a b...
Page 9 - FUEL SAFETY
QP- 2TE TRASH PUMP — OPERATION AND PARTS MANUAL — REV. #1 (08/10/10) — PAGE 9 SAFETY INFORMATION FUEL SAFETY DANGER DO NOT add fuel to equipment if it is placed inside truck bed with plastic liner. Possibility exists of explosion or fire due to static electricity. DO NOT start the engine near spi...
Page 10 - TRANSPORTING SAFETY; ENVIRONMENTAL SAFETY
PAGE 10 — QP- 2TE TRASH PUMP — OPERATION AND PARTS MANUAL — REV. #1 (08/10/10) TRANSPORTING SAFETY CAUTION NEVER allow any person or animal to stand underneath the equipment while lifting. NOTICE Before lifting, make sure that the equipment parts (hook and vibration insulator) are not damaged an...
Page 14 - QP- 2TE — GENERAL INFORMATION
PAGE 14 — QP- 2TE TRASH PUMP — OPERATION AND PARTS MANUAL — REV. #1 (08/10/10) QP- 2TE — GENERAL INFORMATION APPLICATION The QP-2TE Trash Pump is designed to be used for dewatering applications. Both the suction and discharge ports on the QP-2TE trash pump use a 2-inch diameter opening, which allows...
Page 15 - QP- 2TE — PUMP COMPONENTS
QP- 2TE TRASH PUMP — OPERATION AND PARTS MANUAL — REV. #1 (08/10/10) — PAGE 15 Figure 2 shows a typical application using the QP- 2TE Trash pump. Please note that this pump is intended for the removal of cleanwater and water containing some debris and solids. Maximum size of solids should not exceed...
Page 16 - Figure 3. Pump Refueling; cool down. In the event of a fuel spill,; DO NOT; attempt to start the; REMOVE; pump from truck bed and place on; fire; or; explosion
PAGE 16 — QP- 2TE TRASH PUMP — OPERATION AND PARTS MANUAL — REV. #1 (08/10/10) QP- 2TE — REFUELING PLASTIC TRUCK-BED LINER DO NOT ADD FUEL TO TRASH PUMP IF TRASH PUMP IS PLACED INSIDE TRUCK-BED WITH PLASTIC LINER. POSSIBILITY EXISTS OF EXPLOSION OR FIRE DUE TO . STATIC ELECTRICITY DANGER Figure 3. P...
Page 17 - QP- 2TE — BASIC ENGINE
QP- 2TE TRASH PUMP — OPERATION AND PARTS MANUAL — REV. #1 (08/10/10) — PAGE 17 QP- 2TE — BASIC ENGINE Figure 4. Engine Controls and Components INITIAL SERVICING The engine (Figure 4) must be checked for proper lubrication andfilled with fuel prior to operation. Refer to the ROBIN engine service manu...
Page 19 - discharge; must; collapsible
QP- 2TE TRASH PUMP — OPERATION AND PARTS MANUAL — REV. #1 (08/10/10) — PAGE 19 Before Starting 1. Read safety instructions at thebeginning of manual. 2. Place pump as near to water as possible, on a firm flat, level surface. 3. To prime pump, remove fill cap (Figure 2) and fill pump casing with wate...
Page 21 - full speed; CAUTI
QP- 2TE TRASH PUMP — OPERATION AND PARTS MANUAL — REV. #1 (08/10/10) — PAGE 21 QP- 2TE — INITIAL START-UP (ENGINE) 6. Grasp the starter grip (Figure 12) and slowly pull it out. The resistance becomes the hardest at a certain position, corre-sponding to the compression point. Pull the starter grip br...
Page 26 - QP- 2TE — PREPARATION FOR LONG -TERM STORAGE; Pump Storage; Drain the fuel tank completely.
PAGE 26 — QP- 2TE TRASH PUMP — OPERATION AND PARTS MANUAL — REV. #1 (08/10/10) QP- 2TE — PREPARATION FOR LONG -TERM STORAGE Pump Storage For storage of the pump for over 30 days, the following isrequired: Drain the fuel tank completely. Run the engine until the fuel in the injection system iscom...
Page 27 - NOTE PAGE
QP- 2TE TRASH PUMP — OPERATION AND PARTS MANUAL — REV. #1 (08/10/10) — PAGE 27 NOTE PAGE
Page 30 - QP- 2TE — EXPLANATION OF CODE IN REMARKS COLUMN; SAMPLE PARTS LIST; REMARKS Column
PAGE 30 — QP- 2TE TRASH PUMP — OPERATION AND PARTS MANUAL — REV. #1 (08/10/10) QP- 2TE — EXPLANATION OF CODE IN REMARKS COLUMN The following section explains the different symbols and remarks used in the Parts section of this manual. Use the help numbers found on the back page of the manual if there...
Page 31 - QP- 2TE — SUGGESTED SPARE PARTS
QP- 2TE TRASH PUMP — OPERATION AND PARTS MANUAL — REV. #1 (08/10/10) — PAGE 31 QP- 2TE — SUGGESTED SPARE PARTS QP- 2TE TRASH PUMP 1 TO 3 UNITSW/ROBIN EX170D50021 ENGINE Qty. P/N Description 2 ........................................... KIT, MECHANICAL SEAL, O-RINGS1 ............ 1889040030 ............
Page 38 - ROBIN EX170D50021 ENGINE— CRANKSHAFT AND PISTON ASSY.; CRANKSHAFT AND PISTON ASSY.
PAGE 38 — QP- 2TE TRASH PUMP — OPERATION AND PARTS MANUAL — REV. #1 (08/10/10) ROBIN EX170D50021 ENGINE— CRANKSHAFT AND PISTON ASSY. CRANKSHAFT AND PISTON ASSY.
Page 39 - PART NO
QP- 2TE TRASH PUMP — OPERATION AND PARTS MANUAL — REV. #1 (08/10/10) — PAGE 39 ROBIN EX170D50021 ENGINE— CRANKSHAFT AND PISTON ASSY. CRANKSHAFT AND PISTON ASSY. NO PART NO PART NAME QTY. REMARKS 10 2772030121 CRANKSHAFT CP 1 50 0180140020 FLANGE NUT 1 70 0323030010 WOODRUFF KEY 1 310 2772250110 CONN...
Page 42 - INTAKE AND EXHAUST GROUP ASSY.
PAGE 42 — QP- 2TE TRASH PUMP — OPERATION AND PARTS MANUAL — REV. #1 (08/10/10) ROBIN EX170D50021 ENGINE— INTAKE EXHAUST ASSY. INTAKE AND EXHAUST GROUP ASSY.
Page 46 - COOLIONG AND STARTING ASSY.
PAGE 46 — QP- 2TE TRASH PUMP — OPERATION AND PARTS MANUAL — REV. #1 (08/10/10) ROBIN EX170D50021 ENGINE — COOLING AND STARTING ASSY. COOLIONG AND STARTING ASSY.
Page 52 - ELECTRIC DEVICE ASSY.
PAGE 52 — QP- 2TE TRASH PUMP — OPERATION AND PARTS MANUAL — REV. #1 (08/10/10) ROBIN EX170D50021 ENGINE— ELECTRIC DEVICE ASSY. ELECTRIC DEVICE ASSY.
Page 53 - ELECTRIC DEVICE ASSY.; OIL SENSOR CP
QP- 2TE TRASH PUMP — OPERATION AND PARTS MANUAL — REV. #1 (08/10/10) — PAGE 53 ROBIN EX170D50021 ENGINE— ELECTRIC DEVICE ASSY. ELECTRIC DEVICE ASSY. NO PART NO PART NAME QTY. REMARKS 700 2777630111 OIL SENSOR CP 1 705 KU31104311 CONTROL ASSY. 1 740 0011406160 BOLT & WASHER ASSY. 2 741 0150040090...
Page 58 - OPERATION AND PARTS MANUAL; Your Local Dealer is:; HERE’S HOW TO GET HELP; PLEASE HAVE THE MODEL AND SERIAL; CANADA
OPERATION AND PARTS MANUAL Your Local Dealer is: HERE’S HOW TO GET HELP PLEASE HAVE THE MODEL AND SERIAL NUMBER ON-HAND WHEN CALLING © COPYRIGHT 2010, MULTIQUIP INC. Multiquip Inc and the MQ logo are registered trademarks of Multiquip Inc. and may not be used, reproduced, or altered without written ...
