Page 2 - PROPOSITION 65 WARNING
PAGE 2 — MT54F RAMMER — OPERATION AND PARTS MANUAL — REV. #8 (01/10/12) PROPOSITION 65 WARNING
Page 3 - NOTES
MT54F RAMMER — OPERATION AND PARTS MANUAL — REV. #8 (01/10/12) — PAGE 3 NOTES
Page 4 - Terms and Condition Of Sale; Specification and part number are subject to; TABLE OF CONTENTS
PAGE 4 — MT54F RAMMER — OPERATION AND PARTS MANUAL — REV. #8 (01/10/12) MIKASA MT54FTamping Rammer Proposition 65 Warning ......................................... 2Table Of Contents ................................................. 4Parts Ordering Procedures ................................... 5Saf...
Page 5 - Ordering parts has never been easier!; Choose from three easy options:; Order via Internet; Order; Order via Fax; PARTS ORDERING PROCEDURES
MT54F RAMMER — OPERATION AND PARTS MANUAL — REV. #8 (01/10/12) — PAGE 5 www .multiquip .com Ordering parts has never been easier! Choose from three easy options: WE ACCEPT ALL MAJOR CREDIT CARDS! When ordering parts, please supply: ❒ Dealer Account Number ❒ Dealer Name and Address ❒ Shipping Address...
Page 6 - SAFETY MESSAGES; DANGER; SAFETY INFORMATION
PAGE 6 — MT54F RAMMER — OPERATION AND PARTS MANUAL — REV. #8 (01/10/12) Do not operate or service the equipment before reading the entire manual. Safety precautions should be followed at all times when operating this equipment. Failure to read and understand the safety messages and operating instruc...
Page 7 - GENERAL SAFETY; RAMMER SAFETY
MT54F RAMMER — OPERATION AND PARTS MANUAL — REV. #8 (01/10/12) — PAGE 7 GENERAL SAFETY CAUTION NEVER operate this equipment without proper protective clothing, shatterproof glasses, respiratory protection, hearing protection, steel-toed boots and other protective devices required by the job or cit...
Page 8 - ENGINE SAFETY; FUEL SAFETY
PAGE 8 — MT54F RAMMER — OPERATION AND PARTS MANUAL — REV. #8 (01/10/12) ENGINE SAFETY DANGER The engine fuel exhaust gases contain poisonous carbon monoxide. This gas is colorless and odorless, and can cause death if inhaled. The engine of this equipment requires an adequate free flow of cooling...
Page 9 - TRANSPORTING SAFETY; ENVIRONMENTAL SAFETY
MT54F RAMMER — OPERATION AND PARTS MANUAL — REV. #8 (01/10/12) — PAGE 9 TRANSPORTING SAFETY CAUTION NEVER allow any person or animal to stand underneath the equipment while lifting. NOTICE Before lifting, make sure that the equipment parts (hook and vibration insulator) are not damaged and screw...
Page 10 - GENERAL INFORMATION
PAGE 10 — MT54F RAMMER — OPERATION AND PARTS MANUAL — REV. #8 (01/10/12) Definition of Tamping Rammer The Mikasa MT-54F tamping rammer is a powerful compactingtool capable of applying a tremendous force in consecutiveimpacts to a soil surface. Its applications include soil compactingfor road, embank...
Page 11 - NOTE; SPECIFICATIONS
MT54F RAMMER — OPERATION AND PARTS MANUAL — REV. #8 (01/10/12) — PAGE 11 NOTE Specifications are general and are subject to change without notice. If exactmeasurements are required, equipment should be weighed and measured. s n o i t a c i f i c e p S r e m m a R F 4 5 - T M . 1 e l b a T s n o i t ...
Page 12 - MT-54F — CONTROLS AND COMPONENTS; COMPONENTS
PAGE 12 — MT54F RAMMER — OPERATION AND PARTS MANUAL — REV. #8 (01/10/12) 8. Foot – Laminated wood with tempered steel plate for superior shock absorption. 9. Oil Level Sight Glass – Indicates the level of oil in the oil bath reservoir. 10. Recoil Starting Handle – Used when starting the engine. Pull...
Page 13 - CAUTION - Burn Hazard; BASIC ENGINE
MT54F RAMMER — OPERATION AND PARTS MANUAL — REV. #8 (01/10/12) — PAGE 13 Figure 1-A. Engine Controls and Components INITIAL SERVICING The engine (Figure 1-A) must be checked for proper lubrication andfilled with fuel prior to operation. Refer to the manufacturer's Enginemanual for instructions and d...
Page 14 - Figure 4. Engine Oil Dipstick; Engine; OPERATION
PAGE 14 — MT54F RAMMER — OPERATION AND PARTS MANUAL — REV. #8 (01/10/12) CAUTION: CAUTION: CAUTION: CAUTION: CAUTION: Failure to understand the operation of the MT-54F Tamping Rammer could result in severedamage to the trowel or personal injury. Rammer Gearbox and Spring Cylinder Oil Bath This unit ...
Page 15 - Inspection; Figure 6. On Off Switch; ON; Figure 7. Choke Lever
MT54F RAMMER — OPERATION AND PARTS MANUAL — REV. #8 (01/10/12) — PAGE 15 Inspection 1 . Check all nuts, bolts fasteners for tightness. Retighten as necessary. 2. Clean any dirt from the recoil starter and foot pedestal. Wipe the entire unit clean before operating. 3. Replace any missing or damaged S...
Page 17 - Maintenance; Perform the scheduled maintenance procedures as indicated:; DAILY; Remove or clean the filter at the bottom of the tank.; Yearly; Drain fuel from fuel tank, fuel line and carburetor.; MAINTENANCE
MT54F RAMMER — OPERATION AND PARTS MANUAL — REV. #8 (01/10/12) — PAGE 17 Maintenance Perform the scheduled maintenance procedures as indicated: DAILY ■ Thoroughly remove dirt and oil from the engine and controlarea. Clean or replace the air cleaner elements as necessary.Check and retighten all faste...
Page 18 - MT-54F — TROUBLESHOOTING GUIDE; TROUBLESHOOTING
PAGE 18 — MT54F RAMMER — OPERATION AND PARTS MANUAL — REV. #8 (01/10/12) MT-54F — TROUBLESHOOTING GUIDE G N I T O O H S E L B U O R T E N I G N E . 4 E L B A T M O T P M Y S M E L B O R P E L B I S S O P N O I T U L O S t r a t s o t t l u c i f f i D g u l p k r a p s t u b e l b a li a v a s i l e...
Page 19 - ENGINE
MT54F RAMMER — OPERATION AND PARTS MANUAL — REV. #8 (01/10/12) — PAGE 19 MT-54F — TROUBLESHOOTING GUIDE ENGINE ENGINE ENGINE ENGINE ENGINE d e u n i t n o c ( G N I T O O H S E L B U O R T E N I G N E . 4 E L B A T ) M O T P M Y S M E L B O R P E L B I S S O P N O I T U L O S y r o t c a f s i t a s...
Page 20 - SAMPLE PARTS LIST; REMARKS Column; EXPLANATION OF CODES IN THE REMARKS COLUMN
PAGE 20 — MT54F RAMMER — OPERATION AND PARTS MANUAL — REV. #8 (01/10/12) The following section explains the different symbols and remarks used in the Parts section of this manual. Use the help numbers found on the back page of the manual if there are any questions. SAMPLE PARTS LIST NO. PART NO. PAR...
Page 21 - SUGGESTED SPARE PARTS
MT54F RAMMER — OPERATION AND PARTS MANUAL — REV. #8 (01/10/12) — PAGE 21 MT-54F RAMMER 1 TO 3 UNITS Qty. P/N Description 1 ............ 956225020 ............ LEVER, THROTTLE3 ............ 354030030 ............ ELEMENT, YELLOW3 ............ 354030040 ............ ELEMENT, GRAY1 ............ 3619100...
Page 22 - NAMEPLATE AND DECALS; Mikasa
PAGE 22 — MT54F RAMMER — OPERATION AND PARTS MANUAL — REV. #8 (01/10/12) NAMEPLATE AND DECALS 3 Mikasa Mikasa MT-54F 4 10 11 1 2 To start, switch must be in the “ ” position ON NPA 293 3400 ~ 3600 RPM NPA 90 CAUTION READ 0WNER’S MANUAL NPA 629 14 13 NPA-333 12 5 9 NAMEPLATE 8 7 6
Page 24 - CRANKCASE AND ENGINE ASSY.
PAGE 24 — MT54F RAMMER — OPERATION AND PARTS MANUAL — REV. #8 (01/10/12) CRANKCASE AND ENGINE ASSY.
Page 28 - GUIDE CYLINDER AND FOOT ASSY.
PAGE 28 — MT54F RAMMER — OPERATION AND PARTS MANUAL — REV. #8 (01/10/12) GUIDE CYLINDER AND FOOT ASSY. 100
Page 30 - TANK AND HANDLE ASSY.
PAGE 30 — MT54F RAMMER — OPERATION AND PARTS MANUAL — REV. #8 (01/10/12) MT-54F — TANK AND HANDLE ASSY. TANK AND HANDLE ASSY.
Page 32 - ROBIN EH09 ENGINE — CRANKCASE ASSY.
PAGE 32 — MT54F RAMMER — OPERATION AND PARTS MANUAL — REV. #8 (01/10/12) ROBIN EH-09 ENGINE — CRANKCASE ASSY. ROBIN EH09 ENGINE — CRANKCASE ASSY.
Page 34 - ROBIN EH09 ENGINE — CRANKSHAFT AND PISTON ASSY.
PAGE 34 — MT54F RAMMER — OPERATION AND PARTS MANUAL — REV. #8 (01/10/12) ROBIN EH09 ENGINE — CRANKSHAFT AND PISTON ASSY.
Page 36 - ROBIN EH09 ENGINE — INTAKE AND EXHAUST ASSY.
PAGE 36 — MT54F RAMMER — OPERATION AND PARTS MANUAL — REV. #8 (01/10/12) ROBIN EH09 ENGINE — INTAKE AND EXHAUST ASSY.
Page 38 - ROBIN EH09 ENGINE — GOVERNOR ASSY.
PAGE 38 — MT54F RAMMER — OPERATION AND PARTS MANUAL — REV. #8 (01/10/12) ROBIN EH09 ENGINE — GOVERNOR ASSY.
Page 40 - ROBIN EH09 ENGINE — RECOIL STARTER ASSY.
PAGE 40 — MT54F RAMMER — OPERATION AND PARTS MANUAL — REV. #8 (01/10/12) ROBIN EH09 ENGINE — RECOIL STARTER ASSY.
Page 42 - ROBIN EH09 ENGINE — CARBURETOR ASSY.
PAGE 42 — MT54F RAMMER — OPERATION AND PARTS MANUAL — REV. #8 (01/10/12) ROBIN EH09 ENGINE — CARBURETOR ASSY.
Page 44 - ROBIN EH09 ENGINE — ELECTRIC DEVICE ASSY.
PAGE 44 — MT54F RAMMER — OPERATION AND PARTS MANUAL — REV. #8 (01/10/12) ROBIN EH09 ENGINE — ELECTRIC DEVICE ASSY.
Page 46 - TERMS AND CONDITIONS OF SALE — PARTS
PAGE 46 — MT54F RAMMER — OPERATION AND PARTS MANUAL — REV. #8 (01/10/12) TERMS AND CONDITIONS OF SALE — PARTS PAYMENT TERMS Terms of payment for parts are net 30 days. FREIGHT POLICY All parts orders will be shipped collect or prepaid with the charges added to the invoice. All shipments are F.O.B. p...
Page 48 - OPERATION AND PARTS MANUAL; Your Local Dealer is:; HERE’S HOW TO GET HELP; PLEASE HAVE THE MODEL AND SERIAL; CANADA
OPERATION AND PARTS MANUAL Your Local Dealer is: HERE’S HOW TO GET HELP PLEASE HAVE THE MODEL AND SERIAL NUMBER ON-HAND WHEN CALLING UNITED STATES Multiquip Corporate Office MQ Parts Department 18910 Wi lm i ngton A v e . C ars on, C A 90746 Cont a ct : mq@mult i qu i p.com T e l. (800) 421-1244 F a...
