Multiquip C30HDG Manual - Free PDF Download

Page 2 - TABLE OF CONTENTS

PAGE 2 — INSTALLATION OPERATION MANUAL — REV. #0 (08/19/09) TABLE OF CONTENTS Warranty ............................. 3 Overview ............................ 4 Specifi cations .................... 5 Care And Handling ............. 6 Receiver Installation ......... 7-8 Cable Installation ................

Page 3 - LIMITED ONE YEAR WARRANTY; Product specifi cation subject to change without notice.; WARRANTY

INSTALLATION/OPERATION MANUAL — REV. #0 (08/19/09) — PAGE 3 LIMITED ONE YEAR WARRANTY Miratron Incorporated, hearafter referred to as Miratron, is providing this warranty in lieu of all other express or implied warranties, including any warranty of merchantability or fi tness for a particular purpos...

Page 4 - OVERVIEW; ALWAYS; read manual before attempting to operate the

PAGE 4 — INSTALLATION OPERATION MANUAL — REV. #0 (08/19/09) OVERVIEW ALWAYS read manual before attempting to operate the equipment. Failure not to read manual could cause severe equipment damage and or damage to the receiver and transmitter. Make sure work area is safe to operate radio control recei...

Page 5 - SPECIFICATIONS

INSTALLATION/OPERATION MANUAL — REV. #0 (08/19/09) — PAGE 5 SPECIFICATIONS Specifi cations Table 1. Miratron Model Number: RX4 Radio Control Receiver CMD16-0135 ~ (MQ P/N EM98215) General: Power Requirements 12-24VDC, 500mA max Radio: Frequency Standard Frequecy Control FCC ID Receiver Sensitivity 9...

Page 6 - CARE AND HANDLING

PAGE 6 — INSTALLATION OPERATION MANUAL — REV. #0 (08/19/09) CARE AND HANDLING Transmitter: Clean transmitter gently with a damp cloth.  DO NOT immerse transmitter in water, or spray with hose. DO NOT store outside. DO NOT  drop transmitter or otherwise subject transmitter to physical shock. DO NOT...

Page 7 - RECEIVER INSTALLATION; Battery Disconnection

INSTALLATION/OPERATION MANUAL — REV. #0 (08/19/09) — PAGE 7 RECEIVER INSTALLATION Parts: Make sure all parts are accounted for before performing the installation. The following parts are included with the kit: Radio Transmitter  Radio Receiver  Spiral Antenna with associated mounting hardware  Co...

Page 8 - Radio Control Receiver Mounting; Drill two 1/4” holes into the control box support panel on the C30HDG

PAGE 8 — INSTALLATION OPERATION MANUAL — REV. #0 (08/19/09) Radio Control Receiver Mounting Drill two 1/4” holes into the control box support panel on the C30HDG 1. as shown in Figure 1. After both holes have been drilled, deburr each hole opening. 2. Using a 1/4-20 x 1-1/4 bolt (2), 1/4 lock washer...

Page 9 - CABLE INSTALLATION; Control Box Removal

INSTALLATION/OPERATION MANUAL — REV. #0 (08/19/09) — PAGE 9 CABLE INSTALLATION Control Box Removal Using a 7/16 socket remove the mounting bolts (3) that secure the control box 1. to the support bracket. Once the bolts have been removed, fl ip the panel downward to gain access to 2. the connection p...

Page 10 - Wiring Diagram; WIRING DIAGRAM

PAGE 10 — INSTALLATION OPERATION MANUAL — REV. #0 (08/19/09) Wiring Diagram Figure 2. DECREASE TERMINAL STRIP (+12VDC) BATT + ADD TERMINAL RING BLACK WHITE PUMPING CONTROL SWITCH WHITE (ADD) BLACK (ADD) ENGINE OIL SENSOR EMERGENCY STOP PIN 4 (WHITE) SPLICE SPLICE REMOTE (WHITE) DECREASE (WHITE) INCR...

Page 11 - Transmitter; Power On Switch

INSTALLATION/OPERATION MANUAL — REV. #0 (08/19/09) — PAGE 11 TRANSMITTER/RECEIVER The defi nitions below describe the controls and functions of the Miratron Transmitter and Radio Control Receiver. Transmitter Power On Switch 1. — Place this switch in the ON position to turn on the transmitter. Be su...

Page 12 - Functional Test; Start the engine as outlined on the operator’s manual.

PAGE 12 — INSTALLATION OPERATION MANUAL — REV. #0 (08/19/09) TRANSMITTER/RECEIVER Functional Test Perform the functional test procedure below to test the remote control radio system.. Start the engine as outlined on the operator’s manual. 1. Place the transmitter power ON/OFF switch in the ON positi...

Page 13 - TROUBLESHOOTING; Troubleshooting

INSTALLATION/OPERATION MANUAL — REV. #0 (08/19/09) — PAGE 13 TROUBLESHOOTING Troubleshooting Table 2. Symptom Possible Problem Solution Transmitter does not function at all LED status indicator not fl ashing. LED indicator not lit when power ON/OFF switch is pressed. Turn transmitter power switch ON...

Page 14 - SYSTEM WIRING DIAGRAM; System Wiring Diagram

PAGE 14 — INSTALLATION OPERATION MANUAL — REV. #0 (08/19/09) SYSTEM WIRING DIAGRAM System Wiring Diagram Figure 4.

Page 15 - NOTE PAGE

INSTALLATION/OPERATION MANUAL — REV. #0 (08/19/09) — PAGE 15 NOTE PAGE

Page 16 - INSTALLATION/OPERATION MANUAL; HERE’S HOW TO GET HELP

INSTALLATION/OPERATION MANUAL Your Local Dealer is: HERE’S HOW TO GET HELP PLEASE HAVE THE MODEL AND SERIAL NUMBER ON-HAND WHEN CALLING © COPYRIGHT 2009, MULTIQUIP INC. Multiquip Inc, the MQ logo and the Mayco logo are registered trademarks of Multiquip Inc. and may not be used, reproduced, or alter...