Monarch 1071-4833-121 - Manual

Page 2 - Safeguards and Precautions; LIMITED WARRANTY

Safeguards and Precautions 1. Read and follow all instructions in this manual carefully, and retainthis manual for future reference. 2. Do not use this instrument in any manner inconsistent with theseoperating instructions or under any conditions that exceed theenvironmental specifications stated. 3...

Page 3 - DECLARATION OF CONFORMITY; Monarch Instrument; Division of Monarch International Inc.; NovaStrobe - Stroboscope

1.0 INTRODUCTION ..................................................................... 1 1.1 Direct Digital Synthesis ...................................................................... 1 1.2 Display Panel ..................................................................................... 1 2.0...

Page 4 - OPTIONS AND ACCESSORIES

8.0 BATTERY AND POWER SUPPLY SPECIFICS .................... 10 8.1 Displaying Battery Charge Percentage ............................................ 10 8.2 Low Battery Indication ..................................................................... 10 8.3 Charging the Batteries ........................

Page 5 - Figure 1 Display Panel; Direct Digital Synthesis

Figure 1 Display Panel 1 1.0 INTRODUCTION The Phaser-Strobe is an extremely sophisticated instrument with many features never before available in a stroboscope, yet remains simple to operate. Select only the features you need. Its internalmicroprocessor with “Direct Digital Synthesis” enables precis...

Page 6 - Figure 3 Input Connector Connection Detail; PREPARATION FOR USE; before the stroboscope is; Battery Disposal

2 ! ! ! ! ! ! ! ! ! ! Out In ! ! ! ! ! " " " " " Figure 2 Input/ Output Jacks Signal Input +6V Out to Sensor Common (GND) Common(GND)+6V Out toSensor Signal Input Figure 3 Input Connector Connection Detail 2.0 PREPARATION FOR USE The Strobe may be hand held or mounted on a tripod...

Page 7 - Figure 4 Output Connector Connection Detail; BATTERY AND POWER SUPPLY SPECIFICS; Displaying Battery Charge Percentage

3 Signal Input Common (GND) Common(GND) Signal Input Figure 4 Output Connector Connection Detail With no external input, theoutput jack ( ! pointing away from socket) provides a TTLcompatible pulse from thestrobe’s internal oscillator. Ifan external input is applied,the output pulse mimics thei n p ...

Page 8 - Red Dots; Fuse Replacement

4 increment would exceed the maximum, eg 32,000 to 33,000, the display will notincrement. Select a lower digit to increment. There are two ways/modes to select a new blinking digit: Knob 1 mode: Push and hold in the knob and turn to select a new digit. The next digit to blink isdependent upon the di...

Page 9 - External Delay Modes – External Input Required; LAMP AND FUSE REPLACEMENT; Lamp Replacement

5 Pressing the x2 or ÷2 buttons has no effect on operation. Pressing the DELAY button will put the unit into one of the two External Delay modes as explained in the next section. 3.4 External Delay Modes – External Input Required There are two External Delay modes: Phase Delay and Time Delay . In or...

Page 10 - Storing Settings; Stopped Image; Recalling Settings; USING THE STROBOSCOPE TO MEASURE RPM; Figure 5 Object Rotating at 3500 RPM

6 2. Press the MEMORY/AUTO button until “AUTO” is displayed. (When in the Auto mode , the ‘AUTO’ chevron is displayed.) When the “AUTO” chevron displayed, the secondary (white) button functions are active.These are STEP, RATE, ON, and OFF . To adjust the step size, press the STEP button. The display...

Monarch 1071-4833-121 - Manual

Table of Contents:

Summary

Other Monarch Models