Moen INS2151A-9 - Manual
Moen INS2151A-9 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Table of Contents; Rough-in Plumbing Variations; Thank you for choosing Moen.; Please Contact Moen First; For Installation Help, Missing or Replacement Parts; USA; li; Tub/Shower Parts Supplied; Shower Only Parts Supplied; Visit Moen.com for product specific parts diagrams.; Styles and parts vary by model.
- Page 3 – Helpful Tools; These may be; Please follow all local building and plumbing codes.; Copper; Helpful Tools; Helpful Tools
- Page 4 – lis; Installing Your Valve; Thick Wall Installation; For Walls Thicker Than; The “Thick Wall” installation method is used; Thin Wall Installation; For Walls Thinner Than; The “Thin Wall” method is used when the; Shower Only; not included
- Page 5 – Slip Fit Tub Spout Installation; Cartridge Orientation; OR; Other Possible Handle
- Page 6 – Moen Lifetime Limited Warranty; Setting The Temperature Limit Stop and Finishing Your
- Page 7 – sp; Instrucciones de instalación; Los estilos y las piezas varían según el modelo.; Para soporte de la garantía; Instrucciones para el cuidado; sp; Problema Causa probable Para diagnosticar; Para obtener asistencia adicional, póngase en contacto Moen en:
- Page 8 – Tabla de contenido; Variaciones de las tuberías de plomería; Piezas suministradas para la tina/regadera; Piezas suministradas sólo para la regadera; Primero póngase en contacto con Moen; CANADÁ; Visite Moen.com para ver los diagramas de
- Page 9 – Siga; Cobre; Herramientas útiles; Herramientas útiles
- Page 10 – no incluido; Instalación en paredes delgadas; Para paredes más delgadas de 1/4 de pulgada; permanece; Instalar la válvula; Instalación en paredes gruesas; Para paredes más gruesas de 1/4 de pulgada
- Page 11 – Instalar el regulador Moen para la tina/regadera; Orientación del; Otras posibles; Instalación del surtidor de la tina con rosca
- Page 12 – Garantía limitada de por vida de Moen; Si la temperatura es inferior a los 120 grados, vaya al paso 5.4.; Establecer el tope del límite de temperatura y terminar la
- Page 13 – Directives d’entretien; Pour obtenir de l’aide, contacter Moen au :; Directives d’installation; Les styles et les pièces peuvent varier selon le modèle choisi.; Pour obtenir un soutien de garantie
- Page 14 – Table des matières; Modèles de plomberie brute; ra; Nous vous remercions d’avoir choisi Moen.; Veuillez d’abord contacter Moen; en cas de problèmes avec l’installation, ou pour obtenir toute; CANADA; Pièces de douche/baignoire fournies; Visiter Moen.com pour obtenir les diagrammes de pièces
- Page 15 – Veuillez vous conformer aux codes de; Cuivre; Outils utiles; Outils utiles
- Page 16 – non inclus; Installation dans un mur mince; Pour les murs de moins de 1/4 po; La méthode du « mur mince » est utilisée; Installation de la soupape; Installation dans un mur épais; Pour les murs de plus de 1/4 po; La méthode d’installation sur un « mur épais » est
- Page 17 – Installation du bec de baignoire; Orientation de la cartouche; OU; Installation d’un bec de baignoire fileté
- Page 18 – Garantie à vie limitée Moen; Si la température dépasse 49; Réglage du limiteur de température et finalisation de; Installation de poignée à levier; Autres types d’installation
Installation Instructions
Styles and parts vary by model.
E
n
g
lis
h
E1
One Handle Tub/Shower Valve Trim
One Handle Shower Only Valve Trim
Model Number
Installation Date
For Warranty Support
▲
▲
INS2151A - 9/11
OR
OR
E12
INS2151A - 9/11
©2011 Moen Incorporated www.moen.com
Care Instructions
To preserve the finish on the metallic parts of your Moen faucet, apply non-abrasive wax, such as car wax. Any
cleaners should be rinsed off immediately.
Hot/cold reversed
Lines reversed/
Hot/cold reversed
Rotate cartridge stem 180˚
cartridge installed
so that the notch is facing
upside down
down towards the drain.
No water/low flow
One or both
No water/low flow
Turn both water supply valves
supplies not on
counterclockwise to the on
to the unit
position
Leak or drip
Grommets not
Leak/drip from spout
Replace cartridge
from spout
sealing properly
Only hot/no cold –
Balancing spool
Only hot/no cold –
Replace cartridge
Only cold/no hot
stuck
Only cold/no hot
Stacking (Water
Choice of pipe/
Water comes out of spout
Change pipe to IPS or
comes out of the
distance between
and showerhead at the
copper/distance from
showerhead during
valve and showerhead
same time
showerhead and valve
tub fill mode)
less than 46"/multiple
moved to at least 46"/
elbows/anything
change or remove anything
restricting flow of
restrictive
water exiting valve
Flow restriction
Water comes out of spout
Remove tub spout and flush
between valve and
and showerhead at the
out debris – Replace
tub spout
same time causing
undersized line or fittings
restriction
Valve installed
Remove cartridge and verify
Remove valve and reinstall
upside down
that the outlet hole is in
in the proper orientation
proper location (should be
down). "Up" is on the top
of the valve
Restricted
Handle (more
In the off position, able to
Remove handle, rotate 180˚,
temperature range
common in knob
turn the handle both
re-install
models) is installed
clockwise and
upside down
counterclockwise
Temperature limit
Remove handle and
Position temperature limit
stop out of position
see Step 5.3
stop to desired temperature
position
Not able to install
Valve installed too far
Handle does not install
Contact Moen for assistance.
handle/handle
back from finished
rubs up against
wall
escutcheon
Handle is hard
Cartridge stem is
Difficult movement from
Replace cartridge
to turn
difficult to rotate
handle
or lubricate
For further assistance, contact Moen at:
USA: 1-800-289-6636 or visit www.moen.com
Canada: 1-800-465-6130 or visit www.moen.ca
6. Post Installation - Troubleshooting Guide
Problem
Possible
To Diagnose
Remedy
Cause
E
n
g
li
sh
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Table of Contents Tub/Shower Parts Supplied ................................................................................................E3 Shower Only Parts Supplied ..............................................................................................E3 Rough-in Plumbing Variations Copp...
E n g li sh E4 Pipe Joint Com pound Wire Brush Phillips Screwdriver Tube Cutter Crescent Wrench Measuring Tape Safety Glasses Thermometer Thread Seal Tape Lead-free Solder Kit Torch Pipe Joint Compound Flashlight Key Hole Saw Helpful Tools For safety and ease of faucet replacement, Moen recommends t...
E n g li sh E6 Tub/Shower Position the valve body 32 inches from the floor of thetub basin. The shower arm should be placed 78 inchesabove the floor of the tub basin (recommended installa-tion of the shower arm is with a flanged elbow fitting – not included – and attached to a wood brace). The tub s...
