Moen 8963 - Manual
Moen 8963 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Reassembly
- Page 3 – Lavatory Lift Rod and Waste Assembly; AUCET
- Page 4 – Consumer Information
MODELS 4934 & 8983
TWO-HANDLE WIDESPREAD
LAVATORY FAUCET
INSTALLATION INSTRUCTIONS
THESE INSTRUCTIONS MUST BE
LEFT WITH HOMEOWNER
®
MT143B
Before turning water on during either rough-in or trim-out, make sure that the cartridge retainer nuts are in place. The cartridges
and retainer nuts were properly installed and tested before leaving the factory. Although it is unlikely, it is nevertheless possible
that through the handling of the valve by any number of persons the cartridge retainer nuts may not be properly installed. This
should be carefully checked at time of rough-in and trim-out. If the retainer nuts are not properly installed, water pressure could
force the cartridge out of the casting. Personal injury or water damage to the premises could result.
Always turn water off before disassembling the valve. Open valve handle to releive water pres-
sure and to insure that complete water shut-off has been accomplished.
CAUTION:
FLOW RATOR
AERATOR
SPOUT
HANDLE
KNOB
VALVE
BODY
DECK
4" - 16" CENTERS
SPOUT
UNION TEE
MOUNTING
NUT
TAILPIECE
NUT
WATER
SUPPLY LINES
(NOT FURNISHED)
COLD
HOT
1/2" NPT
THREADED
CONNECTIONS
SPOUT
MOUNTING
WASHER
SPOUT
MOUNTING
NUT
MOUNTING
WASHER
4-5/16"
5-1/8"
1-1/4" MAX.
DECK
THICKNESS
WASHER
MOUNTING
NUT
* SPOUT TUBE
(See note 5, Waste
Assembly Installation)
SPOUT INSTALLS THROUGH 1" MINIMUM DIAMETER HOLE.
VALVE INSTALLS THROUGH 1-1/8" MINIMUM DIAMETER HOLE.
Complies with ASME A112.18.1M and CSA B125
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Disassembly Installation Instructions FOR LOCATINGCARTRIDGE PROPERLY STEM KEY NOTCH IN BODY KNOB INSERT HANDLE SCREW HANDLE KNOB CARTRIDGE NUT STEM GUIDE STEM EXTENSION CARTRIDGE ESCUTCHEON * SPOUT TUBE(SEE NOTE 5, WASTE ASSEMBLYINSTALLATION) SPOUTSHANK MOUNTING WASHER MOUNTING NUT MT143B Fill the r...
Lavatory Lift Rod and Waste Assembly 1. Thoroughly clean around drain opening in lavatory sink. Apply 1/4 inch bead of plumber's putty (not furnished) around the bot-tom side of seat. 2. Apply pipe joint compound or Teflon tape (not furnished) to top threaded end of the drain body. Slip drain body u...
Moen Incorporated 25300 Al Moen Drive, North Olmsted, OH 44070-8022, U.S.A. In Canada: Moen Inc. 2816 Bristol Circle, Oakville, Ontario L6H5S7 MT143B SEP 95 © Copyright 1995 Moen Incorporated Printed in U.S.A. ® HELPLINE: For answers to any product, installation, replacment parts or warranty quest...
