Moen 12242 - Manual
Moen 12242 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – CAUTION; Stop Operation; MAKE SURE ALL WATER SUPPLIES ARE OFF.; Flushing
- Page 3 – Disassembly
- Page 4 – Trim; MAKE SURE ALL WATER SUPPLIES ARE OFF; TO REMOVE STOP VALVE; Removal of stop valve:; Not for use with Moentrol valves.; HELPLINE: Call our toll free Helpline number,; Reversed Rough-In Where Hot and Cold Positions Are Reversed:
MT692C
INSTALLATION INSTRUCTIONS
THESE INSTRUCTIONS MUST BE
LEFT WITH HOMEOWNER
T187, T188, T189, T190, T191, T628, 2320, 2325, 2339, 2370, 2375, 2389 Series
Models 12189, 12242, 12341, 12342, 62300, TL181, TL182, TL183, TL191
Measurements
These are shown in the drawings.
The depth measurement is critical. Use the front face of the plaster ground as a reference point for the finished wall
position, including tile ( 1-3/4"[44mm] )
. The supply piping centerline should be a maxium of 2" (51mm) and a minimum of 1" (25mm) behind the wall surface.
Use thick wall handle extension kit 96945 for wall thickness 13/16" to 1-13/16". Use handle kit 96955 for wall thickness 1-13/16" to 2-13/16".
Available with and without stops.
Connections are either 1/2 inch I.P.S. pipe or 1/2 inch copper sweat connections.
If the Moen Slip Fit spout is used, a 1/2 inch copper drop and lookout may be used.
POSI-TEMP
TUB AND SHOWER VALVES
Always turn water off before disassembling the valve. Open valve handle to relieve water
pressure and to insure that complete water shut-off has been accomplished.
Before turning water on during either rough-in or trim-out, make sure that cartridge retainer clip is in place.
The cartridge and retainer clip were properly installed and tested before leaving the factory. Although it is unlikely, it is never-
theless possible that through the handling of the valve by any number of persons the retainer clip may not be properly installed.
This should be carefully checked at time of rough-in and trim-out. If the retainer clip is not properly installed, water pressure
could force the cartridge out of the casting. Personal injury or water damage to the premises could result.
RETAINER
CLIP
CAUTION:
Visit Moen's Web Site at www.moen.com
WALL LINE
FACE OF STUD
1-3/4" (44mm)
2-5/16" (59mm) MAX (IPS)
2-3/16" (56mm) MAX (CC)
ESCUTCHEON
SHOWER 45" (1143mm) to 48" (1219mm)
32" (813mm) FOR TUB/SHOWER
COMBINATIONS AND TUB
MODELS ONLY
PLASTER GROUND
KEY STOP
TEMPERATURE
LIMIT STOP
KNOB
HANDLE
KNOB
SCREW
CAP
SCREW
HANDLE
SCREW
HANDLE
ADAPTER
HANDLE
SCREW
KNOB CAP
PLUG
BUTTON
LEVER
HANDLE
FINISHED WALL
SURFACE
STOP
TUBE
WASHER
HANDLE ASSEMBLIES
6'6"
(1981mm)
FLOOR
TUB SPOUT
IMPORTANT: SEE FLUSHING INSTRUC-
TIONS PAGE 2
A
B
C
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
MT692C WITHOUT STOPS WITH STOPS 7" 7" SHOWER SHOWER SUPPLY TUB TUB SUPPLY SUPPLY 2-3/4" C.C. & I.P.S. 2-5/16" C.C. & I.P.S. 4-13/16" C.C. 4-5/16" NOMINAL 4-1/2" PLASTER GROUND SIZE AND WALL OPENING C.C. I.P.S. CLAMPSCREW CAUTION This valve is equipped with the Moe...
RETAINER CLIP CARTRIDGE NOTCH WASHER STOP TUBE KEY STOP TEMPERATURE LIMIT STOP KNOB HANDLE HANDLE ADAPTER CAP SCREW HANDLE SCREW HANDLE SCREW KNOB INSERT PLUG BUTTON HOT INLETFORWARD COLD INLET TO REAR INSTALL WITH CARTRIDGE STEM NOTCH DOWN TOP VIEW CAUTION: CARTRIDGE MUST BE INSTALLED WITH HOT &...
MT692C NOV. 02 Trim MAKE SURE ALL WATER SUPPLIES ARE OFF TO INSTALL TRIM AFTER ROUGH-IN Slide the flange onto the long end of the shower arm. Wrap both ends of shower arm withthread seal tape and screw long end of shower arm into pipe ell inside the wall. Do not installthe showerhead. Install tub sp...
