Mitsubishi MCCH1- Installation Manual
Mitsubishi MCCH1– Installation Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Wireless System Installation Guide; Install batteries in wireless devices; Remote Controller; lithium; Push the excess cable back through the indoor
- Page 3 – Link all devices to wireless network; CONNECT; Link remote controller to wireless network; NEXT
- Page 4 – Link Portable Central Controller to RedLINKTM network (optional); WIRELESS SETUP
- Page 5 – Exit wireless setup; Customize remote controller (installer setup)
- Page 6 – Installer setup tables; Setup function
- Page 9 – Follow the procedure below to test for proper operation.; System test; Commercial Override; to temporarily activate an occupied temperature. Each press of; Optimal Start
- Page 10 – Mount remote controller & outdoor sensor; Place sensor securely; RedLINKTM error codes
- Page 11 – Replacing system components; follow the procedures on page 4 to link it to the wireless network.; Wireless receiver; At the remote controller:; FAN; At the Portable Central Controller:; REMOVE
- Page 12 – Regulatory information; Specifications & replacement parts; Operating Ambient Temperature; Operating Relative Humidity; Physical Dimensions; Accessories & Replacement Parts
© 2010 Mitsubishi Electric & Electronics USA, Inc.
Suwanee, GA 30024 All Rights Reserved.
The three diamond logo is a registered trademark
of Mitsubishi Electric Corporation
www.mitsubishipro.com
Controller Kit Installation Manual
MIFH1, MRCH1, MCCH1, MOS1
69-2426-01
Installation guide for:
• Wireless Receiver and Cable (MIFH1)
• Remote Controller (MRCH1)
• Portable Central Controller (MCCH1)
• Outdoor Air Sensor (MOS1)
DISCONNECT POWER
BEFORE BEGINNING INSTALLATION
.
Can cause
electrical shock or equipment damage.
Must be installed by a trained, experienced technician
.
Read these
instructions carefully. Failure to follow these instructions can damage the product or
cause a hazardous condition.
Installation at a glance
This document covers linking and
installation procedures for the
Mitsubishi Split-Zoning Ductless
and Ducted Systems' RedLINK™
control devices and accessories.
Before you begin, you must attach the cable to the CN105 connector on the indoor unit
control board, then follow the steps in this document.
Remote controllers are linked to specific indoor units. Each indoor unit must have a
dedicated remote controller and wireless receiver.
Wireless receiver
Wireless
outdoor
air sensor
Portable
central
controller
M32309
Remote controller
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Wireless System Installation Guide 69-2426—01 2 M28474 1 Install batteries in wireless devices Install batteries in all devices. Make sure batteries are inserted properly (see polarity marks on the devices). 2 Install cable and receiver M28472A Remote Controller Portable Central Controller (optional...
3 69-2426—01 3 Link all devices to wireless network 1 Remove cover from wireless receiver. 2 Verify POWER light is solid green. 3 Press and release the CONNECT button. 4 If CONNECT light does not flash, another receiver or RedLINK wireless adapter may be in wireless setup mode. Exit wireless setup a...
Wireless System Installation Guide 69-2426—01 4 Link Portable Central Controller to RedLINK™ network (optional) Link outdoor sensor to RedLINK™ network (optional) CONNECT WIRELESS SETUP M28481 M28483 NO YES CONNECT MORE? M28482 1 Make sure the CONNECT light on the wireless receiver is flashing. 2 Pr...
