Mitsubishi Electric XD520U-G - Manual
Mitsubishi Electric XD520U-G – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – ) Operation commands; How to set the value
- Page 3 – ) Password lock commands; digit password comprised of any figures 1 to 4 at the end.
- Page 5 – 日本語
1
1) Interface
Controlling the projector using a personal computer
This projector can be controlled by connecting a personal computer with RS-232C terminal.
PC-controllable functions :
•
Turning the power ON or OFF
•
Changing input signals
•
Inputting commands by pressing the buttons on the control panel and remote control
•
Menu setting
Connection
Important:
•
Make sure that your computer and projector are turned off before connection.
•
Boot up the computer first, and then plug the power cord of the projector.
(If you do not follow this instruction, the Comport may not function.)
•
Adapters may be necessary depending on the PC connected to this projector. Contact your dealer for details.
PROTOCOL
RS-232C
BAUD RATE
9600 [bps]
DATA LENGTH
8 [bits]
PARITY BIT
NONE
STOP BIT
1 [bit]
FLOW CONTROL
NONE
This projector uses RXD, TXD and GND lines for RS-232C control.
For RS-232C cable, the reverse type cable should be used.
2) Control command diagram
The command consists of the address code, function code, data code, and end code. The length of the command
varies among the functions.
Address code
Function code
Data code
End code
HEX
30h 30h
Function
Data
0Dh
ASCII
'0' '0'
Function
Data
[Address code] 30h 30h (In ASCII code, '0' '0') fixed.
[Function code] A code of each fixed control move.
[Data code]
A code of each fixed control data (number) and not always indicated.
[End code]
0Dh (In ASCII code, '
') fixed.
DLP Projector
XD500U/XD500U-G/XD500U-ST/XD510U/SD510U/XD510U-G
XD520U/XD520U-G/EX51U/EX52U
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 3) Control sequence (1) Send the command from the personal computer to the projector.(2) The projector will send a return command after it receives an end code. If the command is not received cor- rectly, the projector will not send the return command. (3) The personal computer checks the command ...
3 6) Keystone commands (Not executable in stand-by mode. Possible only to read during muting.) The keystone commands are used for the keystone setting of this projector with the value. The value will varydepending on the installation conditions, etc.) ITEM ASCII HEX VALUE KEYSTONE(vertical) KS 4Bh 5...
5 How to set the value Use the ASCII or HEX code as shown below to set the value. ASCII '+' '–' '0' '1' '2' '3' '4' '5' '6' '7' '8' '9' HEX 2Bh 2Dh 30h 31h 32h 33h 34h 35h 36h 37h 38h 39h ITEM ASCII HEX VALUE WALL SCREEN WS 57h 53h 0 (OFF), 1 (BEIGE), 2 (LIGHT BLUE), 3 (LIGHT GREEN),4 (PINK), 5 (BLA...
