Mitsubishi Electric SRK71ZR-S - Manual

– 6 – Name of each part and its function Air outlet Air inlet (On side & rear surface) Outdoor unit fan Heat exchanger Air inlet panel Indoor unit fan Air fi lter Removes dust or dirt from the inlet air. Wireless remote control Drain hose Drains water from the indoor unit. * The appearance varie...

– 7 – Unit display section Name of each part and its function • Buzzer sound for remote control When preset temperature 24°C, automatic operation and automatic airfl ow are selected, the buzzer sound (PiPi) is produced.When turning off the air-conditioner by pressing ON/OFF button (except CLEAN mode...

– 8 – Remote control handling Replacing the batteries The following cases show exhausted batteries. Replace old batteries with new ones. • Receiving beep is not emitted when a signal is transmitted. • Display fades away. NOTE • Do not use old and new batteries together. • Remove the batteries when t...

– 9 – Installing two air-conditioners in the same room ■ When two air-conditioners are installed in the same room, use this setting when the two air-conditioners are not operated with one remote control. Set the remote control and indoor unit. P u l l o u t t h e c o v e r a n d t a k e o u t batter...

– 10 – Air fl ow range setting ■ Take the air-conditioner location into account and adjust the left/right airfl ow range to maximize air-conditioning. 1 If the air-conditioner is running, press the ON/OFF button to stop. The airfl ow range setting cannot be made while the unit is running. (Center In...

– 11 – OPERATION MODE select button Each time the button is pressed, the mode changes. • The above illustration shows all controls, but in practice only the relevant parts are shown. ALLERGEN CLEAR button This button selects ALLERGEN CLEAR operation. ON/OFF (luminous) button Press to star t operatio...

– 12 – AUTO mode operation ■ Automatically selects the operation mode (COOL, HEAT, DRY) depending on the room temperature when switched on. • If you do not want the AUTO mode program, change to COOL, HEAT, DRY or FAN instead of AUTO. Page 14 • Air fl ow direction adjustment procedure. Page 15 AUTO m...

– 13 – Temperature adjustment during AUTO ■ Air temperature adjustment is possible even during automatic operation. There are 6 levels of adjustment possible with the button or the button.During automatic operation, 24°C is preset both for heating and cooling. 1 Press the“ or (TEMP)” button. ■ Each ...

– 14 – COOL/HEAT/DRY/FAN mode operation Airfl ow direction adjustment procedure. Page 15 Press the MODE button. Set to a required mode. (Cool), (Heat), (Dry), (Fan) Press the ON/OFF button. Press the TEMP button. Press or button for the preferred temperature. Recommendation 4 3 To stop: Press the ON...

– 15 – Air fl ow direction adjustment ■ Up/down direction can be adjusted with the AIRFLOW U/D (UP/DOWN) button on the remote control. Every time you press this button the mode changes as follows: Change on AIRFLOW (UP/DOWN) mode. ■ Left/right direction can be adjusted with the AIRFLOW L/R (LEFT/RIG...

– 16 – ■ If it is pressed while the unit is off SLEEP TIMER operation star ts with the previous operation settings, and the air-conditioner is turned off after the set time lapses. ■ If it is pressed while the unit is running The air-conditioner is turned off after the set time lapses. Every time th...

– 18 – ALLERGEN CLEAR operation Press the ALLERGEN CLEAR button. 1 ■ The power of enzymes is used to eliminate allergy-causing allergens that accumulate on the allergen clear fi lter. To stop: Press the ON/OFF orALLERGEN CLEAR button. • Since the room temperature may change quite a bit, it is recomm...

– 19 – WEEKLY TIMER operation ■ Up to 4 programs with timer operation (ON-TIMER / OFF-TIMER) are available for each day of the week. Max 28 programs per week are available. Once this has been set, the timer operation will be repeated at the same programs every week unless the WEEKLY TIMER is cancele...

– 23 – Press the ON/OFF button. Press the HI/ECO button. • When the operating mode is AUTO, COOL or HEAT Every time the HI/ECO button is pressed, the display is switched in the order of: (HIGH POWER) (ECONOMY) No display (Normal operation) • When the operating mode is DRY or ON-TIMER + OFF-TIMER Eve...

– 25 – SELF CLEAN operation ■ CLEAN operation should be run after AUTO, COOL and DRY operation to remove the moisture from inside the indoor unit and control the growth of mold and bacteria. 1 In order to active CLEAN operation, press the CLEAN switch with the tip of a ballpoint pen. Every time the ...

– 26 – Turn off the power source. Remove the air fi lter Before maintenance During the operational season Maintenance Cleaning the air fi lter Do not use the following articles: • Hot water (40°C or more) It may deform or discolour the unit. • Petrol, paint thinner, benzine or cleanser, etc. They ma...

– 27 – At the end of the season At the beginning of the season Stop the unit and turn off the power source. The unit consumes approx. 4W even when the unit is not operating. Turning off the power source will help saving energy consumption and cost. Ensure that the earth wiring is not snapped nor dis...

– 28 – Proper installation Pay attention to operating noises! • When you install the unit, take care to choose a place that can comfortably stand the weight of the unit and does not increase the operating noise or vibration. If vibration is transmitted through the house, fi x the unit with the aid o...

– 29 – Notice Air fl ow is not blown out when starting the HEATING operation. RUN light blinks slowly (1.5 sec ON, 0.5 sec OFF) Air fl ow has stopped to prevent blowing out of cold air until the indoor heat exchanger has warmed up. (2 to 5 min.) (HOT KEEP program) Air fl ow is not blown out for 5 to...

– 30 – Contact your dealer ■ Turn off the power switch immediately and inform your dealer in any of the following situations: The cable becomes extremely hot.The covering of the cable is cracked. W h e n a b n o r m a l i t i e s o c c u r, t u r n o f f t h e p ow e r s o u rc e immediately and tur...

– 31 – Self diagnosis function ■ We are constantly trying to do better service to our customers by installing such judges that show abnormality of each function as follows RUN light TIMER light TIMER light ON 1-time fl ash 2-time fl ash 3-time fl ash 5-time fl ash 6-time fl ash 7-time fl ash 5-time ...

USER’S MANUAL AIR-CONDITIONER RLD012A002G SRK63ZR-SSRK71ZR-SSRK80ZR-S AIR-CONDITIONING & REFRIGERATION DIVISION 3-1, Asahi, Nishibiwajima-cho, Kiyosu, Aichi, 452-8561, Japanhttp://www.mhi.co.jp MITSUBISHI HEAVY INDUSTRIES AIR-CONDITIONING EUROPE, LTD. 7 Roundwood Avenue, Stockley Park, Uxbridge,...