Mitsubishi Electric PAC-YG60MCA - Manual
Mitsubishi Electric PAC-YG60MCA – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Safety Precautions; Warning; WARNING; Device Capabilities; Caution: Usage Restrictions
- Page 3 – • Confirm that the box contains the following parts.; Confirmation of Parts
- Page 4 – Example of System Configuration; the transmission line.; LAN
- Page 5 – Prepare the following parts to install this device.; Installation Method; ON
- Page 6 – Note: Two hooks are located on the upper section of the cover.
- Page 7 – Diagram Image (Installed within a Control Panel); Wiring Method
- Page 8 – Tightening torque for terminal screws: 1 N·m; * Only the M-NET circuitry of this device receives the power from the
- Page 9 – noise, using wires shorter than 10 m is recommended.
- Page 10 – Initial Setting Procedure
- Page 11 – Switch List
- Page 12 – Display Content
- Page 13 – Use the following procedure to confirm operation of the system.; Test Run
Mitsubishi Electric Air Conditioner Network System
PI controller
PAC-YG60MCA
Installation/Instruction Manual
Before using the PI controller, please read this installation/instruction manual carefully to ensure proper operation.
Keep this installation/instruction manual for future reference.
Contents
Page
1.
Safety Precautions .............................................. 1
2.
Device Capabilities ............................................. 1
3.
Confirmation of Parts .......................................... 2
4.
Specifications ...................................................... 2
4-1.
Product Specifications ....................... 2
4-2.
External View ..................................... 2
5.
Example of System Configuration ....................... 3
6.
Installation Method .............................................. 4
6-1.
Parts to be Procured Locally .............. 4
6-2.
Installation Procedure ........................ 5
7.
Wiring Method ..................................................... 6
7-1.
Names of Parts .................................. 6
7-2.
Connecting the Power Line and
M-NET Transmission Line ................. 7
7-3.
Connecting the Signal Lines .............. 8
(1) Pulse input (non-voltage a contact) ... 8
8.
Initial Setting Procedure ...................................... 9
9.
Switch List ......................................................... 10
10.
Display Content................................................. 11
10-1.
Display Content List ......................... 11
10-2.
Communication Error Status
Display ............................................. 11
11.
Test Run ........................................................... 12
12.
Precautions for Expansion ................................ 12
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
1 • Before using the device, thoroughly read the following safety precautions and use as directed. • Hazards and levels of danger that can occur due to incorrect handling are classified by the following symbols. • After reading this manual, keep this manual for future reference. When the device is r...
2 • Confirm that the box contains the following parts. * In addition to the parts mentioned above, other parts need to be procured locally in order to operate this device. Furthermore, other Mitsubishi optional parts may be required depending on how the device is to be used. For details, refer to &#...
3 5 Example of System Configuration Note: • For the shield ground of the M-NET centralized control line for central control, use single-point grounding at the power unit for the transmission line. However, when supplying electric power to the M-NET centralized control line from the R410A series outd...
