Mitsubishi Electric HC5000 - Manual
Mitsubishi Electric HC5000 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – ) Operation commands
- Page 4 – ) Menu setting commands
- Page 5 – How to set the value; ) Setting range differs depending on the input signals.
1
Address code
Function code
Data code
End code
HEX
30h 30h
Function
Data
0Dh
ASCII
'0' '0'
Function
Data
1) Interface
Controlling the projector using a personal computer
This projector can be controlled by connecting a personal computer with RS-232C terminal.
PC-controllable functions:
• Turning the power ON or OFF
• Changing input signals
• Inputting commands by pressing the buttons on the control panel and remote control
• Menu setting
Connection
RS-232C cable
SERIAL
D-SUB 9-pin
D-SUB 9-pin
To RS-232C
terminal
Important:
• Make sure that your computer and projector are turned off before connection.
• Boot up the computer first, and then plug the power cord of the projector.
(If you do not follow this instruction, the Com port may not function.)
• Adapters may be necessary depending on the PC connected to this projector. Contact your dealer for details.
PROTOCOL
RS-232C
BAUD RATE
9600 [bps]
DATA LENGTH
8 [bits]
PARITY BIT
NONE
STOP BIT
1 [bit]
FLOW CONTROL
NONE
This projector uses RXD, TXD and GND lines for RS-232C control.
For RS-232C cable,the reverse type cable should be used.
2) Control command diagram
The command consists of the address code, function code, data code, and end code. The length of the command
varies among the functions.
[Address code]
30h 30h (In ASCII code, '0' '0') fixed.
[Function code]
A code of each fixed control move.
[Data code]
A code of each fixed control data (number) and not always indicated.
[End code]
0Dh (In ASCII code, '
') fixed.
LCD Projector
HC5000
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 3) Control sequence (1) Send the command from the personal computer to the projector.(2) The projector will send a return command after it receives an end code. If the command is not received correctly, the projector will not send the return command. (3) The personal computer checks the command an...
4 ITEM ASCII HEX VALUE GAMMA MODE GS 47h 53h 0 (SPORTS), 1 (VIDEO), 2 (CINEMA), 3 (USER1), 4 (USER2), 5 (AUTO) GAMMA MODE-USER1 GSU1 47h 53h 55h 31h R , G , B , +0 (SPORTS), +1 (VIDEO), +2 (CINEMA), ±10 ±10 ±10 (HIGH, MID, LOW) GAMMA MODE-USER2 GSU2 47h 53h 55h 32h R , G , B , +0 (SPORTS), +1 (VIDEO...
5 [Example 1] When setting the AUTO POWER ON to ON. (Figures and symbols enclosed in quotationmarks are ASCII codes.): Sending commands Status code from Description from the PC, etc. the projector 30 30 50 2B 31 30 2B 30 30 2D 30 35 0D Command for setting the '0' '0' 'P' '+' '1' '0' '+' '0' '0' '-' ...
