Mitsubishi Electric DV156 - Manual

6 4 4 Hardware Installation Your monitor is equipped with an automatic power supply with a voltagerange from 90 to 264 Volts AC at a frequency of 50 to 60 Hz. Make sure thatyour local power supply is within the supported range. If you are unsure,please contact your electricity supplier. To install y...

7 Audio Cable Installation 1. Remove the rear cover and then take the base cover off. 2. Connect the stereo audio cable from the Audio output of yoursound card to the Audio Input of the monitor. 3. Replace the base cover and the rear cover.

10 6 6 Setting the DisplayResolution Choosing The Best Resolution All Liquid Crystal Displays (LCDs) have a fixed resolution that is the same asthe maximum resolution that may be displayed on the LCD. In the case ofthe DV156 the LCD resolution is 1024 x 768 pixels. This is also known asthe native re...

11 Supported Graphics Modes and Refresh Rate Selection There is no need to choose the highest possible refresh rate when using anLCD monitor. It is not technically possible for an LCD monitor to flicker. Evenat a refresh rate of 60 Hz you will get an absolutely flicker-free image. For best results, ...

13 7 7 Adjusting the Monitor Picture Optimisation The easiest way to obtain an optimal picture is by using the AUTO button. This only works reliably if the graphics adaptor is set to use one of themonitor’s factory modes (see Table 1 in the previous chapter) and if you are displaying an appropriate ...

19 1 1 0 0 Specifications Model Diamond View DV156 Display Characteristics Display Type 15“ active matrix Thin FilmTransistor Liquid Crystal Display Viewable Diagonal Area 38.1 cm / 15” Native (Maximum) Resolution 1,024 x 768 pixels Colours 16.7 million Contrast Ratio 400:1 (typical) Brightness 250 ...

20 Input Signal Line Frequency 31.5 - 60.2 kHz multi-frequency Image Frequency (Refresh Rate) 56.3 - 75.0 HzWithin the parameters detailed inchapter 6 Video Signal RGB analog (Positive polarity)0.7 Vpp/75 Ohm Synchronisation TTL separate, composite TTL Signal Connection 15-pin mini D-sub cable Physi...

21 1 1 1 1 Service Contacts If problems remain after checking this manual, please contact your place ofpurchase or contact: Australia Visit the Customer Support section of Mitsubishi Electric Australia’s web siteat www.mitsubishi-electric.com.au for details of your nearest Mitsubishi Electric Author...

22 Victoria and Tasmania 4 / 303 Burwood HwyEast Burwood, Vic, 3151 Telephone: (03) 9262-9899 Fax: (03) 9262-9850 Western Australia 5 / 329 Collier RoadBassendean, WA, 6054 Telephone: (08) 9377-3411 Fax: (08) 9377-3499 New Zealand Contact: Melco New Zealand Ltd.1 Parliament St.Lower HuttWellington T...