Miele KM5951 - Manual

Timer control and display a Sensor switch for activating the timer, switching between functions andselecting automatic switch-off for a cooking zone b Sensor switches for setting the time c Time display d Indicator lamp for automatic switch-off, e.g. of the rear right cooking zone e Control lamp for...

Cooking zones Cooking zone KM 5941 / KM 5951 / KM 5952 / KM 5953 Minimum to maximum C in cm* Rating in watts for 230 V** y 16 - 23 normal:with Single Booster I:with Twin Booster II: 230030003700 w 10 - 16 normal:with Booster: 14001800 x 14 - 20 normal:with Booster: 18502900 z 14 - 20 normal:with Boo...

Cooking zone KM 5958 Minimum to maximum C in cm* Rating in watts for 230 V** f 18 - 28 normal:with Single Booster I:with Twin Booster II: 240030003700 x 10 - 16 normal:with Booster: 14001800 z 14 - 20 / 20 x 30 normal:with Single/Twin Booster I/II:normal:with Single Booster I:with Twin Booster II: 1...

This appliance complies with allrelevant local and national safetyrequirements. Improper use of theappliance can, however, present arisk of both personal injury andmaterial damage. To avoid the risk of accidents anddamage to the appliance, pleaseread these instructions carefullybefore installation a...

Safety with children ~ Use the safety lock to prevent children operating the appliance oraltering the settings. ~ Keep children away from the appliance at all times. It is not a toy! Toavoid the risk of injury, do not allowthem to play with it or use the controls.They will not understand the potenti...

Technical safety ~ Before installation, check the appliance for visible signs of damage.Do not install and use a damagedappliance. A damaged appliance isdangerous. ~ The electrical safety of this appliance can only be guaranteedwhen continuity is complete between itand an effective earthing system w...

~ While the appliance is under guarantee, repairs should only beundertaken by a service technicianauthorised by the manufacturer.Otherwise the guarantee is invalidated. ~ Faulty components must only be replaced by genuine Miele originalspare parts. The manufacturer can onlyguarantee the safety of th...

Disposal of the packingmaterial The transport and protective packinghas been selected from materials whichare environmentally friendly fordisposal, and can normally berecycled. Ensure that any plastic wrappings,bags, etc. are disposed of safely andkept out of the reach of babies andyoung children. D...

Please stick the extra data plate for theappliance supplied with thisdocumentation in the space provided inthe "After sales service, data plate"section of this booklet. Cleaning for the first time Remove any protective wrapping andadhesive labels. Before using for the first time, clean theap...

The induction principle An induction coil is located under eachcooking zone. When a cooking zone isswitched on, this coil creates amagnetic field which impacts directlyon the base of the pan and heats it up.The cooking zone itself is heated upindirectly by the heat given off by thepan. An induction ...

Noises When using an induction cooking zone,the following noises can occur in thepan, depending on what it is made ofand how it has been constructed. – On the higher power settings, it might buzz. This will decrease orcease altogether when the powersetting is reduced. – If the pan base is made of la...

Pans Suitable pans include: – stainless steel pans with a magnetic base – enamelled steel pans – cast iron pans Unsuitable pans: – stainless steel pans without a magnetic base – aluminium and copper pans – glass, ceramic or earthenware pots and pans To test whether a pot or pan is suitablefor use on...

Sensor switches This hob is equipped with electronicsensor switches which react to fingercontact.To operate a cooking zone, touch therelevant sensor. Each time you touch asensor switch, an audible tone sounds. Take care only to touch the middleof the sensor required. Keep thecontrol panel clean, and...

Settings Settings* Standard factory settings (9 settings) Extended settings** (17 settings) Keeping warm h h Melting butterDissolving gelatine 1 - 2 1 - 2. Warming small quantities of liquidCooking riceDefrosting frozen vegetables 3 3 - 3. Warming liquid and semi-solid foodsThickening sauces, e.g. H...

Booster function The cooking zones are equipped withSingle (l) or Twin Boosters (I/II) (see"Guide to the appliance"). When activated, the power is boostedso that large quantities can be heatedquickly, e.g. boiling water for cookingpasta. When Booster l is activated, thecooking zones will ope...

To activate Booster l ^ If necessary, switch on the requiredcooking zone. ^ Touch the B sensor for the relevant cooking zone. I will show in the cooking zone display, and the indicator lamp for the Boosterfunction will also light up. To activate Booster II ^ If necessary, switch on the requiredcooki...

Keeping warm Each cooking zone has a keepingwarm function. If the keeping warm function has beenactivated, the cooking zone will switchoff automatically after a maximum of 2hours. This function is for keeping food thathas just been cooked warm, i.e.food that is still hot. It is not forreheating food...

The timer can be used for two differentfunctions: – To set the minute minder – To set a cooking zone to switch off automatically. You can select a time from 1 minute( 01 ) to 9 1 / 2 hours ( 9.^ ). If a time of more than 99 minutes ( 99 ) is set, the time is set in half-hour steps. The half hour isi...

Safety lock/System lock Keep children away from the hob fortheir own safety. Your appliance is equipped with asafety lock to prevent the hob and thecooking zones being switched on orany settings being altered. The safety lock is activated when the hob is switched on. If the safety lock isactivated: ...

Stop and Go Your appliance has a Stop and Gofeature which, when activated, reducesthe power of all switched-on cookingzones to setting 1 . When Stop and Go is deactivated, the cooking zones resumeat the power level which was last set.If Stop and Go is not deactivated, thehob switches off after 1 hou...

Overheating protection All the induction coils and the coolingelements for the electronics are fittedwith an overheating protectionmechanism. To prevent the inductioncoils and cooling elements fromoverheating, the overheating protectionmechanism works on the affectedcooking zone or on the entire hob...

, Do not use a steam cleaning appliance to clean this appliance.The steam could reach the electricalcomponents and cause a shortcircuit. The appliance should be cleanedregularly, preferably after each use.Allow it cool down to room temperaturebefore cleaning.To avoid water marks and limescaledeposit...

Ceramic surface Wipe all coarse soiling off using adamp cloth. Stubborn soiling may needto be removed with a shielded scraperblade. Then clean the hob with a suitableproprietary ceramic and stainless steelhob cleaner (see "Optionalaccessories") applied with kitchenpaper or a clean cloth. Do ...

You can change the default settings ofthe programme options (see chart). ^ With the hob switched off, touch thehob ON/OFF sensor s and the safety lock sensor $ at the same time until the indicator lamp for the safety lockflashes. A P (Programme) and an S (Status) will appear in the cooking zone disp...

, Installation work and repairs to electrical appliances must only becarried out by a suitably qualifiedand competent person in strictaccordance with current local andnational safety regulations (BS 7671in the UK). Repairs and other workby unqualified persons could bedangerous. The manufacturercanno...

Miele appliances are designed to give the best possibleresults and years of satisfaction. To help you get the mostfrom your appliance, Miele has put together acomprehensive range of accessories and cleaning products. These can be ordered via the internet at: or from Miele (see back cover for contact...

Fit wall units and extractor hoodbefore fitting the hob to avoiddamaging the surface. ~ The veneer or laminate coatings of worktops (or adjacent kitchen units)must be treated with 100 °Cheat-resistant adhesive which will notdissolve or distort.Any backmoulds must be ofheat-resistant material. ~ This...

Safety distance above the appliance A minimum safety distance must bemaintained between the appliance andthe cooker hood above it. See thecooker hood manufacturer's operatingand installation instructions for details. If the manufacturer's instructions arenot available for the cooker hood, aminimum s...

Safety distance when installing the appliance near a wall with additionalniche cladding There must be a minimum distance of 50 mm between the niche cladding and theworktop cut-out.This distance is only necessary for niche cladding made of wood or any othercombustible material. For non-combustible ma...

Building-in dimensions KM 5941 a Front b Building-in depth c Building-in depth, including mains connection cable d Mains connection cable, L = 1440 mm Hob with frame or bevelled edge 58 600 8 514 614 500 1 + - 1 b d a a 50 R4 0 ß 0 30 b 44 44 c 205 250 53 + -

Installation Preparing the worktop ^ Make the worktop cut-out followingthe dimensions applicable.Remember to maintain a minimum safety distance from the back wall , as well as from any tall unit or side wall to the right or left of the hob. See "Safety instructions forinstallation". ^ Seal t...

General installation tips Do not use any sealant unlessexpressly instructed to do so. Thesealing strip under the edge of the toppart of the appliance provides asufficient seal for the worktop. Do not use sealant between theframe of the top part of theappliance and the worktop.This could cause diffic...

Making the worktop cut-out andbuilding in the hob Granite and marble worktops e Worktop f Hob g Gap Corner radius of the worktop ß R4 As the ceramic glass and theworktop cut-out have a certaindimensional tolerance, gap g can vary (min. 1 mm). ^ Make the worktop cut-out as shownin "Building-in di...

All electrical work should be carriedout by a suitably qualified andcompetent person, in strictaccordance with current local andnational safety regulations (BS 7671in the UK). Installation, repairs and other workby unqualified persons could bedangerous. The manufacturercannot be held liable forunaut...

WARNINGTHIS APPLIANCE MUST BEEARTHED The electrical safety of this appliancecan only be guaranteed whencontinuity is complete between it andan effective earthing system, whichcomplies with current local and nationalsafety regulations. It is most importantthat this basic safety requirement ispresent ...

In the event of any faults which you cannot remedy yourself, or if the appliance isunder guarantee, please contact: – Your Miele dealer, or – the Miele Service Department (see back cover for address). Please note that telephone calls may be monitored and recorded to improveour service. When contacti...