Miele KM5773 - Manual

Timer/Memory display r Indicator lamp for relevant zone, e.g. the rear right cooking zone s Display for Time/Memory programme 00 to 99 = Time P1 to P5 = Memory programme t Memory programme indicator lamp Cooking zones Cooking zone KM 5773 minimum to maximum C in cm* Rating in watts for 230 V** y 16 ...

To avoid the risk of accidents anddamage to the appliance, pleaseread these instructions carefullybefore using it for the first time. Theycontain important notes on itsinstallation, safety, use andmaintenance. The use of the appliance by theelderly or infirm or those who havenot used the appliance b...

Never open the casing of theappliance. Tampering with electrical connectionsor components is highly dangerous tothe user and can cause operationalfaults. On hobs with bevelled glass edgesa small gap may be visible between the hob and the worktopduring the first few days afterinstallation. This gap w...

Safety with children Use the safety lock to preventchildren operating the appliance or altering the settings. The appliance is only intended foruse by adults who have read these instructions. This appliance is not a toy! Toavoid the risk of injury, keep children well away, and do not allowthem to pl...

Appliance faults In the event of damage or a defect,switch off the appliance immedi- ately. Disconnect completely from theelectricity supply. If the appliance hasnot yet been fully installed, theelectricity cable must be disconnectedfrom the supply point. If connected viaa plug and socket, switch of...

Futher safety notes For people fitted with a heartpacemaker: Please note that the area immediatelysurrounding the hob iselectromagnetically charged, and thatthis could affect a pacemaker.If in any doubt, consult themanufacturer of the pacemaker or yourdoctor. Ensure pans are placed centrallyover the...

Disposal of the packingmaterial The transport and protective packinghas been selected from materials whichare environmentally friendly for disposaland can normally be recycled.Packaging, e.g. cling film, polystyreneand plastic wrappings, must be keptout of the reach of babies and youngchildren. Dang...

General notes Your appliance has a "programming"function which you can use tocustomise the appliance to yourparticular requirements (see"Programming"). Cleaning for the first time Before using for the first time, clean theappliance with a damp cloth only andthen wipe dry. Do not use ...

Calibrating the sensorswitches Automatic calibration To ensure trouble free operation, thesensors – need to be recalibrated after installation and each time theelectricity supply fails, e.g. after apower cut.The safety lock indicator lamp lightsup during automatic calibration, andthe hob cannot be s...

How it works An induction coil is located under eachcooking zone. When a cooking zone isswitched on, this coil creates amagnetic field which impacts directlyon the base of the pan and heats it up.The cooking zone itself is heated upindirectly by the heat given off by thepan. Induction cooking zones ...

Noises When using an induction cooking zone,the following noises can occur in thepan, depending on what it is made ofand how it has been constructed. – On the higher power settings, it might buzz. This will decrease orcease altogether when the powersetting is reduced. – If the pan base is made of la...

Pans Suitable pans include: – stainless steel pans with a magnetic base – enamelled steel pans – cast iron pans Unsuitable pans: – stainless steel pans without a magnetic base – aluminium and copper pans – glass, ceramic or earthenware pots and pans To test whether a pot or pan is suitablefor use on...

Sensor switches This hob is equipped with electronicsensor switches which react to fingercontact.To operate a cooking zone, touch therelevant sensor switch. Each time youtouch a sensor switch, an audible tonesounds. Take care only to touch the middle ofthe sensor required. Keep thecontrol panel clea...

Settings Cooking process Power levels* standard factory settings (12 levels) extendedsettings** (23 levels) Melting butterDissolving gelatine 1 - 2 1 - 2. Warming small quantities of food/liquidKeeping warm food which sticks easilyCooking riceDefrosting frozen vegetables 3 3 - 3. Warming liquid and ...

How to activate Auto heat-up ^ While a 0 is lit up in the cooking zone display, touch the - sensor until the required continued cooking powerlevel appears, e.g. 3 . The 12 curved lines show in the light-ring during the Auto heat-up time.After the Auto heat-up time hasfinished, only the number of cur...

Booster function All of the cooking zones are equippedwith a booster function, i. e. an increasein the power level.If activated, the zones will operate onpower level 12 with an extra boost of power for a period of 10 minutes. Thisbooster is intended for quickly bringinglarge quantities of water to t...

Introduction The hob is fitted with:- Minute minder (Timer function)- Automatic switch-off for the cooking zones (Timer function) - Memory function. These functions are described one by one on the following pages. The Combi mode is described in the section of thatname. You can set a time of 1 to 99 ...

Switching a cooking zone offautomatically You can set a time at the end of which agiven cooking zone will switch offautomatically. This automatic switch-offfunction can be used on all of thecooking zones at the same time. ^ Select a power level for the zone yourequire, e.g. back right, in the usualw...

Memory function The settings used on a particularcooking zone from switching on rightthrough to switching off can berecorded as a Memory programme. Upto 5 of your favourite cookingprocesses can be saved as Memoryprogrammes. However, only oneprogramme can be recorded or used atany one time.Memory pro...

Combi mode The minute minder, automatic switch-offand memory functions can all be usedat the same time. If you wish to use the minute minder at the same time as another function : Touch the m sensor until the indicator lamps for the programmed cookingzones light up constantly, and 00 appears in the ...

Safety lock Keep children away from the hob fortheir own safety. Your appliance is equipped with asafety lock to prevent the hob and thecooking zones being switched on orany settings being altered. The safety lock can be activated whenthe hob is switched off as well as whenit is in use. If the safet...

Stop and Go Your appliance has a Stop and Gofeature which, when activated, reducesthe power of all cooking zones thathave been switched on. This allows youto leave the hob unattended for a shorttime without any danger of pans boilingover or burning. To activate Stop and Go: ^ Touch the $ sensor unti...

Overheating protection All of the induction coils and the coolingelement for the electronics are fittedwith an overheating protectionmechanism. To prevent the inductioncoils and cooling element fromoverheating, the overheating protectionmechanism works on the affectedcooking zone or on the entire ho...

Do not use a steam cleaner to cleanthis appliance. The steam couldreach electrical components andcause a short circuit. Pressurisedsteam could also cause permanentdamage to the surface and tocomponents, for which themanufacturer cannot accept liability. Do not use any sharp objects whichcould damage...

Should any sugar, plastic or aluminium foil spill or fall on to a hot cooking zone while it is in use, firstswitch off the appliance. Then carefullyscrape off all the sugar, plastic oraluminium residues from the hob whilstthey are still hot, using a shieldedscraper blade. Take care not to burnyourse...

You can change the standard settingsof your hob (see chart). Proceed as follows: ^ With the hob switched off, touch thehob ON/OFF sensor s and the safety lock sensor $ at the same time until the indicator lamp for the safety lockflashes. A P (Programme) and an S (Status) will appear in the cooking z...

Installation work and repairs toelectrical appliances must only becarried out by a suitably qualifiedand competent person in strictaccordance with current local andnational safety regulations (BS 7671in the UK). Repairs and other workby unqualified persons could bedangerous. The manufacturercannot b...

In the event of any faults which you cannot remedy yourself, or if the appliance isunder guarantee, please contact: – Your Miele dealer, or – the Miele Service Department (see back cover for address). When contacting the Service Department, please quote the model and serialnumber of your appliance, ...

Safety instructions forinstallation Fit wall units and extractor hoodbefore fitting the hob to avoiddamaging the surface. The veneer or laminate coatings ofworktops (or adjacent kitchen units) must be treated with 100 °Cheat-resistant adhesive which will notdissolve or distort.Any backmoulds must be...

Safety distance above the hob A minimum safety distance must bemaintained between the hob and thecooker hood above it. See the cookerhood manufacturer's operating andinstallation instructions for details. If the manufacturer's instructions arenot available for the cooker hood, aminimum safety distan...

Safety distance when installing the appliance near a wall with additionalniche cladding There must be a minimum distance of 50 mm between the niche cladding and theworktop cut-out.This distance is only necessary for niche cladding made of wood or any othercombustible material. For non-combustible ma...

Installation above an oven a Ventilation gap for the fan when installed in a base unit withouta back panel. When installed above a Miele ovenin a worktop thickness 0 40 mm the minimum ventilation gap for the fanof 15 mm is present. If the worktop is ß 40 mm , a filler panel will have to be fitted ab...

Building-in dimensions a Front b Building-in depth c Building-in depth for mains connection cable d Mains connection cable, L = 1,400 mm Installation 48

Sealant Do not use any sealant unlessexpressly instructed to do so. Thesealing strip under the edge of the toppart of the hob provides a sufficientseal for the worktop. Do not use sealant between theframe of the top part of the hob andthe worktop.This could cause difficulties if thehob ever needs to...

Electrical connection All electrical work should be carriedout by a suitably qualified andcompetent person, in strictaccordance with current local andnational safety regulations (BS 7671in the UK). Installation, repairs and other workby unqualified persons could bedangerous. The manufacturercannot b...

Wiring diagram N.B. This appliance is supplied single phase only in the U.K. / AUS / NZ Installation 53