MicroLux 80463 - User Manual
MicroLux 80463 Table Saw – User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – OPERATING INSTRUCTIONS; #80463 MICROLUX TILTING ARBOR TABLE SAW; PRODUCT LIABILITY DISCLAIMER; T H E S M A L L T O O L S P E C I A L I S T S; NOTICE
- Page 3 – B. BLADE CHANGING INSTRUCTIONS; Always unplug saw before changing blades.
- Page 4 – Never change angle of blade with saw running.; F. SAW BLADES AND CUTTING SPEEDS; Refer to chart on page 4
- Page 5 – TEMPLATE FOR LOCATING & DRILLING MOUNTING HOLES
- Page 6 – Par ts List for #80463 MicroLux Tilting Arbor Table Saw
- Page 7 – Tilting Arbor Table Saw; Assembly Drawing
SPECIAL INSTRUCTIONS FOR #80463 MICROLUX TILT-ARBOR SAW
CAUTION!
PLEASE TAKE THE FOLLOWING STEPS
TO ASSURE YOUR SAFETY AND THE
PROPER OPERATION OF YOUR SAW.
Before operating your saw, you MUST check that it has not been damaged
during shipment from our warehouse to your location. You must also save
ALL the packing materials for your saw should you ever need to return it to
us for any reason.
To inspect your saw, first remove the cleanout/blade storage door on the
right side of the saw housing – turn the screw counterclockwise to unlock,
then remove the door. Look inside the saw housing and locate the corrugated
packing pieces. Carefully remove these pieces and
SAVE THEM
. While the
door is open, check for damage to any of the internal parts of the saw.
If everything checks OK, continue with the saw set-up as outlined in the
O P E R AT I N G I N S T R U C T I O N S s u p p l i e d w i t h y o u r s a w. I f d a m a g e i s
discovered, repack the saw and contact the Micro-Mark Customer Service
Department at 1-908-464-6764 for assistance.
The internal mechanism of this tool must be packed properly to best prevent
damage during shipment. If you need to return the tool to us for any reason,
please be sure to properly replace all packing materials prior to shipment.
We cannot assume responsibility for damage resulting from the improper
packing of merchandise being returned to us.
Carefully check the motor housing pivot system for damage. . .
in particular, check the molded holes surrounding the motor
housing pivot pin (item 21 on the Parts List).
340 Snyder Avenue, Berkeley Heights, NJ 07922 • Tech Support: 908-464-1094
www.micromark.com [email protected]
MM122904
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
OPERATING INSTRUCTIONS #80463 MICROLUX TILTING ARBOR TABLE SAW GENERAL SAFETY INSTRUCTIONS Table saws can be dangerous tools if not used properly. For your own safety and the safety of others, please read and understand operating instructions completely before using your new saw. 1. Always wear safe...
B. BLADE CHANGING INSTRUCTIONS Always unplug saw before changing blades. IMPORTANT NOTE: BLADE INSTALLED ON SAW IS FOR CUTTING WOOD ONLY. 1. For your safety, mount your saw in a location that does notrequire you or an observer to stand in line with the saw blade.Your saw must be securely mounted to ...
E. SAW OPERATION D. DUST COLLECTOR ATTACHMENT 1. CROSS CUTTING Cross cutting is a cut across the short dimensionof a piece of wood (usually across the grain).Remove rip fence and ALWAYS USE MITERGAUGE WHEN CROSS CUTTING. Adjust bladeheight so it is approximately 1/16" above thewood. Hold the woo...